
TA1310N
2001-06-25
57
Y stage
(#16 VCC = 9 V, #37 VCC = 9 V, #51 VCC = 5 V, Ta = 25 ± 3°C)
SW MODE
NOTE
ITEM
SW45
MEASUREMENT METHOD
Y1
Sync Input~DL Output
AC Gain
A
1) Input signal C-2 to the Sync Input pin (TP38).
f0 = 100 kHz, picture period amplitude = 0.2 Vp-p
2) Turn DL mode off (subaddress (12), data (80)) and measure the picture period amplitude v43off of the DL output (TP43).
Calculate the gain from the input (GYoff) by the formula shown below.
3) Turn DL mode on (subaddress (12), data (A0)) and measure the picture period amplitude v43on of the DL output (TP43).
Calculate the gain from the input (GYon) by the formula shown below.
2
0
43off
v
20Log
GYoff
.
=
2
0
43on
v
20Log
GYon
.
=
Y2
Sync Input~DL Output
Frequency Gain
A
1) Input signal C-2 to the Sync Input pin (TP38).
f0 = 8 MHz, picture period amplitude = 0.2 Vp-p
2) Turn DL mode off (subaddress (12), data (80)) and measure the picture period amplitude v438Moff of the DL output (TP43).
Calculate the gain from the input (GfYoff) by the formula shown below.
3) Turn DL mode on (subaddress (12), data (A0)) and measure the picture period amplitude v438Mon of the DL output (TP43).
Calculate the gain from the input (GfYon) by the formula shown below.
43off
v
438Moff
v
20Log
GfYoff
=
43on
v
438Mon
v
20Log
GfYon
=
Y3
Sync Input~DL Output
Dynamic Range
A
1) Input signal C-3 to the Sync Input pin (TP38).
2) When the amplitude A of signal C-3 is increased from 0, observe the change in the picture period amplitude of the DL output
(TP43). With DL mode turned on and off, when the output amplitude stops changing in a linear direction, measure the input signal
amplitude A.
Y4
Sync Input~DL Output
Transfer Characteristics
A
1) Input signal C-2 to the Sync Input pin (TP38).
f0 = 100 kHz, picture period amplitude = 0.2 Vp-p
2) Turn DL mode on (subaddress (12H), data (20)) and measure the amount of delay TYLD from the Sync Input (#38) to the DL
output (TP43).
Note 1: Where the bus data are not specified, set the preset value.
Note 2: Ensure the sync signal is always input to TP38 (SYNC IN).