參數資料
型號： MAX7000B
廠商： Altera Corporation
英文描述： Programmable Logic Device
中文描述： 可編程邏輯器件
文件頁數： 15/66頁
文件大?。?/td> 421K
代理商： MAX7000B
Altera Corporation
15
MAX 7000B Programmable Logic Device Data Sheet
In-System
Programma-
bility (ISP)
MAX 7000B devices can be programmed in-system via an industry-
standard 4-pin IEEE Std. 1149.1 (JTAG) interface. ISP offers quick, efficient
iterations during design development and debugging cycles. The
MAX 7000B architecture internally generates the high programming
voltages required to program EEPROM cells, allowing in-system
programming with only a single 2.5-V power supply. During in-system
programming, the I/O pins are tri-stated and weakly pulled-up to
eliminate board conflicts. The pull-up value is nominally 50 k.
MAX 7000B devices have an enhanced ISP algorithm for faster
programming. These devices also offer an ISP_Done bit that provides safe
operation when in-system programming is interrupted. This ISP_Done
bit, which is the last bit programmed, prevents all I/O pins from driving
until the bit is programmed.
ISP simplifies the manufacturing flow by allowing devices to be mounted
on a PCB with standard pick-and-place equipment before they are
programmed. MAX 7000B devices can be programmed by downloading
the information via in-circuit testers, embedded processors, the Altera
MasterBlaster communications cable, and the ByteBlasterMV parallel port
download cable. Programming the devices after they are placed on the
board eliminates lead damage on high-pin-count packages (e.g., QFP
packages) due to device handling. MAX 7000B devices can be
reprogrammed after a system has already shipped to the field. For
example, product upgrades can be performed in the field via software or
modem.
In-system programming can be accomplished with either an adaptive or
constant algorithm. An adaptive algorithm reads information from the
unit and adapts subsequent programming steps to achieve the fastest
possible programming time for that unit. A constant algorithm uses a
pre-defined (non-adaptive) programming sequence that does not take
advantage of adaptive algorithm programming time improvements.
Some in-circuit testers cannot program using an adaptive algorithm.
Therefore, a constant algorithm must be used. MAX 7000B devices can be
programmed with either an adaptive or constant (non-adaptive)
algorithm.
The Jam Standard Test and Programming Language (STAPL), JEDEC
standard JESD-71, can be used to program MAX 7000B devices with
in-circuit testers, PCs, or embedded processors.
f
For more information on using the Jam language, see
Application Note 88
(Using the Jam Language for ISP & ICR via an Embedded Processor)
and
Application Note 122 (Using STAPL for ISP & ICR via an Embedded Processor)
.
The ISP circuitry in MAX 7000B devices is compliant with the IEEE
Std. 1532 specification. The IEEE Std. 1532 is a standard developed to
allow concurrent ISP between multiple PLD vendors.
相關PDF資料
PDF描述
MAX7000 Programmable Logic Device Family
MAX7000S Programmable Logic Device Family
MAX7030 RES 22.1-OHM 1% 0.1W 100PPM THICK-FILM SMD-0603 5K/REEL-7IN-PA
MAX7030-ATJ Low-Cost, 315MHz, 345MHz, and 433.92MHz ASK Transceiver with Fractional-N PLL
MAX7030HATJ Low-Cost, 315MHz, 345MHz, and 433.92MHz ASK Transceiver with Fractional-N PLL
相關代理商/技術參數
參數描述
MAX7000S 制造商:ALTERA 制造商全稱:Altera Corporation 功能描述:Programmable Logic Device Family
MAX700C/D 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel
MAX700C/D DIE 制造商:Maxim Integrated Products 功能描述:
MAX700CPA 功能描述:監控電路 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel
MAX700CPA+ 功能描述:監控電路 Power-Supply Monitor w/Reset RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*