參數資料
型號: SAF-C513A-HN
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 8-BIT, EEPROM, 8 MHz, MICROCONTROLLER, PQCC44
封裝: PLASTIC, LCC-44
文件頁數: 8/128頁
文件大?。?/td> 1837K
代理商: SAF-C513A-HN
Semiconductor Group
9-5
EEPROM Programming Interface
SAB-C513A-H
9.2.1 Selection of the Programming Mode
The programming mode is selected by applying specific logic levels to the four PMS0-3 pins of the
SAB-C513A-H.
Table 9-2
Programming Mode Selection Pins
Note that PMS3 has to be active (’1’) during the whole programming mode operation. During normal
operation PMS2 and PMS1 are outputs (PSEN, ALE) and no external driving circuitry should be
connected to these pins.
It should be also noted, that always a clock has to be supplied in programming mode and that the
operating voltage is restricted to 5 V
± 10%.
9.2.2 Resetting the Programming Interface
By applying a high level to the PRES pin the contents of the programming interface registers will be
set to their initial values. When entering the programming mode, PRES should be held high.
The programming interface must not be reset while programming or erasing the EEPROM (PROG
bit =1). The program or erase cycle should be finished properly before resetting the interface.
9.2.3 Interface Bus Operation
The programming interface with its registers can be accessed via a Intel type multiplexed bus
interface. Figures 9-9-4 and 9-9-5 illustrate a read and a write access to the registers. To enable
access to the programming interface the enable input PCS must be active during the entire access
cycle (from leading edge of ALE until trailing edge of RD or WR). PCS should always be deactivated
between subsequent accesses to the programming interface. With the falling edge of ALE the
address of the register to be accessed is latched. The read signal puts the contents of the selected
register onto the bus. During write cycles the write signal latches the data bus content into the
selected register. Each read and write cycle must be initiated by a PALE high pulse.
Mode
PMS3
(RESET)
PMS2
(PSEN)
PMS1
(ALE)
PMS0
(EA)
Normal Mode
1 or 0
none
0 or 1
Programming Mode
1010
相關PDF資料
PDF描述
SAF-C515A-LM 8-BIT, 18 MHz, MICROCONTROLLER, PQFP80
SAF-C515C-8EMCA 8-BIT, OTPROM, 10 MHz, MICROCONTROLLER, PQFP80
SAF-C517A-4R24M 8-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP100
SAF-C868-1RR 8-BIT, MROM, 40 MHz, MICROCONTROLLER, PDSO38
SAF-C868-1SR 8-BIT, 40 MHz, MICROCONTROLLER, PDSO38
相關代理商/技術參數
參數描述
SAF-C513AO 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-bit CMOS Microcontroller
SAF-C515 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAF-C515-1R24M 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAF-C515-1RM 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAF-C515A-4R 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller