![](http://datasheet.mmic.net.cn/380000/-PD784214Y_datasheet_16744924/-PD784214Y_6.png)
6
Major Revisions in this Edition
Page
Description
Throughout
Changes the status from “Under development” to “Developed” in the following products:
m
PD784215, 784216, 784215Y, and 784216Y
Changes the packages of the
m
PD784214, 784215, 784216, 784214Y, 784215Y, and 784216Y as
follows:
“100-pin plastic QFP (14
¥
14 mm, resin thickness 1.45 mm)” to “100-pin plastic LQFP QFP (14
¥
14
mm, resin thickness 1.4 mm)”
Table 3-6 Special Function Register (SFR) List of Chapter 3 CPU ARCHTECTURE
Changes the status from “No” to “Yes” for the 1-bit operation of PRM1, PRM2, PRM5, PRM6, PRM7,
and PRM8.
Changes the status from “Yes” to “No” for the 1-bit operation of IMS.
p.95, 96
p.97
Table 5-3 Port Mode Register and output Latch Settings when Using Alternate Functions of
Chapter 5 PORT FUNCTION
Adds Port 2 (P20 to P27)
p.137
Section 8.2 Configuration of Chapter 8 16-BIT TIMER/COUNTER
Adds Caution about CR00 and CR01 settings in (2) Capture/compare register 00 (CR00) and (3)
Capture/compare register 01 (CR01).
Section 8.5 Cautions
Adds description of (2) Setting 16-bit compare register and (8) Contention operation.
p.160, 161
p.187, 189
Figure 14-2 A/D Converter Mode Register (ADM) Format of Chapter 14 A/D CONVERTER
Changes the A/D conversion time selection.
p.267
Section 17.3.2 Asynchronous Serial Interface (UART) Mode (d) of Chapter 17 ASYNCHRONOUS
SERIAL INTERFACE/3-WIRE SERIAL I/O
Adds description of the condition for reception complete interrupt request (INTSRn) generation.
p.307
p.339
Chapter 19 I
2
C BUS MODE (ONLY
m
PD784216Y SUBSERIES)
Modifies transfer clock in
Figure 19-5 Format of the Prescaler Mode Register (SPRM0) for Serial
Clock
.
Chapter 25 STAND-BY FUNCTION
Deletes watchdog timer interrupt (INTWDT) from the HALT mode release source.
Adds clock timer interrupt (INTWT) to STOP mode, IDLE mode, the release source of Low consumption
power IDLE mode.
Adds the following figures:
Figure 25-5 Operation after HALT Mode Release, Figure 25-6 Operation after STOP Mode
Release
, and
Figure 25-9 Operation after IDLE Mode Release
.
p.509, 525
p.529, 533, 536
539, 549
p.521, 530, 537
Chapter 27
m
PD78F4216 PROGRAMMING
and
Appendix B DEVELOPMENT TOOLS
Changes the name of Flash writer as follows:
“Flashpro” to “Flashpro II”
p.553, 555
p.593
p.584, 586
Chapter 28 INSTRUCTION OPERATION
Deletes the description of special functions (CHKL and CHKLA)
p.615
Adds
APPENDIX E REVISION HISTORY
.
The mark shows major revised points.