![](http://datasheet.mmic.net.cn/380000/-PD784214Y_datasheet_16744924/-PD784214Y_615.png)
615
APPENDIX E REVISION HISTORY
APPENDIX E REVISION HISTORY
The following shows the revision history up to present. Application portions signifies the chapter of each edition.
Edition No.
Main Revised Contents from Old Edition
Revised Sections
2nd Edition
Changes the status from “Under development” to “Developed” in the following
products:
m
PD784215, 784216, 784215Y, and 784216Y
Throughout
Changes the packages of the
m
PD784214, 784215, 784216, 784214Y,
784215Y, and 784216Y as follows:
“100-pin plastic QFP (14
¥
14 mm, resin thickness 1.45 mm)” to “100-pin
plastic LQFP QFP (14
¥
14 mm, resin thickness 1.4 mm)”
Table 3-6 Special Function Register (SFR) List
Changes the status from “No” to “Yes” for the 1-bit operation of PRM1, PRM2,
PRM5, PRM6, PRM7, and PRM8.
Changes the status from “Yes” to “No” for the 1-bit operation of IMS.
Chapter 3
CPU ARCHTECTURE
Adds Port 2 (P20 to P27) in
Table 5-3 Port Mode Register and output Latch
Settings when Using Alternate Functions
Chapter 5
PORT FUNCTION
Adds
Caution
about CR00 and CR01 settings in (2) Capture/compare register
00 (CR00) and (3) Capture/compare register 01 (CR01).
Chapter 8
16-BIT TIMER/COUNTER
Adds description of (2) Setting 16-bit compare register and (8) Contention
operation in
Section 8.5 Cautions
.
Changes the A/D conversion time selection in
Figure 14-2 A/D Converter
Mode
Register (ADM) Format
.
Chapter 14
A/D CONVERTER.
Adds description of the condition for reception complete interrupt request
(INTSRn) generation.
Chapter 17
ASYNCHRONOUS SERIAL
INTERFACE/3-WIRE
SERIAL I/O
Modifies transfer clock in
Figure 19-5 Format of the Prescaler Mode
Register (SPRM0) for Serial Clock
Chapter 19
I
2
C BUS MODE
(ONLY
m
PD784216Y
SUBSERIES)
Deletes watchdog timer interrupt (INTWDT) from the HALT mode release
source.
Chapter 25
STAND-BY FUNCTION
Adds watch timer interrupt (INTWT) to STOP mode, IDLE mode, and the
release source of low consumption power IDLE mode.
Adds the following figures:
Figure 25-5 Operation after HALT Mode Release, Figure 25-6 Operation
after STOP Mode Release
, and
Figure 25-9 Operation after IDLE Mode
Release
.
Changes the name of Flash writer as follows:
“Flashpro” to “Flashpro II”
Chapter 27
m
PD78F4216
PROGRAMMING
Appendix B
DEVELOPMENT TOOLS
Deletes the description of special functions (CHKL and CHKLA)
Chapter 28
INSTRUCTION
OPERATION