- 您現在的位置：買賣IC網 > PDF目錄366551 > AM79C978AKCW (ADVANCED MICRO DEVICES INC) Single-Chip 1/10 Mbps PCI Home Networking Controller PDF資料下載
參數資料
| 型號： | AM79C978AKCW |
| 廠商： | ADVANCED MICRO DEVICES INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Single-Chip 1/10 Mbps PCI Home Networking Controller |
| 中文描述： | 5 CHANNEL(S), 10M bps, LOCAL AREA NETWORK CONTROLLER, PQFP160 |
| 封裝： | PLASTIC, QFP-160 |
| 文件頁數： | 83/256頁 |
| 文件大小： | 3505K |
| 代理商： | AM79C978AKCW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁當前第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁
Am79C978A
83
EEPROM Interface
The controller contains a built-in capability for reading
and writing to an external serial 93C46 EEPROM. This
built-in capability consists of an interface for direct con-
nection to a 93C46 compatible EEPROM, an automatic
EEPROM read feature, and a user-programmable reg-
ister that allows direct access to the interface pins.
Automatic EEPROM Read Operation
Shortly after the deassertion of the RST pin, the controller
will read the contents of the EEPROM that is attached to
the interface. Because of this automatic-read capability of
the controller, an EEPROM can be used to program many
of the features of the controller at power-up, allowing sys-
tem-dependent configuration information to be stored in
the hardware instead of inside the device driver.
If an EEPROM exists on the interface, the controller will
read the EEPROM contents at the end of the H_RESET
operation. The EEPROM contents will be serially shifted
into a temporary register and then sent to various register
locations on board the controller. Access to the
Am79C978A configuration space, the Expansion ROM,
or any I/O resource is not possible during the EEPROM
read operation. The controller will terminate any access
attempt with the assertion of DEVSEL and STOP while
TRDY is not asserted, signaling to the initiator to discon-
nect and retry the access at a later time.
A checksum verification is performed on the data that is
read from the EEPROM. If the checksum verification
passes, PVALID (BCR19, bit 15) will be set to 1. If the
checksum verification of the EEPROM data fails, PVALID
will be cleared to 0, and the controller will force all EE-
PROM-programmable BCR registers back to their
H_RESET default values. However, the content of the
Address PROM locations (offsets 0h - Fh from the I/O or
memory mapped I/O base address) will not be cleared.
The 8-bit checksum for the entire 82 bytes of the
EEPROM should be FFh.
If no EEPROM is present at the time of the automatic read
operation, the controller will recognize this condition,
abort the automatic read operation, and clear both the
PREAD and PVALID bits in BCR19. All EEPROM-pro-
grammable BCR registers will be assigned their default
values after H_RESET. The content of the Address
PROM locations (offsets 0h - Fh from the I/O or memory
mapped I/O base address) will be undefined.
EEPROM Auto-Detection
The controller uses the EESK/LED1 pin to determine if
an EEPROM is present in the system. At the rising edge
of CLK during the last clock during which RST is as-
serted, the controller will sample the value of the EESK/
LED1 pin. If the sampled value is a 1, then the controller
assumes that an EEPROM is present, and the EE-
PROM read operation begins shortly after the RST pin is
deasserted. If the sampled value of EESK/LED1 is a 0.
the controller assumes that an external pull-down device
is holding the EESK/LED1 pin low, indicating that there
is no EEPROM in the system. Note that if the designer
creates a system that contains an LED circuit on the
EESK/LED1 pin, but has no EEPROM present, then the
EEPROM auto-detection function will incorrectly con-
clude that an EEPROM is present in the system. How-
ever, this will not pose a problem for the controller, since
the checksum verification will fail.
Direct Access to the Interface
The user may directly access the port through the
EEPROM register, BCR19. This register contains bits
that can be used to control the interface pins. By per-
forming an appropriate sequence of accesses to
BCR19, the user can effectively write to and read from
the EEPROM. This feature may be used by a system
configuration utility to program hardware configuration
information into the EEPROM.
EEPROM-Programmable Registers
The following registers contain configuration informa-
tion that will be programmed automatically during the
EEPROM read operation:
I/O offsets 0h-Fh Address PROM locations
BCR2
Miscellaneous Configuration
BCR4
LED0 Status
BCR5
LED1 Status
BCR6
LED2 Status
BCR7
LED3 Status
BCR9
Full-Duplex Control
BCR18
Burst and Bus Control
BCR22
PCI Latency
BCR23
PCI Subsystem Vendor ID
BCR24
PCI Subsystem ID
BCR25
SRAM Size
BCR26
SRAM Boundary
BCR27
SRAM Interface Control
BCR32
PHY Control and Status
BCR33
PHY Address
BCR35
PCI Vendor ID
BCR36
PCI Power Management
Capabilities (PMC) Alias
Register
BCR37
PCI DATA Register 0 (DATA0)
Alias Register
BCR38
PCI DATA Register 1 (DATA1)
Alias Register
BCR39
PCI DATA Register 2 (DATA2)
Alias Register
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C978AVCW | Single-Chip 1/10 Mbps PCI Home Networking Controller |
| AM79C978 | Single-Chip 1/10 Mbps PCI Home Networking Controller |
| AM79C981 | Integrated Multiport Repeater Plus⑩ (IMR+⑩) |
| AM79C981JC | Integrated Multiport Repeater Plus⑩ (IMR+⑩) |
| AM79C982 | basic Integrated Multiport Repeater (bIMR) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C978AVCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Single-Chip 1/10 Mbps PCI Home Networking Controller |
| AM79C978KC/W | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Single-Chip 1/10 Mbps PCI Home Networking Controller |
| AM79C978VC/W | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Single-Chip 1/10 Mbps PCI Home Networking Controller |
| AM79C979BKC\\W | 制造商:Advanced Micro Devices 功能描述: |
| AM79C98 | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:Twisted-Pair Ethernet Transceiver (TPEX) |
發布緊急采購，3分鐘左右您將得到回復。