- 您現在的位置：買賣IC網 > PDF目錄385096 > AK61584 (Asahi Kasei Microsystems Co.,Ltd) Circular Connector; No. of Contacts:55; Series:MS27484; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:16; Circular Contact Gender:Socket; Circular Shell Style:Straight Plug; Insert Arrangement:16-35 RoHS Compliant: No PDF資料下載
參數資料
| 型號： | AK61584 |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 元件分類： | 圓形連接器 |
| 英文描述： | Circular Connector; No. of Contacts:55; Series:MS27484; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:16; Circular Contact Gender:Socket; Circular Shell Style:Straight Plug; Insert Arrangement:16-35 RoHS Compliant: No |
| 中文描述： | 雙低功耗的T1/E1線路接口 |
| 文件頁數： | 23/38頁 |
| 文件大?。?/td> | 364K |
| 代理商： | AK61584 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
ASAHI KASEI
[AK61584]
0185-E-00
98/04
-23-
HOST MODE REGISTER ACCESS
This mode is selected by setting pin MODE to
logic high, and pin 16 must be set to logic low. In the host
mode, the on-board registers can be written to via
the SDI pin or read from via the SDO pin at the clock
rate determined by SCLK. Through these registers, a
host controller can be used to control operational char-
acteristics and monitor device status. The serial port
read/write timing is independent of the system transmit
and receive timing.
Any read or write to the serial port is initiated by setting
Chip Select (CS) low and writing an 8-bit ad-
dress/command byte (ACB). The ACB consists
of the three separate fields including a 6-bit register
address (see Figure 14). The ACB is followed by a
data word.
In the ACB, D0(LSB) is the R/W field, and
specifies whether the current operation is to be a read or
a write: 1 = read, 0= write. The next 4 bits (D1-D4)
contain the address field. They specify which of the
registers to access. D5 and D6 are “don’t care bits”.
Setting bit D7 to 1 selects burst mode (described
below).
Registers h10 to h17 are read and written as described
above. Registers h18 and h19 are used to access mul-
tiple bytes for the arbitrary waveform generation, refer
to the AK61584 Application Note.
Another communication option, burst mode, is
available. Burst mode is specified by setting bit
D7(MSB) of the ACB to 1. Burst mode allows
multiple registers to be consecutively read or written.
Writing all registers allows fast initialization at
power-up or system reset. When using burst mode, the
address field of the ACB command word must be h00.
The registers are read or written in address order h10 to
h11, followed by 42 byte reads or writes to register
h18, followed by 42 bytes read or writes to register
h19. Burst mode ends on the first rising edge of CS,
and may be ended at any time. If a burst write ends
before writing 92 bytes, the remaining, unwritten
bytes are unchanged.
Figure 15 shows the timing relationships for data
transfers. When the SPOL pin is high, data on SDO is
valid on the falling edge of SCLK. When the SPOL
pin is low, data on SDO is valid on the rising edge
of SCLK.
All data is written to and read from the port LSB
first. When writing to the port, SDI input data is sam-
pled on the rising edge of SCLK.
SDO goes to high impedance state when not in use.
SDO and SDI may be tied together in applications
where the host processor has a bi-directional I/O
port.
CS
SCLK
SDI
SDO
R/W
0
0
0
0
0
0
1
Address/Command Byte
Data Input/Output
D2
D3
D0
D1
D2
D3
D4
D5
D6
D7
D0
D1
D4
D5
D6
D7
Figure 15. Serial Read/Write Timing
7
BM
individual
Burst
6
5
4
3
2
1
0
0
1
0
1
ADD5
ADD3
ADD4
ADD2
ADD1
ADD0
R/W
Write
Read
(MSB)
Register Address Field
(LSB)
(MSB)
(LSB)
Figure 14. Address Command Byte (ACB)
Don't care
相關PDF資料 |
PDF描述 |
|---|---|
| AK6416A | 16Kbit Serial CMOS EEPROM |
| AK6416AM | 16Kbit Serial CMOS EEPROM |
| AK6416C | 16Kbit Serial CMOS EEPROM |
| AK6416CH | 16Kbit Serial CMOS EEPROM |
| AK6416CM | 16Kbit Serial CMOS EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AK616-.5 | 功能描述:CABLE AUDIO CD-ROM 3-FOLD .5M RoHS:否 類別:電纜組件 >> 矩形 系列:- 標準包裝:1 系列:- 連接器類型:插頭至插頭 位置數:30 行數:2 間距 - 連接器:0.100"（2.54mm） 間距 - 線纜:0.050"（1.27mm） 長度:1.50'（457.20mm） 特點:電極標記 顏色:多色，帶狀 屏蔽:無屏蔽 使用:- 電纜端接:IDC 觸點表面涂層:金 觸點涂層厚度:30µin（0.76µm） |
| AK6161024D | 制造商:ACCUTEK 制造商全稱:ACCUTEK MICROCIRCUIT CORPORATION 功能描述:65,536 x 32 Bit CMOS/BiCMOS Static Random Access Memory |
| AK6161024G | 制造商:ACCUTEK 制造商全稱:ACCUTEK MICROCIRCUIT CORPORATION 功能描述:32,768 x 32 Bit CMOS/BiCMOS Static Random Access Memory |
| AK6161024S | 制造商:ACCUTEK 制造商全稱:ACCUTEK MICROCIRCUIT CORPORATION 功能描述:65,536 x 32 Bit CMOS/BiCMOS Static Random Access Memory |
| AK6161024W | 制造商:ACCUTEK 制造商全稱:ACCUTEK MICROCIRCUIT CORPORATION 功能描述:65,536 x 32 Bit CMOS/BiCMOS Static Random Access Memory |
發布緊急采購，3分鐘左右您將得到回復。