- 您現在的位置：買賣IC網 > PDF目錄376463 > XRT83SL30 (Exar Corporation) SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR PDF資料下載
參數資料
| 型號： | XRT83SL30 |
| 廠商： | Exar Corporation |
| 英文描述： | SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| 中文描述： | 單通道的T1/E1/J1上海收發器時鐘恢復和抖動衰減器 |
| 文件頁數： | 43/76頁 |
| 文件大?。?/td> | 376K |
| 代理商： | XRT83SL30 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁
á
XRT83SL30
SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR
PRELIMINARY
HOST MODE SERIAL INTERFACE OPERATION
XRT83SL30 has a simple four wire Serial Interface that is compatible with many of the microcontrollers avail-
able in the market. The Host mode operation is enabled by connecting pin 20 (HW/HOST) to a “Low”. The Se-
rial Interface provides a total of 32 “Read/Write” 8-bit registers that consists of the following signals:
CS
-
Chip Select (Active "Low")
SCLK
-
Serial Clock
SDI
-
Serial Data Input
SDO
-
Serial Data Output
REV. P1.0.4
40
USING THE MICROPROCESSOR SERIAL INTERFACE
The following instructions for using the Microprocessor Serial Interface are best understood by referring to the
diagram in Figure 23.
In order to use the Serial interface, a clock signal must be applied to the SCLK input pin. The maximum SCLK
clock frequency is 20MHz. A Read or Write operation can then be initiated by asserting the active-low Chip Se-
lect (CS) input pin. For proper operation the CS must be asserted “Low” at least 50ns prior to the first rising
edge of the SCLK. Once the CS pin has been asserted, the Read/Write Operation and the target register can
be specified through the Serial Interface by writing eight serial bits into the SDI input. Each bit will be clocked
on the rising edge of SCLK.The function of the eight bits are identified and described below:
Bit 1:
R/W (Read/Write) Bit
This bit is clocked into the SDI input on the first rising edge of the SCLK after CS has been asserted. This bit in-
dicates whether the current operation is a “Read” or a “Write”. A “1” in this bit specifies a Read operation,
whereas a “0” specifies a “Write” operation.
相關PDF資料 |
PDF描述 |
|---|---|
| XRT83SL30IV | SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83VSH28 | 8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH28IB | 8-CHANNEL E1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH314 | 14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH314IB | 14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT83SL30ES | 功能描述:外圍驅動器與原件 - PCI 1 CHT1/E1 LIUSH RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83SL30IV | 制造商:EXAR 制造商全稱:EXAR 功能描述:SINGLE-CHANNEL T1/E1/J1 SH TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT83SL30IV-F | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
| XRT83SL30IVTR-F | 功能描述:外圍驅動器與原件 - PCI RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83SL314 | 制造商:EXAR 制造商全稱:EXAR 功能描述:14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
發布緊急采購，3分鐘左右您將得到回復。