參數資料
型號: SAH-C515A-4R
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP80
封裝: METRIC, PLASTIC, QFP-80
文件頁數: 141/182頁
文件大小: 1917K
代理商: SAH-C515A-4R
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁當前第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁
Semiconductor Group
6-10
1997-08-01
On-Chip Peripheral Components
C515A
the current
I
IL . If, in addition, the pullup FET p3 is activated, a higher current can be sourced
(
I
TL). Thus, an additional power consumption can be avoided if port pins are used as inputs
with a low level applied. However, the driving capability is stronger if a logic high level is
output.
The described activating and deactivating of the four different transistors translates into four states
the pins can be:
input low state (IL), p2 active only
input high state (IH) = steady output high state (SOH) p2 and p3 active
forced output high state (FOH), p1, p2 and p3 active
output low state (OL), n1 active
If a pin is used as input and a low level is applied, it will be in IL state, if a high level is applied, it will
switch to IH state.
If the latch is loaded with "0", the pin will be in OL state.
If the latch holds a "0" and is loaded with "1", the pin will enter FOH state for two cycles and then
switch to SOH state. If the latch holds a "1" and is reloaded with a "1" no state change will occur.
At the beginning of power-on reset the pins will be in IL state (latch is set to "1", voltage level on pin
is below of the trip point of p3). Depending on the voltage level and load applied to the pin, it will
remain in this state or will switch to IH (=SOH) state.
If it is used as output, the weak pull-up p2 will pull the voltage level at the pin above p3’s trip point
after some time and p3 will turn on and provide a strong "1". Note, however, that if the load exceeds
the drive capability of p2 (
IIL), the pin might remain in the IL state and provide a week "1" until the
first 0-to-1 transition on the latch occurs. Until this the output level might stay below the trip point of
the external circuitry.
The same is true if a pin is used as bidirectional line and the external circuitry is switched from
output to input when the pin is held at "0" and the load then exceeds the p2 drive capabilities.
If the load exceeds
IIL the pin can be forced to "1" by writing a "0" followed by a "1" to the port pin.
相關PDF資料
PDF描述
SAH-C515C-LM 8-BIT, 10 MHz, MICROCONTROLLER, PQFP80
SAH-XC2210U-8F66R 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PDSO38
SAH-XC2387A-104F80L 16-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAH-XC2387C-200F100L 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
SAH-XC2387C-136F100L 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
相關代理商/技術參數
參數描述
SAH-C517A 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-bit CMOS MICROCONTROLLER
SAHC684M50R501 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:Tantalum Capacitors
SAHC685M20R501 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:Tantalum Capacitors
SAHD106M25R501 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:Tantalum Capacitors
SAHD155M50R501 制造商:SHARMA 制造商全稱:Sharma Electro Components,Inc 功能描述:Tantalum Capacitors