參數資料
型號： AD9146BCPZ
廠商： Analog Devices Inc
文件頁數： 26/56頁
文件大?。?/td> 0K
描述： IC DAC 16BIT SRL DUAL 48LFCSP
標準包裝： 1
系列： TxDAC+®
設置時間： 20ns
位數： 16
數據接口： 串行
轉換器數目： 2
電壓電源： 模擬和數字
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 48-WFQFN 裸露焊盤，CSP
供應商設備封裝： 48-LFCSP-WQ（7x7）
包裝： 托盤
輸出數目和類型： 2 電流，單極
采樣率（每秒）： 1.23G
AD9146
Data Sheet
Rev. A | Page 32 of 56
DIGITAL DATAPATH
The block diagram in Figure 39 shows the functionality of the
digital datapath. The digital processing includes a premodula-
tion block, two half-band (HB) interpolation filters, phase and
offset adjustment blocks, and an inverse sinc filter.
PREMOD
PHASE
AND
OFFSET
ADJUSTMENT
HB1
HB2
SINC–1
09691-
103
Figure 39. Block Diagram of Digital Datapath
The digital datapath accepts I and Q data streams and processes
them as a quadrature data stream. The signal processing blocks can
be used when the input data stream is represented as complex data.
The digital datapath can also be used to process an input data
stream representing two independent real data streams, but the
functionality is somewhat restricted. The premodulation block
and any of the nonshifted interpolation filter modes can be used
for an input data stream representing two independent real data
for more information.
PREMODULATION
The half-band interpolation filters have selectable pass bands
that allow the center frequencies to be moved in increments of
one-half their input data rate. The premodulation block provides
a digital upconversion of the incoming waveform by one-half the
incoming data rate, fDATA. This can be used to frequency-shift base-
band input data to the center of the interpolation filter pass band.
INTERPOLATION FILTERS
The transmit path contains two interpolation filters. Both inter-
polation filters provide a 2× increase in output data rate. The
half-band (HB) filters can be individually bypassed or cascaded
to provide 1×, 2×, or 4× interpolation ratios. Each half-band
filter stage offers a different combination of bandwidths and
operating modes.
The bandwidth of the two half-band filters with respect to the
data rate at the filter input is as follows:
Bandwidth of HB1 = 0.8 × fIN1
Bandwidth of HB2 = 0.5 × fIN2
The usable bandwidth is defined as the frequency over which
the filters have a pass-band ripple of less than ±0.001 dB and
an image rejection of greater than +85 dB. As described in the
Half-Band Filter 1 (HB1) section, the image rejection usually
sets the usable bandwidth of the filter, not the pass-band
flatness.
The half-band filters operate in several modes, providing
programmable pass-band center frequencies as well as signal
modulation. The HB1 filter has four modes of operation, and
the HB2 filter has eight modes of operation.
Half-Band Filter 1 (HB1)
HB1 has four modes of operation, as shown in Figure 40. The
shape of the filter response is identical in each of the four modes.
The four modes are distinguished by two factors: the filter center
frequency and whether the input signal is modulated by the
filter.
0
–20
–40
–60
–80
–100
0
2.0
1.8
1.6
1.4
1.2
1.0
0.8
0.6
0.4
0.2
M
AG
NI
T
UDE
(
d
B)
FREQUENCY (×
fIN1) (Hz)
MODE 0
MODE 1
MODE 3
MODE 2
09691-
045
Figure 40. HB1 Filter Modes
As shown in Figure 40, the center frequency in each mode is
offset by one-half the input data rate (fIN1) of the filter. Mode 0
and Mode 1 do not modulate the input signal. Mode 2 and
Mode 3 modulate the input signal by fIN1. When operating in
Mode 0 and Mode 2, the I and Q paths operate independently
and no mixing of the data between channels occurs. When oper-
ating in Mode 1 and Mode 3, mixing of the data between the
I and Q paths occurs; therefore, the data input into the filter is
assumed to be complex. Table 15 summarizes the HB1 modes.
Table 15. HB1 Filter Modes
Mode
fCENTER
fMOD
Input Data
0
DC
None
Real or complex
1
fIN/2
None
Complex
2
fIN
Real or complex
3
3fIN/2
fIN
Complex
相關PDF資料
PDF描述
GTC02R-36-5P CONN RCPT 4POS BOX MNT W/PINS
VE-2TY-MX-F2 CONVERTER MOD DC/DC 3.3V 49.5W
MS27508E24B4PC CONN RCPT 56POS BOX MNT W/PINS
VE-2TY-MW-F2 CONVERTER MOD DC/DC 3.3V 66W
MS27508E24B4PB CONN RCPT 56POS BOX MNT W/PINS
相關代理商/技術參數
參數描述
AD9146BCPZRL 功能描述:IC DAC 16BIT SRL DUAL 48LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC+® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 設置時間:1µs 位數:8 數據接口:串行 轉換器數目:8 電壓電源:雙 ± 功率耗散（最大）:941mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC W 包裝:帶卷 (TR) 輸出數目和類型:8 電壓，單極 采樣率（每秒）:*
AD9146-EBZ 制造商:Analog Devices 功能描述:16 BIT DUAL SIGNAL PROC DAC EB - Boxed Product (Development Kits)
AD9146-M5375-EBZ 功能描述:BOARD EVAL FOR AD9146 DAC RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:TxDAC+® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
AD9148 制造商:AD 制造商全稱:Analog Devices 功能描述:Quad 16-Bit,1 GSPS, TxDAC+ Digital-to-Analog Converter
AD9148ARUZ 制造商:Analog Devices 功能描述:- Rail/Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*