參數資料
型號： MPC9894VFR2
廠商： INTEGRATED DEVICE TECHNOLOGY INC
元件分類： 時鐘及定時
英文描述： 9894 SERIES, PLL BASED CLOCK DRIVER, 8 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PBGA100
封裝： 11 X 11 MM, MAPBGA-100
文件頁數： 24/28頁
文件大?。?/td> 362K
代理商： MPC9894VFR2
Advanced Clock Drivers Devices
Freescale Semiconductor
5
MPC9894
OPERATING INFORMATION
Basic Functional Description
The MPC9894 is a quad-redundancy IDCS clock
generator. The redundancy feature allows automatic
switching from the reference clock source to a secondary
clock source on detection of a failed reference clock. The
MPC9894 will detect and report a missing clock on any of its
four inputs. Based upon the current IDCS mode setting and
the qualifier input pins, the MPC9894 will switch to the next
qualified secondary clock.
The input clock sources, CLK0, CLK1, CLK2, and CLK3,
are assumed to be the same frequency(1) but non-phase-
related sources. When a clock switch occurs, the phase
alignment to the new clock source will occur over an
extended time period, eliminating runt clock output pulses.
The maximum rate of phase change is specified in the AC
parameter Delta Period per Cycle(PER/CYC). The device
uses a fully integrated PLL to generate clock signals from
redundant clock sources. The PLL multiplies the input
reference clock signal by a variety of values, including 0.25,
0.5, 1, 2, 4 or 8. For a complete list refer to Table 9. The
frequency multiplied clock signal drives four independent
output banks. Each output bank is phase-aligned to the input
reference clock phase, providing virtually zero-delay
capability(2).
The configuration of the MPC9894 series of clock
generators is performed through either the I2C interface or by
the preset configuration mode. The I2C interface uses a 2 pin
interface to transmit clock and data to and from a series of
configuration and status registers in the MPC9894.
Definitions
IDCS:
Intelligent Dynamic Clock Switch. The IDCS monitors the
clock inputs CLK0, CLK1, CLK2, and CLK3. Upon a failure of
the reference clock signal, the IDCS switches to a qualified
secondary clock signal and the status flags are set.
Reference clock signal:
The input clock signal that is selected by the IDCS or
IDCS_MODE[2:0] as the input reference to the PLL.
Primary clock:
The input clock signal selected by IDCS_MODE[2:0]. The
primary clock may or may not be the reference clock,
depending on IDCS mode and IDCS status.
Secondary clock:
The input clock signal which will be selected by the IDCS
upon an automatic clock switch.
Tertiary, Quaternary clocks:
The input clock signals that will be selected by the IDCS,
in turn, after the current secondary clock. This clock selection
is based upon a round robin rotational sequence
Manual IDCS mode:
The reference clock input is selected by
IDCS_MODE[0xx].
Automatic IDCS mode:
The reference clock signal is determined by the IDCS.
Selected clock:
The SEL_STAT[1:0] flags indicate the reference clock
signal.
Qualified clock:
The corresponding CLK_VALID[3:0] signal is logic high,
the associated CLK_STAT status bit is logic high and no clock
failure is present.
Bit Ordering:
The bit ordering convention used in this document for both
pin and register documentation is NAME[7:0] where bit 7 is
the most significant bit and 0 is the least significant bit.
1. Refer to Table 39 for clock frequency specification.
2. Using external feedback.
相關PDF資料
PDF描述
MPC998FAR2 PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32
MPC998FA 998 SERIES, PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32
MPC9990FAR2 PLL BASED CLOCK DRIVER, 11 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP48
MPC9991FAR2 PLL BASED CLOCK DRIVER, 13 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP52
MPC99J93FAR2 PLL BASED CLOCK DRIVER, 5 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQFP32
相關代理商/技術參數
參數描述
MPC9894VM 制造商:IDT from Components Direct 功能描述:IDT MPC9894VM PLL - Trays 制造商:IDT 功能描述:IDT MPC9894VM PLL
MPC990 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:LOW VOLTAGE PLL CLOCK DRIVER
MPC990F18 F44A WAF 制造商:Motorola Inc 功能描述:
MPC991 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:LOW VOLTAGE PLL CLOCK DRIVER
MPC991FA 制造商:Motorola Inc 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*