參數資料
型號： OL2300NHN
廠商： NXP SEMICONDUCTORS
元件分類： 通信及網絡
英文描述： Fractional-N PLL based transmitter
中文描述： SPECIALTY TELECOM CIRCUIT, PQCC16
封裝： 3 X 3 MM, 0.85 MM HEIGHT, LEAD FREE, PLASTIC, MO-220, SOT758-1, VQFN-16
文件頁數： 6/46頁
文件大?。?/td> 951K
代理商： OL2300NHN
OL2300
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 2 — 28 October 2010
6 of 46
NXP Semiconductors
OL2300
Fractional-N PLL based transmitter
SDIO
is the configurable bidirectional data input/output pin of the serial interface. By
default, the bidirectional mode is configured, so SDIO is used for both input and output
data transmission. If ENSDO in register ACON2 is set, SDIO is used as input only and
TEST1 is configured as data output SDO (4-wire interface). The SDO pin is high ohmic
until data is written.
Table 3.
ENSDO
0
1
Data in or data out operation is adapted automatically during SPI communication
sequences.
Table 4.
C1
0
0
1
6.1.3
Reference oscillator
The reference oscillator is a Pierce type with automatic amplitude regulation and gain
control to reduce the total current consumption. The device pins XTAL1 and XTAL2
connect the internal circuitry to the external reference crystal resonator and load
capacitances. To get oscillation on the specified crystal frequency the input capacitances
of the two XTAL pins and PCB parasitics must be considered. The oscillator typically
operates at frequencies ranging from 9 MHz to 19 MHz to achieve the allowed
transmission frequencies.
6.1.4
Baud rate generator
The output pin of the integrated baud rate generator CKOUT, will provide a clock, which is
derived from the XTAL clock frequency. The baud rate is programmable by a special
function register-set (BDSEL, SCSEL). CKOUT is not always active (see
Section 6.7.2
).
6.1.5
Power amplifier
The power amplifier is driven from the PLL synthesizer and operates in single-ended
fashion, according to
Figure 9
.
(Serial data output)/TEST1 control (ENSDO)
SDO/TEST1 control state
pin TEST1 not used (only for test purposes)
pin TEST1 used as SDO (Serial Data Output)
Fig 5.
Command overview
Command overview
C0
0
1
0
Command
write SFR
read SFR
transmit
A-F
start address A5..A0
start address A5..A0
transmit options
001aak383
EN
SCK
SDIO
C1 C0 A
B
C
D
E
F
DATA
相關PDF資料
PDF描述
OL2311AHN Highly Integrated Single Chip Sub 1-GHz RF Receiver
OL2381AHN Highly Integrated Single Chip Sub 1-GHz RF Transceiver
OL3216TC-DPG CERAMIC BASIC TYPE HIGH-PERFORMANCE LEDS
OLDA23TZ-WPG REFLECTOR COATING TYPE HIGH-PERFORMANCE LEDS
OLDPM8T1-L1G MOLDING TYPE SMD LED LAMPS
相關代理商/技術參數
參數描述
OL2300NHN/F,118 功能描述:鎖相環 - PLL Fractional-N PLL Based Transmitter RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray
OL2311AHN/C0B,515 功能描述:射頻接收器 Single-chip sub 1GHz RF receiver RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel
OL2381AHN/C0B,515 功能描述:射頻收發器 Single Chip 1-GHz 射頻收發器 RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray
OL2381AHN/C0B515 制造商:Rochester Electronics LLC 功能描述: 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述:
OL2385AHN/00100Y 功能描述:RF WIRELESS PLATFORM UHF 制造商:nxp usa inc. 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:TxRx + MCU 射頻系列/標準:- 協議:- 調制:ASK，F(xiàn)SK 數據速率（最大值）:- 功率 - 輸出:14dBm 靈敏度:-124dBm 存儲容量:- 串行接口:SPI，UART GPIO:12 電壓 - 電源:1.9 V ~ 5.5 V 電流 - 接收:- 電流 - 傳輸:29mA 工作溫度:-40°C ~ 85°C 封裝/外殼:48-VFQFN 裸露焊盤 標準包裝:1
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*