參數資料
型號： DS33Z11+
廠商： Maxim Integrated Products
文件頁數： 97/172頁
文件大?。?/td> 0K
描述： IC MAPPER ETHERNET 169-CSBGA
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 7
應用： 數據傳輸
接口： SPI/并聯
電源電壓： 1.8V, 3.3V
封裝/外殼： 169-LBGA，CSPBGA
供應商設備封裝： 169-CSBGA（14x14）
包裝： 托盤
安裝類型： 表面貼裝
產品目錄頁面： 1429 (CN2011-ZH PDF)
DS33Z11 Ethernet Mapper
30 of 172
8.1.1 Read-Write/Data Strobe Modes
The processor interface can operate in either read-write strobe mode or data strobe mode. When MODEC[1:0] =
00 and HWMODE pin = 0 the read-write strobe mode is enabled and a negative pulse on
RD performs a read
cycle, and a negative pulse on
WR performs a write cycle. When MODEC[1:0] pins = 01 and HWMODE pin = 0
the data strobe mode is enabled and a negative pulse on
DS when RW is high performs a read cycle, and a
negative pulse on
DS when RW is low performs a write cycle. The read-write strobe mode is commonly called the
“Intel” mode, and the data strobe mode is commonly called the “Motorola” mode.
8.1.2 Clear on Read
The latched status registers will clear on a read access. It is important to note that in a multi-task software
environment, the user should handle all status conditions of each register at the same time to avoid inadvertently
clearing status conditions. The latched status register bits are carefully designed so that an event occurrence
cannot collide with a user read access.
8.1.3 Interrupt and Pin Modes
The interrupt (
INT) pin is configurable to drive high or float when not active. The INTM bit controls the pin
configuration, when it is set the
INT pin will drive high when not active. After reset, the INT pin is in high-
impedance mode until an interrupt source is active and enabled to drive the interrupt pin.
8.2 SPI Serial EEPROM Interface
The SPI interface is a 4 signal serial interface that allows connection to a serial EEPROM for initialization
information. The DS33Z11 will act as an SPI Master when configured with MODEC[1:0] to read from an external
Serial EEPROM. The reading sequence is commenced upon initial reset or rising edge of the
RST input pin. The
CKPHA pin controls the sampling and update edges of the MISO and MOSI signals. The MISO data can be
sampled on rising or falling edge of SPICK. The MOSI (Master Out Slave In) can be selectively output on the
rising or falling edge of SPICK. The SPICK is generated by the DS33Z11 at a frequency of 8.33 MHz. This
frequency is derived from an external SYSCLKI (100 MHz). The instruction to initiate a read is 0000x011; this is
followed by the address location 0. The
SPI_CS is low till the data addressed (Table 10-1) is read and latched.
The DS33Z11 will provide the starting address (0000000) and the data is sequentially latched till the last data is
read and latched. The MAC specific registers, which are addressed indirectly, are written at the end of the normal
control registers. More details of the programming sequence an functional timing information can be found in
Section 10.3. The indirect registers related to the MAC are programmed using a special command format as
shown in Table 10-2.
相關PDF資料
PDF描述
V110B3V3H100BL3 CONVERTER MOD DC/DC 3.3V 100W
D38999/20JD18SA CONN RCPT 18POS WALL MNT W/SCKT
V110B3V3H100BL2 CONVERTER MOD DC/DC 3.3V 100W
MAX3980UTH+ IC XAUI QUAD EQUAL 44-TQFN
V110B3V3H100BL CONVERTER MOD DC/DC 3.3V 100W
相關代理商/技術參數
參數描述
DS33Z11+ 功能描述:網絡控制器與處理器 IC Ethernet Mapper RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS33Z11+UNUSED 功能描述:網絡控制器與處理器 IC Ethernet Mapper RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS33Z11DK 功能描述:以太網開發工具 DS33Z11 Dev Kit RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓:
DS33Z41 功能描述:網絡控制器與處理器 IC Quad IMUX Ethernet Mapper RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS33Z41DK 功能描述:以太網開發工具 DS33Z41 Dev Kit RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*