參數資料
型號: LPC2368FBD100
廠商: NXP Semiconductors N.V.
元件分類: 數學處理器
英文描述: ARM7 with 512 kB flash, 58 kB SRAM, Ethernet, USB 2.0 Device, CAN, SD-MMC, and 10-bit ADC
封裝: LPC2368FBD100<SOT407-1 (LQFP100)|<<http://www.nxp.com/packages/SOT407-1.html<1<Always Pb-free,;
文件頁數: 3/18頁
文件大小: 220K
代理商: LPC2368FBD100
ES_LPC2368
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Errata sheet
Rev. 9 — 20 April 2011
3 of 18
NXP Semiconductors
ES_LPC2368
Errata sheet LPC2368
1. Product identification
The LPC2368 devices typically have the following top-side marking:
LPC2368xxx
xxxxxxx
xxYYWWR[x]
The last/second to last letter in the third line (field ‘R’) will identify the device revision. This
Errata Sheet covers the following revisions of the LPC2368:
Table 1.
Revision identifier (R)
‘-’
‘A’
‘B’
‘D’
Field ‘YY’ states the year the device was manufactured. Field ‘WW’ states the week the
device was manufactured during that year.
2. Errata overview
Device revision table
Revision description
Initial device revision
Second device revision
Third device revision
Fourth device revision
Table 2.
Functional
problems
Ethernet.4
Functional problems table
Short description
Revision identifier
Detailed description
Ethernet TxConsumeIndex register does not update
correctly after the first frame is sent
ADDRx read conflicts with hardware setting of DONE
bit
Setting up the Ethernet interface in RMII mode
Ethernet SRAM disabled
RxDescriptor number cannot be greater than 4
I
2
S DMA can stall
PLL output is limited to 290 MHz
16 kB SRAM can not be used for code execution
USB_NEED_CLK is always asserted
U1CONNECT is not functional
V
BUS
status input is not functional
Accessing non-Watchdog APB registers in the middle
of the feed sequence causes a reset
Incorrect update of the Abort Link register in Thumb
state
Operating speed out of on-chip flash is restricted
Code execution failure can occur with MAM Mode 2
Data overrun condition can lock the CAN controller
‘-’, ‘A’, ‘B’, ‘D’
Section 3.1 on page 5
ADC.1
‘-’
Section 3.2 on page 5
Ethernet.1
Ethernet.2
Ethernet.3
I2S.1
PLL.1
SRAM.1
USB.1
USB.2
USB.3
WDT.1
‘-’
‘-’
‘-’
‘-’
‘-’
‘-’
‘-’
‘-’
‘-’
‘-’
Section 3.3 on page 6
Section 3.4 on page 7
Section 3.5 on page 7
Section 3.6 on page 7
Section 3.7 on page 8
Section 3.8 on page 8
Section 3.9 on page 9
Section 3.10 on page 9
Section 3.11 on page 9
Section 3.12 on page 10
Core.1
‘-’, ‘A’, ‘B’, ‘D’
Section 3.13 on page 10
Flash.1
MAM.1
CAN.1
‘-’, ‘A’
‘-’, ‘A’
‘-’, ‘A’, ‘B’
Section 3.14 on page 11
Section 3.15 on page 12
Section 3.16 on page 12
相關PDF資料
PDF描述
LPC2377FBD144 Single-chip 16-bit-32-bit microcontrollers; 512 kB flash with ISP-IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC-DAC
LPC2378FBD144 Single-chip 16-bit-32-bit microcontrollers; 512 kB flash with ISP-IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC-DAC
LPC2387FBD100 Single-chip 16-bit-32-bit MCU; 512 kB flash with ISP-IAP, Ethernet, USB 2.0 device-host-OTG, CAN, and 10-bit ADC-DAC
LPC2388FBD144 Single-chip 16-bit-32-bit micro; 512 kB flash with ISP-IAP, Ethernet, USB 2.0 device-host-OTG, CAN, and 10-bit ADC-DAC
LPC2420FBD208 Flashless 16-bit-32-bit microcontroller; Ethernet, CAN, ISP-IAP, USB 2.0 device-host-OTG, external memory interface
相關代理商/技術參數
參數描述
LPC2368FBD100,551 功能描述:ARM微控制器 - MCU ARM7 512KF/USB/ENET RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2368FBD100/CP32 制造商:NXP Semiconductors 功能描述:- Tape and Reel
LPC2368FBD100551 制造商:NXP Semiconductors 功能描述:IC 32BIT MCU 72MHZ LQFP-100
LPC2368FET100 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 16-bit/32-bit ocontrollers; up to 512 kB flash with ISP/IAP, Ethernet, USB 2.0, CAN, and 10-bit ADC/DAC
LPC2368FET100,518 功能描述:ARM微控制器 - MCU 16/32 bit micro RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT