參數資料
型號: T7264
英文描述: T7264 U-Interface 2B1Q Transceiver
中文描述: T7264 U型接口2B1Q收發器
文件頁數: 40/54頁
文件大?。?/td> 876K
代理商: T7264
40
Lucent Technologies Inc.
Data Sheet
April 1998
T7264 U-Interface 2B1Q Transceiver
Appendix A. Questions and Answers
Introduction
The questions and answers are divided into three cate-
gories: U-interface, K2 interface, and miscellaneous.
For detailed application information, also refer to the
application notes Implementation of an ANSI Standard
ISDN NT1 Using the Lucent T7262A/63, T7252A,
T7270, and an 8-Bit Microcontroller and Performance
Factors in Line-Powered 2B1Q Applications.
U-Interface
Q1
:
Is the line interface for the T7264 the same as the
T7262A/63
A1
:
The interface is different in that the T7262A/63
uses a Lucent 2754G transformer (2.5:1 turns
ratio), and the T7264 uses a Lucent 2754H trans-
former (1.5:1 turns ratio).
Other changes to the line interface include
device-side resistors of 16.9
±
1% and line-side
resistors of 16.9
±
7%. Part of the line-side
resistance will likely be a PTC in those applica-
tions requiring power cross protection.
The T7264 device-side protection is unchanged
(521A diodes), and the dc blocking capacitor is
unchanged (Illinois Capacitor* 1.0
μ
F
±
5%).
Line-side protection must be tailored to individual
system needs.
Q2
:
Why is a higher transformer magnetizing
inductance used (as compared to other
vendors)
A2
:
It has been determined that a higher inductance
provides better linearity. Furthermore, it has been
found that a higher inductance at the far end pro-
vides better receiver performance at the near end
and better probability of start-up at long loop
lengths.
Q3
:
Can the T7264 be used with a transformer that
has a magnetizing inductance of 20 mH
A3
:
The echo canceler and tail canceler are
optimized for a transformer inductance of approx-
imately 80 mH and will not work with a value this
low.
Q4
:
Are the Lucent U-interface transformers available
as surface-mount components
A4
:
Not at this time.
Q5
:
Are there any future plans to make a smaller
height 2-wire transformer
A5
:
Due to the rigid design specifications for the
transformer, vendors have found it difficult to
make the transformer any smaller. We are con-
tinuing to work with transformer vendors to see if
we can come up with a smaller solution.
Q6
:
The line interface components’ specifications
require 16.9
resistors on the line side of the
transformer. We would like to change this value
for our application. Can the U-interface line-side
circuit be redesigned to change the value of the
line-side resistors
A6
:
Yes. For example, the line-side resistances can
be reflected back to the device side of the trans-
former so that, instead of having 16.9
on each
side of the transformer, there are no resistors on
the line side of the transformer and 24.4
resis-
tors on the device side (16.9 + 16.9/N
2
, where N
is the turns ratio of the transformer). However,
there may be some performance penalty in this
case since the on-chip hybrid network is opti-
mized for 16.9
of resistance on the device side
of the transformer.
* Illinois Capacitor is a registered trademark of Illinois Capacitor Inc.
相關PDF資料
PDF描述
T7289A DS1 Line Interface(DS1 線接口)
T8207 Asychronous Transfer Mode (ATM) Interconnect(異步傳輸模式互連器件)
T8208 Asychronous Transfer Mode (ATM) Interconnect(異步傳輸模式互連器件)
TA1241ANG DEFLECTION PROCESSOR IC FOR TVs
TA1270BFG PAL / NTSC VIDEO CHROMA AND SYNC PROCESSING SYSTEM FOR PIP / POP / PAP
相關代理商/技術參數
參數描述
T7264ML 制造商:Alcatel-Lucent 功能描述:DATACOM, DIGITAL SLIC, 44 Pin Plastic PLCC
T7264ML2 制造商:Alcatel-Lucent 功能描述:7264ML2
T7267 制造商:TE Connectivity 功能描述:
T7268 制造商:TE Connectivity 功能描述:
T727 制造商:USEM 功能描述:MOTOR VOLTAGE:208-230/460, HERTZ:50/60, 3-PHASE, 8.5-8.0/4.0A, RPM:3465, 1-SPEED, FR:182T, RIGID BASE, CLOSED MOTOR, REVERSE ROTATION, BALL BEARINGS, 1-1/8 X 2-7/8 FRAME : ALL OTHER HERTZ : 50/60 HERTZ HP OR WATTAGE : 3 HP PHASE : 3 PHASE ROTATION (ALL SE) : REV RPM : 3001 AND UP SPEEDS : 1 SPEED VOLTAGE : MULTI VOLT