- 您現在的位置：買賣IC網 > PDF目錄384344 > GS1503-CFZ (Gennum Corporation) HD EMBEDDED AUDIO CODEC PDF資料下載
參數資料
| 型號： | GS1503-CFZ |
| 廠商： | Gennum Corporation |
| 元件分類： | Codec |
| 英文描述： | HD EMBEDDED AUDIO CODEC |
| 中文描述： | 高清嵌入式音頻編解碼 |
| 文件頁數： | 10/83頁 |
| 文件大?。?/td> | 815K |
| 代理商： | GS1503-CFZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁
15879 - 4
10 of 83
G
22
OPERATE
O
Audio processing indicator. When HIGH, audio data is being multiplexed or
demultiplexed.
23
CRC_ERROR
O
CRC error indicator. Will be set HIGH when a CRC error is detected in the incoming video
data stream.
24
PKTENO
O
Arbitrary data packet timing signal. Valid in Multiplex Mode only. Will be HIGH when
arbitrary data packets can be input to the device. This signal is only valid when
multiplexing arbitrary data packets via the PKT[7:0] bus.
See Figure 30 for timing.
25
PKTEN
I/O
Arbitrary data packet enable. In Multiplex Mode, PKTEN is an input and must be set HIGH
two VCLK cycles after the PKTENO signal goes HIGH. Arbitrary packet data is input to the
device two VCLK cycles after PKTEN is set HIGH. In Demultiplex Mode, PKTEN is an
output and is set HIGH two VCLK cycles before the device outputs arbitrary packet data.
See Figures 30 and 42.
26, 28, 29,
30, 32, 33,
34, 35
PKT[7:0]
I/O
Arbitrary data I/O bus. PKT[7] is the MSB and PKT[0] is the LSB. In Multiplex Mode, the
user must input the arbitrary data packet words starting from the data identification (DID)
to the last user data word (UDW) according to SMPTE 291M. The GS1503 internally
converts the data to 10 bits by generating the parity bit (bit 8) and inversion bit (bit 9). The
checksum (CS) word is also generated internally. In Demultiplex Mode, the GS9023
outputs the arbitrary data packet words starting from the DID to the last UDW.
See Figures 30 and 42.
38
SCRBYPASS
I
Scrambler bypass. When set LOW, the output video stream is scrambled according to
SMPTE 292M and NRZ(I) encoded. When set HIGH, the scrambler and NRZ(I) encoder
are bypassed.
39, 40, 41,
42
RSV
-
Connect to ground.
43
EXTH
I/O
Horizontal sync signal. The GS1503 outputs a horizontal sync signal derived from the
incoming TRS. In Multiplex Mode, with EXT_SEL set HIGH in the Host Interface, a
horizontal sync signal can be input to the device for TRS and line number insertion.
44
EXTF
I/O
Field sync signal. The GS1503 outputs a field sync signal derived from the incoming TRS.
In Multiplex Mode, with EXT_SEL set HIGH in the Host Interface, a field sync signal can be
input to the device for TRS and line number insertion. For progressive formats, a signal
with a high to low transition at the position of line one must be provided.
See Figures 14 and 15.
45
VIDEO_DET
O
Video input signal detection. Indicates that the device has detected a valid video input stream.
NOTE: When EXT_SEL is set HIGH in the Host Interface, VIDEO_DET will indicate when
valid EXTH and EXTF signals have been detected.
71, 70, 69,
67, 66, 65,
63, 62, 61,
59, 58, 57,
55, 54, 53,
51, 50, 49,
47, 46
VOUT[19:0]
O
Parallel digital video signal output. VOUT[19] is the MSB and VOUT[0] is the LSB.
74
WCOUTA
O
48kHz word clock for channels 1 to 4. Valid only when operating in Demultiplex Mode.
75
WCOUTB
O
48kHz word clock for channels 5 to 8. Valid only when operating in Demultiplex Mode.
76
AOUT1/2
O
Audio signal output for channels 1 and 2. The AES/EBU digital audio output is bi-phase
mark encoded. In both non-AES/EBU modes, the output is not bi-phase mark encoded.
77
AOUT3/4
O
Audio signal output for channels 3 and 4. The AES/EBU digital audio output is bi-phase
mark encoded. In both non-AES/EBU modes, the output is not bi-phase mark encoded.
78
AOUT5/6
O
Audio signal output for channels 5 and 6. The AES/EBU digital audio output is bi-phase
mark encoded. In both non-AES/EBU modes, the output is not bi-phase mark encoded.
PIN DESCRIPTIONS (Continued)
NUMBER
SYMBOL
TYPE
DESCRIPTION
相關PDF資料 |
PDF描述 |
|---|---|
| GS1508-CKAE3 | HDTV Cable Driver |
| GS1508-CTAE3 | HDTV Cable Driver |
| GS1511-CQR | HD-LINX -TM GS1511 HDTV Serial Digital Formatter |
| GS1511-CQRE3 | HD-LINX -TM GS1511 HDTV Serial Digital Formatter |
| GS1524A | GS1524A HD-LINX-RII Adaptive Cable Equalizer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| GS1504 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HDTV Adaptive Equalizer |
| GS1504_04 | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HDTV Adaptive Equalizer |
| GS1504-CKD | 制造商:Rochester Electronics LLC 功能描述: 制造商:Gennum Corporation 功能描述: |
| GS1504-CKDE3 | 制造商:Gennum Corporation 功能描述:High Performance Cable Equalizer 16-Pin SOIC N |
| GS1504-CTD | 制造商:GENNUM 制造商全稱:GENNUM 功能描述:HDTV Adaptive Equalizer |
發布緊急采購，3分鐘左右您將得到回復。