- 您現在的位置：買賣IC網 > PDF目錄385496 > LPC1751FBD80 (NXP SEMICONDUCTORS) Cortex-M3 with 32 kB flash, 8 kB SRAM, USB 2.0 Device, CAN, 12-bit ADC PDF資料下載
參數資料
| 型號： | LPC1751FBD80 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Cortex-M3 with 32 kB flash, 8 kB SRAM, USB 2.0 Device, CAN, 12-bit ADC |
| 中文描述： | 32-BIT, FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP80 |
| 封裝： | 12 X 12 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT315-1, 80 PIN |
| 文件頁數： | 16/74頁 |
| 文件大?。?/td> | 1572K |
| 代理商： | LPC1751FBD80 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁
LPC1759_58_56_54_52_51
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 7 — 29 March 2011
16 of 74
NXP Semiconductors
LPC1759/58/56/54/52/51
32-bit ARM Cortex-M3 microcontroller
7.7 Nested Vectored Interrupt Controller (NVIC)
The NVIC is an integral part of the Cortex-M3. The tight coupling to the CPU allows for low
interrupt latency and efficient processing of late arriving interrupts.
7.7.1
Features
Controls system exceptions and peripheral interrupts
In the LPC1759/58/56/54/52/51, the NVIC supports 33 vectored interrupts
32 programmable interrupt priority levels, with hardware priority level masking
Relocatable vector table
Non-Maskable Interrupt (NMI)
Software interrupt generation
7.7.2
Interrupt sources
Each peripheral device has one interrupt line connected to the NVIC but may have several
interrupt flags. Individual interrupt flags may also represent more than one interrupt
source.
Any pin on Port 0 and Port 2 (total of 30 pins) regardless of the selected function, can be
programmed to generate an interrupt on a rising edge, a falling edge, or both.
7.8 Pin connect block
The pin connect block allows selected pins of the microcontroller to have more than one
function. Configuration registers control the multiplexers to allow connection between the
pin and the on-chip peripherals.
Peripherals should be connected to the appropriate pins prior to being activated and prior
to any related interrupt(s) being enabled. Activity of any enabled peripheral function that is
not mapped to a related pin should be considered undefined.
Most pins can also be configured as open-drain outputs or to have a pull-up, pull-down, or
no resistor enabled.
7.9 General purpose DMA controller
The GPDMA is an AMBA AHB compliant peripheral allowing selected
LPC1759/58/56/54/52/51 peripherals to have DMA support.
The GPDMA enables peripheral-to-memory, memory-to-peripheral,
peripheral-to-peripheral, and memory-to-memory transactions. The source and
destination areas can each be either a memory region or a peripheral, and can be
accessed through the AHB master. The GPDMA controller allows data transfers between
the USB and Ethernet (LPC1758 only) controllers and the various on-chip SRAM areas.
The supported APB peripherals are SSP0/1, all UARTs, the I
2
S-bus interface, the ADC,
and the DAC. Two match signals for each timer can be used to trigger DMA transfers.
Remark:
Note that the DAC is not available on the LPC1752/51, and the I
2
S-bus interface
is not available on the LPC1754/52/51.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2101FBD48 | Single-chip 16-bit-32-bit microcontrollers; 8 kB-16 kB-32 kB flash with ISP-IAP, fast ports and 10-bit ADC |
| LPC2102FBD48 | Single-chip 16-bit-32-bit microcontrollers; 8 kB-16 kB-32 kB flash with ISP-IAP, fast ports and 10-bit ADC |
| LPC2102FHN48 | Single-chip 16-bit-32-bit microcontrollers; 8 kB-16 kB-32 kB flash with ISP-IAP, fast ports and 10-bit ADC |
| LPC2103FBD48 | Single-chip 16-bit-32-bit microcontrollers; 8 kB-16 kB-32 kB flash with ISP-IAP, fast ports and 10-bit ADC |
| LPC2103FHN48 | Single-chip 16-bit-32-bit microcontrollers; 8 kB-16 kB-32 kB flash with ISP-IAP, fast ports and 10-bit ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC1751FBD80,551 | 功能描述:ARM微控制器 - MCU ARM Cortex M3 Micro Controller RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC1751FBD80551 | 制造商:NXP Semiconductors 功能描述:IC 32BIT MCU 100MHZ LQFP-80 |
| LPC1752 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M3 MCU; up to 512 kB flash and 64 kB SRAM with Ethernet, USB 2.0 Host/Device/OTG, CAN |
| LPC1752FBD80 | 制造商:NXP Semiconductors 功能描述:MCU 32BIT ARM CORTEX M3 80LQFP 制造商:NXP Semiconductors 功能描述:MCU, 32BIT, ARM CORTEX M3, 80LQFP 制造商:NXP Semiconductors 功能描述:IC, 32BIT MCU, ARM CORTEX, 100MHZ LQFP80; Controller Family/Series:(ARM Cortex); Core Size:32bit; No. of I/O's:52; Supply Voltage Min:2.4V; Supply Voltage Max:3.6V; Digital IC Case Style:LQFP; No. of Pins:80; Program Memory Size:64KB;RoHS Compliant: Yes |
| LPC1752FBD80,551 | 功能描述:ARM微控制器 - MCU ARM Cortex M3 Micro Controller RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。