參數資料
型號： CLRC632
廠商： NXP Semiconductors N.V.
英文描述： Multiple Protocol Contactless Reader IC
中文描述： 多協議非接觸式讀卡器IC
文件頁數： 120/163頁
文件大?。?/td> 948K
代理商： CLRC632
Philips Semiconductors
Product Specification Rev. 3.0; May 2003
Multiple Protocol Contactless Reader IC
CL RC632
120
Confidential
18.4.2.3 Collision Detection
If more than one card is within the RF-field during the card selection phase, they will respond simultaneously.
The CL RC632 supports the algorithm defined in ISO14443-A to resolve data-collisions of cards serial
numbers by doing the so-called anti-collision procedure. The basis for this is the ability to detect bit-
collisions.
Bit-collision detection is supported by the used bit-coding scheme, namely the Manchester-coding. If in the
first and second half-bit of a bit a sub-carrier modulation is detected, instead of forwarding a 1 or a 0 a bit
collision will be signalled. To distinguish a 1 or 0-bit from a bit-collision, the CL RC632 uses the setting of
CollLevel
. If the amplitude of the half-bit with smaller amplitude is larger than defined by
CollLevel
, the CL
RC632 indicates a bit-collision.
If a bit-collision is detected, the error flag
CollErr
is set. If a bit-collision is detected in a parity bit, the flag
ParityErr
is set indicating a parity error.
Independent from the detected collision the receiver continues receiving the incoming data stream. In case of
a bit-collision, the decoder forwards 1 at the collision position.
Note: As an exception, if bit
ZeroAfterColl
is set, all bits received after the first bit-collision are forced to zero,
regardless whether a bit-collision or an unequivocal state has been detected. This feature eases for the
software to carry out the anti-collision procedure defined in ISO14443-A.
When the first bit collision in a frame is detected, the bit position of this collision is stored in the
CollPos
Register
.
The collision position follows the table below:
Collision in Bit
Value of CollPos
SOF
0
LSBit of LSByte
1
…
…
MSBit of LSByte
8
LSBit of second Byte
9
…
…
MSBit of second Byte
16
LSBit of third Byte
17
…
…
Table 18-2: Returned Values for Bit Collision Positions
The parity bits are not counted in
CollPos
, since a bit-collision in a parity bit per definition succeeds a bit-
collision in the data bits. If a collision is detected in the SOF a frame error is reported and no data is
forwarded to the FIFO buffer. In this case the receiver continues to monitor the incoming signal and
generates the correct notifications to the μ-Processor when the ending of the faulty input stream is detected.
This helps the μ-Processor to determine the time when it is allowed next to send anything to the card.
相關PDF資料
PDF描述
CM-2 Low Cost Miniature Double Balanced Mixer 10-1000 MHz
CM04MC01T COMMON MODE CHOKE COILS (FOR DC AND SIGNAL LINES) SMD TYPE
CM05RC01T COMMON MODE CHOKE COILS (FOR DC AND SIGNAL LINES) SMD TYPE
CM05RC02T CONNECTOR ACCESSORY
CM05RC03T COMMON MODE CHOKE COILS (FOR DC AND SIGNAL LINES) SMD TYPE
相關代理商/技術參數
參數描述
CLRC63201T/0FE 制造商:NXP Semiconductors 功能描述:
CLRC63201T/0FE,112 功能描述:RFID應答器 I.CODE HS READER RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
CLRC63201T/0FE,118 制造商:NXP Semiconductors 功能描述:Interface Misc
CLRC63201T/0FE112 制造商:NXP Semiconductors 功能描述:CNTCLESS RC 5V ISO14443 + ISO15693
CLRC663 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Contactless reader IC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*