- 您現在的位置：買賣IC網 > PDF目錄1900 > ADUC832BSZ-REEL (Analog Devices Inc)IC MCU 62K FLASH ADC/DAC 52MQFP PDF資料下載
參數資料
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁當前第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
ADuC832
Data Sheet
Rev. B | Page 70 of 92
TIMERS/COUNTERS
The ADuC832 has three 16-bit timer/counters: Timer 0, Timer 1,
and Timer 2. The timer/counter hardware has been included on
chip to relieve the processor core of the overhead inherent in
implementing timer/counter functionality in software. Each
timer/counter consists of two 8-bit registers THx and TLx (x =
0, 1, and 2). All three can be configured to operate either as
timers or event counters.
In the timer function, the TLx register is incremented every
machine cycle. Thus, it can be thought of as counting machine
cycles. Because a machine cycle consists of 12 core clock
periods, the maximum count rate is 1/12 the core clock
frequency.
In a counter function, the TLx register is incremented by a 1-to-
0 transition at its corresponding external input pin, T0, T1, or
T2. In this function, the external input is sampled during S5P2
of every machine cycle. When the samples show a high in one
cycle and a low in the next cycle, the count is incremented. The
new count value appears in the register during S3P1 of the cycle
following the one in which the transition was detected. Because
two machine cycles (24 core clock periods) are needed to
recognize a 1-to-0 transition, the maximum count rate is 1/24
the core clock frequency. There are no restrictions on the duty
cycle of the external input signal, but to ensure that a given level
is sampled at least once before it changes, it must be held for a
minimum of one full machine cycle.
User configuration and control of all timer operating modes is
achieved via three SFRs: TMOD and TCON, which control and
configure Timer 0 and Timer 1, and T2CON, which controls and
configures Timer 2.
TMOD (Timer/Counter 0 and Timer/Counter 1 Mode
Register)
SFR Address:
89H
Power-On Default Value:
00H
Bit Addressable:
No
Table 36. TMOD SFR Bit Designations
Bit
Name
Description
[7]
Gate
Timer 1 gating control. Set by software to enable Timer/Counter 1 only while INT1 pin is high and TR1 control bit is set.
Cleared by software to enable Timer 1 whenever TR1 control bit is set.
[6]
C/T
Timer 1 timer or counter select bit. Set by software to select counter operation (input from T1 pin). Cleared by software to
select timer operation (input from internal system clock).
[5:4
M[1:0]
Timer 1 Mode Select Bit 1 and Bit 0.
M1
M0
Description
0
TH1 operates as an 8-bit timer/counter. TL1 serves as a 5-bit prescaler.
0
1
16-bit timer/counter. TH1 and TL1 are cascaded; there is no prescaler.
1
0
8-bit autoreload timer/counter. TH1 holds a value that is to be reloaded into TL1 each time it overflows.
1
Timer/Counter 1 stopped.
[3]
Gate
Timer 0 gating control. Set by software to enable Timer/Counter 0 only while INT0 pin is high and TR0 control bit is set.
Cleared by software to enable Timer 0 whenever TR0 control bit is set.
[2]
C/T
Timer 0 timer or counter select bit. Set by software to select counter operation (input from T0 pin). Cleared by software to
select timer operation (input from internal system clock).
[1:0]
M[1:0]
Timer 0 Mode Select Bit 1 and Bit 0.
M1
M0
Description
0
TH0 operates as an 8-bit timer/counter. TL0 serves as a 5-bit prescaler.
0
1
16-bit timer/counter. TH0 and TL0 are cascaded; there is no prescaler.
1
0
8-Bit autoreload timer/counter. TH0 holds a value that is to be reloaded into TL0 each time it overflows.
1
TL0 is an 8-bit timer/counter controlled by the standard timer 0 control bits.
TH0 is an 8-bit timer only, controlled by Timer 1 control bits.
相關PDF資料 |
PDF描述 |
|---|---|
| ADUC834BCPZ-REEL | IC MCU 62K FLASH ADC/DAC 56LFCSP |
| ADUC836BCPZ | IC MCU 62K FLASH ADC/DAC 56LFCSP |
| ADUC843BSZ62-5 | IC ADC 12BIT W/FLASH MCU 52-MQFP |
| ADUC845BCPZ62-5 | IC FLASH MCU W/24BIT ADC 56-CSP |
| ADUC847BCPZ62-5 | IC MCU FLASH W/24BIT ADC 56-CSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADUC832QS-U1 | 制造商:Analog Devices 功能描述:EVAL KIT - Bulk |
| ADUC834 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter, Dual 16-Bit/24-Bit ADCs with Embedded 62 kB Flash MCU |
| ADUC834_02 | 制造商:AD 制造商全稱:Analog Devices 功能描述:MicroConverter, Dual 16-Bit/24-Bit ADCs with Embedded 62 kB Flash MCU |
| ADUC834BCP | 制造商:Rochester Electronics LLC 功能描述:8BIT CISC 62KB FLASH 12.58MHZ 3.3/5V 56LFCSP - Bulk 制造商:Analog Devices 功能描述: |
| ADUC834BCPZ | 功能描述:IC MCU 62K FLASH ADC/DAC 56LFCSP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 標準包裝:250 系列:LPC11Uxx 核心處理器:ARM? Cortex?-M0 芯體尺寸:32-位 速度:50MHz 連通性:I²C，Microwire，SPI，SSI，SSP，UART/USART，USB 外圍設備:欠壓檢測/復位，POR，WDT 輸入/輸出數:40 程序存儲器容量:96KB（96K x 8） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):1.8 V ~ 3.6 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:48-LQFP 包裝:托盤 其它名稱:568-9587 |
發布緊急采購，3分鐘左右您將得到回復。