參數資料
型號: TMS32C5402PGER10G4
廠商: Texas Instruments, Inc.
元件分類: 數字信號處理
英文描述: FIXED-POINT DIGITAL SIGNAL PROCESSOR
中文描述: 定點數字信號處理器
文件頁數: 7/68頁
文件大?。?/td> 948K
代理商: TMS32C5402PGER10G4
SPRS079E – OCTOBER 1998 – REVISED AUGUST 2000
7
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251–1443
terminal functions
The following table lists each signal, function, and operating mode(s) grouped by function.
Terminal Functions
TERMINAL
NAME
TYPE
DESCRIPTION
DATA SIGNALS
A19
A18
A17
A16
A15
A14
A13
A12
A11
A10
A9
A8
A7
A6
A5
A4
A3
A2
A1
A0
(MSB)
(LSB)
O/Z
Parallel address bus A19 [most significant bit (MSB)] through A0 [least significant bit (LSB)]. The lower sixteen
address pins (A0 to A15) are multiplexed to address all external memory (program, data) or I/O, while the upper
four address pins (A16 to A19) are only used to address external program space. These pins are placed in the
high-impedance state when the hold mode is enabled, or when OFF is low.
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
(MSB)
(LSB)
I/O/Z
Parallel data bus D15 (MSB) through D0 (LSB). The sixteen data pins (D0 to D15) are multiplexed to transfer
data between the core CPU and external data/program memory or I/O devices. The data bus is placed in the
high-impedance state when not outputting or when RS or HOLD is asserted. The data bus also goes into the
high-impedance state when OFF is low.
The data bus has bus holders to reduce the static power dissipation caused by floating, unused pins. These bus
holders also eliminate the need for external bias resistors on unused pins. When the data bus is not being driven
by the ’5402, the bus holders keep the pins at the previous logic level. The data bus holders on the ’5402 are
disabled at reset and can be enabled/disabled via the BH bit of the bank-switching control register (BSCR).
INITIALIZATION, INTERRUPT, AND RESET OPERATIONS
IACK
O/Z
Interrupt acknowledge signal. IACK Indicates receipt of an interrupt and that the program counter is fetching the
interrupt vector location designated by A15–A0. IACK also goes into the high-impedance state when OFF is low.
INT0
INT1
INT2
INT3
I
External user interrupts. INT0–INT3 are prioritized and are maskable by the interrupt mask register (IMR) and
the interrupt mode bit. INT0 –INT3 can be polled and reset by way of the interrupt flag register (IFR).
NMI
I
Nonmaskable interrupt. NMI is an external interrupt that cannot be masked by way of the INTM or the IMR. When
NMI is activated, the processor traps to the appropriate vector location.
I = input, O = output, Z = high impedance, S = supply
All revisions of the ’5402 can be operated with an external clock source, provided that the proper voltage levels be driven on the X2/CLKIN
pin. It should be noted that the X2/CLKIN pin is referenced to the device 1.8V power supply (CVDD), rather than the 3V I/O supply (DVDD).
Refer to the recommended operating conditions section of this document for the allowable voltage levels of the X2/CLKIN pin.
相關PDF資料
PDF描述
TMS34020 GRAPHICS PROCESSORS
TMS3450NL LED DUPLEX DIGITAL RADIO CLOCK
TMS3471CFS 780- 】 488-pixel ccd image sensor
TMS3471 2/3-INCH NTSC TIMER
TMS3473 PARALLEL DRIVER
相關代理商/技術參數
參數描述
TMS32C6202BGNZA250 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Pt Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
TMS32C6203BGLS173A 制造商:Texas Instruments 功能描述:FIXED-POINT DIGITAL SIGNAL PROCESSOR - Trays
TMS32C6203BGLS173H 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:DSP FIX PT 16BIT 173MHZ 1384MIPS 384PIN FC/CSP - Trays
TMS32C6203BGNY17-3 制造商:Texas Instruments 功能描述:TMS C6203B 1.7V REV 2.X GNY 300 MHZ - Trays
TMS32C6203BGNZA250 功能描述:數字信號處理器和控制器 - DSP, DSC Fixed-Point Dig Sig Processor RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT