參數資料
型號: SDED5-008G-NCY
廠商: SANDISK CORP
元件分類: 存儲控制器/管理單元
英文描述: FLASH MEMORY DRIVE CONTROLLER, PBGA115
封裝: 12 X 18 MM, 1.40 MM HEIGHT, FBGA-115
文件頁數: 10/87頁
文件大小: 1675K
代理商: SDED5-008G-NCY
Rev. 1.2
Product Overview
mDOC H3 EFD Featuring Embedded TrueFFS Data Sheet
18
92-DS-1205-10
Signal
Ball No.
Signal Type
1
Description
Signal
Direction
Reserved
C2, C3,
C4, C5,
C6, C7,
C8, C9,
C10, D1,
D2, D9,
D10, E9,
F1, F9,
G1, H1,
J1, K1, K2,
L2, L9,
L10, M2,
M3, M4,
M5,
M6,M7,
M8, M9,
M10
-
All reserved signals are not connected
internally, and if not identified in this
document then it is recommended to leave
them floating to guarantee forward
compatibility with future products. They
should not be connected to arbitrary signals,
and must not be connected to GND
P1
ST/PU
Test Data In (JTAG).
Used for dedicated developer product only4.
Input
M1
CMOS output
Test Data Out (JTAG).
Used for dedicated developer product only4.
Output
L1
ST/PU
Test Mode Select (JTAG)
Used for dedicated developer product only4.
Input
RSRVD
N1
ST/PU
Test Clock (JTAG).
Used for dedicated developer product only4.
Input
Mechanical
NC
A1, A2,
A9, A10,
B1, B2,
B9, B10,
G5, G6,
H5, H6,
N2, N9,
N10, P2,
P9, P10
-
Not Connected.
1. The following abbreviations are used: ST - Schmitt Trigger input. IN/PD – CMOS input with internal pull down resistor (77K to 312K;
135K typical), which is enabled only when 8KB memory window is in use, ST/PU - Schmitt Trigger input with internal pull up resistor
(95K to 261 K; 149 K typical).
2. When mDOC H3 is used as a Master device, SO is used for Serial Interface Data In, and SI is used for Serial Interface Data Out.
3. The capacitor is required only for 1.8V Core and 1.8V I/O configuration. Please see section 9.5 for further details.
4. The RSRVD JTAG balls will only be enabled on special versions of the mDOC H3 devices that will be used for debugging severe system
problems. In order to support this feature, the JTAG balls should be brought out to a separate header or test points. The JTAG RSRVD
balls must not be connected to the JTAG scan chain that is used for the rest of the PCB. If not used they should be left floating.
5. BUSY#, DMARQ# and IRQ# should not be pulled up to any voltage higher than VCCQ. A pull-up resistor is required if this pin will be
connected to an input. A 10K ohm resistor to Vccq is recommended, however the exact value depends on system power, timing and signal
integrity requirements.
相關PDF資料
PDF描述
MD80C154-12/883 8-BIT, 12 MHz, MICROCONTROLLER, CDIP40
MD80C154-16P883D 8-BIT, 16 MHz, MICROCONTROLLER, CDIP40
MR83C154CXXX-20/883D 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQCC44
MQ83C154CXXX-L16/883 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQFP44
MD83C154CXXX-25P883D 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CDIP40
相關代理商/技術參數
參數描述
SDED5-512M-N9T 功能描述:IC MDOC H3 4GB 115-FBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:150 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (2 x 256 x 8) 速度:400kHz 接口:I²C,2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-VFDFN 裸露焊盤 供應商設備封裝:8-DFN(2x3) 包裝:管件 產品目錄頁面:1445 (CN2011-ZH PDF)
SDED5-512M-N9Y 功能描述:IC MDOC H3 4GB 115-FBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:150 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (2 x 256 x 8) 速度:400kHz 接口:I²C,2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-VFDFN 裸露焊盤 供應商設備封裝:8-DFN(2x3) 包裝:管件 產品目錄頁面:1445 (CN2011-ZH PDF)
SDED7-002G-NTY 制造商:SanDisk Corporation 功能描述:Flash Card 2G-Byte 1.8V/3.3V Flash Disk 115-Pin FBGA Tray
SDED7-256M-N9T 功能描述:IC MDOC H3 2GB 115-FBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:150 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (2 x 256 x 8) 速度:400kHz 接口:I²C,2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-VFDFN 裸露焊盤 供應商設備封裝:8-DFN(2x3) 包裝:管件 產品目錄頁面:1445 (CN2011-ZH PDF)
SDED7-256M-N9Y 功能描述:IC MDOC H3 256MB FBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:150 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:4K (2 x 256 x 8) 速度:400kHz 接口:I²C,2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-VFDFN 裸露焊盤 供應商設備封裝:8-DFN(2x3) 包裝:管件 產品目錄頁面:1445 (CN2011-ZH PDF)