- 您現在的位置：買賣IC網 > PDF目錄2012 > MC92603VF (Freescale Semiconductor)IC TXRX ETH QUAD GIG 256-MAPBGA PDF資料下載
參數資料
| 型號： | MC92603VF |
| 廠商： | Freescale Semiconductor |
| 文件頁數： | 54/126頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX ETH QUAD GIG 256-MAPBGA |
| 標準包裝： | 1 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 4/4 |
| 規程： | 千兆位以太網 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 256-LBGA |
| 供應商設備封裝： | 256-MAPBGA |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
Transmitter
MC92603 Quad Gigabit Ethernet Transceiver Reference Manual, Rev. 1
Freescale Semiconductor
2-11
/S/ Ordered_set to indicate Start_of_Frame. The MC92603 will support shorter preambles. The minimum
preamble size is a single 0x55 code group followed by a 0xD5 code group.
If XMIT_x_ERR is also raised when XMIT_x_ENABLE is raised, then a false carrier is declared, and a
void code groups (/V/) is transmitted.
If XMIT_x_ERR is raised after XMIT_x_ENABLE has been raised and while data is being transferred,
this is a request to transmit an error propagation Ordered_set (/V/) for as many code groups as long as
XMIT_x_ERR remains high.
When a normal End_of_Packet is detected (XMIT_x_ENABLE transitions to low and XMIT_x_ERR
remains low), a single End_of_Packet ordered_set (/T/) is transmitted followed by at least one
Carrier_Extend (/R/) ordered_set. A second Carrier_Extend will be inserted (if necessary) to complete an
even/odd pair. This is then followed by IDLE ordered_sets to indicate the inter-packet gap. The first /I/
may be either an /I1/ or /I2/, depending on running disparity.
If XMIT_x_ERR transitions to high as XMIT_x_ENABLE transitions to low, this is defined as a ‘carrier
extension.’ The ‘carrier extension’ state is a half-duplex feature and is not supported in the MC92603.
XMIT_x_ERR will be ignored while XMIT_x_ENABLE is low.
Transmitting in the Ethernet-compatability mode with the reduced (RGMII) interface is shown in
Table 2-8. The transmitter functional operation is the same as discussed above, except the data is entered
on both edges of the transmitter input clock, XMIT_x_CLK.
The 8 bits of uncoded data are entered with the least significant 4 bits on the rising clock and the most
significant bits on the falling clock edge.
2.5.2
Transmitting Coded Data—TBI or RTBI Modes
The PMA sublayer of the 1000BASE-X specification does not require any functional differences in the
transmitter from that used in the backplane application mode. Therefore, when operating in a mode
specified when the TBIE input is high, the state of the COMPAT input does not affect the transmitter’s
operation. See Section 2.4.2, “Transmitting Coded Data—10-/5-Bit Modes.”
Table 2-8. Transmitter Inputs for RGMII Operating Mode
Data on Rising Edge of XMIT_x_CLK
Data on Falling Edge of XMIT_x_CLK
MC92603 Signal Name
GMII_TX_EN
GMII_TX_EN (XOR) GMII_TX_ER
XMIT_x_ENABLE
Data bits 3–0
Data bits 7–4
XMIT_x_3/XMIT_x_0
相關PDF資料 |
PDF描述 |
|---|---|
| MC92604VM | IC ETH TXRX DUAL GIG 196-MAPBGA |
| MC92604ZT | IC TXRX ETH DUAL GIG 196-MAPBGA |
| MCP2120T-I/SL | IC ENCODR/DECODR 2.5V IR 14-SOIC |
| MCP2122-E/P | IC ENCODER/DECODER IRDA 8-DIP |
| MCP2122T-E/SNG | IC ENCODER/DECODR INFRARED 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC92603VM | 功能描述:IC ETH TXRX QUAD GIG 256-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC92604VM | 功能描述:IC ETH TXRX DUAL GIG 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC92604ZT | 功能描述:IC TXRX ETH DUAL GIG 196-MAPBGA RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
| MC92610 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
| MC92610VF | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES |
發布緊急采購，3分鐘左右您將得到回復。