- 您現在的位置：買賣IC網 > PDF目錄384931 > ST16C2552 (Exar Corporation) Dual UART with 16-Byte Transmit and Receive FIFO(雙通用異步接收器/發送器（帶16字節接收和發送先進先出）) PDF資料下載
參數資料
| 型號： | ST16C2552 |
| 廠商： | Exar Corporation |
| 英文描述： | Dual UART with 16-Byte Transmit and Receive FIFO(雙通用異步接收器/發送器（帶16字節接收和發送先進先出）) |
| 中文描述： | 雙UART），16字節的傳輸和接收FIFO（雙通用異步接收器/發送器（帶16字節接收和發送先進先出） |
| 文件頁數： | 16/32頁 |
| 文件大?。?/td> | 409K |
| 代理商： | ST16C2552 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
ST16C2552
16
Rev. 3.50
disabled, FCR bit-0 = logic 0) or in the FIFO mode
(FIFOs enabled, FCR bit-0 = logic 1, FCR bit-3 = logic
0) and when there are no characters in the transmit
FIFO or transmit holding register, the -TXRDY pin will
be a logic 0. Once active the -TXRDY pin will go to a
logic 1 after the first character is loaded into the
transmit holding register.
Receive operation in mode 0:
When the 2552 is in mode 0 (FCR bit-0 = logic 0) or
in the FIFO mode (FCR bit-0 = logic 1, FCR bit-3 =
logic 0) and there is at least one character in the
receive FIFO, the -RXRDY signal at the MF pin will be
a logic 0. Once active the -RXRDY signal at the MF pin
will go to a logic 1 when there are no more characters
in the receiver. Note: The MF Register must be set to
the RXRDY mode prior to any possible reading of the
-RXRDY signal.
Transmit operation in mode 1:
When the 2552 is in FIFO mode ( FCR bit-0 = logic 1,
FCR bit-3 = logic 1 ), the -TXRDY pin will be a logic 1
when the transmit FIFO is completely full. It will be a
logic 0 if one or more FIFO locations are empty.
Receive operation in mode 1:
When the 2552 is in FIFO mode (FCR bit-0 = logic 1,
FCR bit-3 = logic 1) and the trigger level has been
reached, or a Receive Time Out has occurred, the -
RXRDY signal at the MF pin will go to a logic 0. Once
activated, it will go to a logic 1 after there are no more
characters in the FIFO. Note: The MF Register must
be set to the RXRDY mode prior to any possible
reading of the -RXRDY signal.
FCR BIT 4-5:
Not Used - initialized to a logic 0.
FCR BIT 6-7: (logic 0 or cleared is the default condi-
tion, RX trigger level = 1)
These bits are used to set the trigger level for the
receive FIFO interrupt.
An interrupt is generated when the number of charac-
ters in the FIFO equals the programmed trigger level.
However the FIFO will continue to be loaded until it is
full.
BIT-7
BIT-6
RX FIFO trigger level
0
0
1
1
0
1
0
1
01
04
08
14
Interrupt Status Register (ISR)
The 2552 provides four levels of prioritized interrupts
to minimize external software interaction. The Inter-
rupt Status Register (ISR) provides the user with four
interrupt status bits. Performing a read cycle on the
ISR will provide the user with the highest pending
interrupt level to be serviced. No other interrupts are
acknowledged until the pending interrupt is serviced.
Whenever the interrupt status register is read, the
interrupt status is cleared. However it should be noted
that only the current pending interrupt is cleared by the
read. A lower level interrupt may be seen after reread-
ing the interrupt status bits. The Interrupt Source
Table 6 (below) shows the data values (bits 0-3) for the
four prioritized interrupt levels and the interrupt
sources associated with each of these interrupt levels:
相關PDF資料 |
PDF描述 |
|---|---|
| ST16C450 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450CJ44 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450CP40 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450CQ48 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
| ST16C450IJ44 | UNIVERSAL ASYNCHRONOUS RECEIVER/TRANSMITTER (UART) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST16C2552_06 | 制造商:EXAR 制造商全稱:EXAR 功能描述:2.97V TO 5.5V DUAL UART WITH 16-BYTE FIFO |
| ST16C2552CJ | 制造商:EXAR 功能描述:IC , Dual UART 4MBPS 5.5 44 PLCC 制造商:Exar Corporation 功能描述: 制造商:XIC 功能描述: 制造商:Exar Corporation 功能描述:UART, 44 Pin, Plastic, PLCC |
| ST16C2552CJ-0A-EB | 功能描述:界面開發工具 Supports C2550 44 ld PLCC, ISA Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V |
| ST16C2552CJ44 | 制造商:Exar Corporation 功能描述: 制造商:Exar Corporation 功能描述:UART, 44 Pin, Plastic, PLCC 制造商:EXER 功能描述:UART, 44 Pin, Plastic, PLCC 制造商:STAR 功能描述:UART, 44 Pin, Plastic, PLCC 制造商:STARTECH 功能描述:UART, 44 Pin, Plastic, PLCC |
| ST16C2552CJ44-F | 功能描述:UART 接口集成電路 2.97V-5.5V 16B FIFO temp 0C to 70C; UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。