- 您現在的位置：買賣IC網 > PDF目錄385657 > OL2300NHN (NXP SEMICONDUCTORS) Fractional-N PLL based transmitter PDF資料下載
參數資料
| 型號： | OL2300NHN |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 通信及網絡 |
| 英文描述： | Fractional-N PLL based transmitter |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQCC16 |
| 封裝： | 3 X 3 MM, 0.85 MM HEIGHT, LEAD FREE, PLASTIC, MO-220, SOT758-1, VQFN-16 |
| 文件頁數： | 5/46頁 |
| 文件大?。?/td> | 951K |
| 代理商： | OL2300NHN |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
OL2300
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 2 — 28 October 2010
5 of 46
NXP Semiconductors
OL2300
Fractional-N PLL based transmitter
6.1.2
Interface and control logic
6.1.2.1
Configurable 3-wire or 4-wire interface
The OL2300 can be configured via a simple Serial Peripheral Interface (SPI). The
interface itself can be configured for 3-wire or 4-wire mode. The 4-wire mode uses pin
TEST1 as Serial Data Output SDO when the SDIO is used as input (see
Figure 4
).
EN
pin must be set to enable communication via the 3 or 4-wire serial interface. If the EN
pin is kept low for at least 2
16
XTAL clock pulses, the transmitter device will be reset, the
bit-counter implemented inside the SPI counting the already transferred bits shall be set to
zero, SCK and SDIO are disabled and the device will enter the Power-down mode (also
the crystal oscillator is switched off). If the 4-wire interface has been used, a reset would
also deactivate the SDO pin (set to 3-state; ENSDO is not influenced).
After a transmit command the EN pin has an additional function: At the falling edge of the
EN pin the level of the SDIO pin is latched and directly connected to the modulator input.
In this case it is possible to intercept the RF data transmission without deactivating the PA
and to loop the last transmitted bit while the SDIO interface is used for SFR configuration.
Note that EN must not be low for more than 2
16
XTAL clock pulses otherwise the device
will be reset.
SCK
pin is the clock input for the serial interface. Depending on the start-up condition of
SCK at the rising edge of EN (see
Section 6.7.9
) each rising/falling edge of SCK shifts
data into or gets data from the SPI register set. During RF data transmission the SCK is
don’t care (signal on SCK has no influence on interface).
Fig 4.
Peripheral connection diagram
001aak382
MICROCONTROLLER
EN
3-wire interface
(transparent mode: baud-rate generated by
μ
C)
SCK
SDIO
OL2300
MICROCONTROLLER
EN
3-wire interface
(synchronized mode: baud-rate generated by Frantic)
SCK
SDIO
OL2300
MICROCONTROLLER
EN
SCK
SDI
SDO
4-wire interface
CKOUT
CKOUT
OL2300
相關PDF資料 |
PDF描述 |
|---|---|
| OL2311AHN | Highly Integrated Single Chip Sub 1-GHz RF Receiver |
| OL2381AHN | Highly Integrated Single Chip Sub 1-GHz RF Transceiver |
| OL3216TC-DPG | CERAMIC BASIC TYPE HIGH-PERFORMANCE LEDS |
| OLDA23TZ-WPG | REFLECTOR COATING TYPE HIGH-PERFORMANCE LEDS |
| OLDPM8T1-L1G | MOLDING TYPE SMD LED LAMPS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| OL2300NHN/F,118 | 功能描述:鎖相環 - PLL Fractional-N PLL Based Transmitter RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray |
| OL2311AHN/C0B,515 | 功能描述:射頻接收器 Single-chip sub 1GHz RF receiver RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
| OL2381AHN/C0B,515 | 功能描述:射頻收發器 Single Chip 1-GHz 射頻收發器 RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| OL2381AHN/C0B515 | 制造商:Rochester Electronics LLC 功能描述: 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述: |
| OL2385AHN/00100Y | 功能描述:RF WIRELESS PLATFORM UHF 制造商:nxp usa inc. 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:TxRx + MCU 射頻系列/標準:- 協議:- 調制:ASK，F(xiàn)SK 數據速率（最大值）:- 功率 - 輸出:14dBm 靈敏度:-124dBm 存儲容量:- 串行接口:SPI，UART GPIO:12 電壓 - 電源:1.9 V ~ 5.5 V 電流 - 接收:- 電流 - 傳輸:29mA 工作溫度:-40°C ~ 85°C 封裝/外殼:48-VFQFN 裸露焊盤 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。