- 您現在的位置：買賣IC網 > PDF目錄11744 > PI7C8150AMAE (Pericom)IC PCI-PCI BRIDGE 2PORT 208-FQFP PDF資料下載
參數資料
| 型號： | PI7C8150AMAE |
| 廠商： | Pericom |
| 文件頁數： | 76/111頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PCI-PCI BRIDGE 2PORT 208-FQFP |
| 標準包裝： | 24 |
| 系列： | * |
| 應用： | * |
| 接口： | * |
| 電源電壓： | * |
| 封裝/外殼： | 208-BFQFP |
| 供應商設備封裝： | 208-FQFP（28x28） |
| 包裝： | 管件 |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁當前第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁
PI7C8150A
2-PORT PCI-TO-PCI BRIDGE
The secondary bus request and grant signals are connected internally to the arbiter and are
not brought out to external pins when S_CFN_L is HIGH.
Figure 8-1
Secondary Arbiter Example
The secondary arbiter supports a 2-sets programmable 2-level rotating algorithm with each
set taking care of 9 requests / grants. Each set of masters can be assigned to a high priority
group and a low priority group. The low priority group as a whole represents one entry in
the high priority group; that is, if the high priority group consists of n masters, then in at
least every n+1 transactions the highest priority is assigned to the low priority group.
Priority rotates evenly among the low priority group. Therefore, members of the high
priority group can be serviced n transactions out of n+1, while one member of the low
priority group is serviced once every n+1 transactions. Figure 8-1 shows an example of an
internal arbiter where four masters, including PI7C8150A, are in the high priority group,
and five masters are in the low priority group. Using this example, if all requests are always
asserted, the highest priority rotates among the masters in the following fashion (high
priority members are given in italics, low priority members, in boldface type): B, m0, m1,
m2, m3, B, m0, m1, m2, m4, B, m0, m1, m2, m5, B, m0, m1, m2, m6, B, m0, m1, m2, m7
and so on.
Each bus master, including PI7C8150A, can be configured to be in either the low priority
group or the high priority group by setting the corresponding priority bit in the arbiter-
control register. The arbiter-control register is located at offset 40h. Each master has a
corresponding bit. If the bit is set to 1, the master is assigned to the high priority group. If
the bit is set to 0, the master is assigned to the low priority group. If all the masters are
assigned to one group, the algorithm defaults to a straight rotating priority among all the
masters. After reset, all external masters are assigned to the low priority group, and
PI7C8150A is assigned to the high priority group. PI7C8150A receives highest priority on
the target bus every other transaction and priority rotates evenly among the other masters.
Priorities are re-evaluated every time S_FRAME_L is asserted at the start of each new
transaction on the secondary PCI bus. From this point until the time that the next
transaction starts, the arbiter asserts the grant signal corresponding to the highest priority
request that is asserted. If a grant for a particular request is asserted, and a higher priority
request subsequently asserts, the arbiter de-asserts the asserted grant signal and asserts the
grant corresponding to the new higher priority request on the next PCI clock cycle. When
priorities are re-evaluated, the highest priority is assigned to the next highest priority
master relative to the master that initiated the previous transaction. The master that initiated
the last transaction now has the lowest priority in its group.
Page 67 of 111
APRIL 2006 – Revision 1.1
06-0057
相關PDF資料 |
PDF描述 |
|---|---|
| PIC18F2515-I/SP | IC MCU FLASH 24KX16 28-DIP |
| V300A15E500B2 | CONVERTER MOD DC/DC 15V 500W |
| PIC16C73B-04I/SO | IC MCU OTP 4KX14 A/D PWM 28SOIC |
| GRM1555C1H301JA01D | CAP CER 300PF 50V 5% NP0 0402 |
| PIC16LF876A-I/ML | IC PIC MCU FLASH 8KX14 28QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PI7C8150AMAE-33 | 功能描述:外圍驅動器與原件 - PCI 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PI7C8150AND | 制造商:PERICOM 制造商全稱:Pericom Semiconductor Corporation 功能描述:2-PORT PCI-to-PCI BRIDGE |
| PI7C8150AND-33 | 制造商:Pericom Semiconductor Corporation 功能描述:PCI-TO-PCI BRIDGE 256BGA - Rail/Tube |
| PI7C8150ANDE | 功能描述:外圍驅動器與原件 - PCI 2 Port PCI Bridge RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PI7C8150B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PCI Bridge | Asynchronous 2-Port PCI Bridge |
發布緊急采購，3分鐘左右您將得到回復。