參數資料
型號： HMS91C7134
英文描述： [Monitor]
中文描述： [顯示器]
文件頁數： 74/86頁
文件大?。?/td> 1508K
代理商： HMS91C7134
HMS91C7134
74
November.2001 ver1.0
Encryption Array
Within the EPROM array are 64bytes of Encryption Array that
are initially unprogrammed (all 1s). Every time that a byte ad-
dressed during a verify, address line are used to select a byte of
the Encryption array. This byte is then exclusive NOR-ed
(XNOR) with the code byte, creating an Encrypted Verify byte.
The algorithm, with the array in the unprogrammed state (all 1s),
will return the code in its original, unmodified form. It is recom-
mended that whenever the Encryption Array is used, at least one
of the Lock Bits be programmed as well.
Reading the Signature Bytes
The HMS97C7134 signature bytes in location 30H and 20H. To read these bytes follow the procedure for EPROM verify, except that P3.6
and P3.7 need to be pulled to a logic low.
Table 21-3 The Value
Quick-pulse programming
The setup for micro-controller quick-pulse programming is
shown in Figure 21-2. Note that the HMS97C7134 is running
with a 4 to 6MHz oscillator. The reason the oscillator needs to be
running is that the device is executing internal address and pro-
gram data transfers.
The address of the EPROM location to be programmed is applied
to port 1, 2 and VSYNCIN, as shown in Figure 21-1. The code
byte to be programmed into that location is applied to port 0. RE-
SET, PSEN and pins of port2 and 3 in Table 21.1 are held at the
“Program Code Data” levels indicated in Table 21.1. The P3.5/
PROG is pulsed low 10 times as shown Figure 21-2.
To program the encryption table, repeat the 10 pulses program-
ming sequence for address 0 through 3F H, using the “Program
Encryption Table” levels. Do not forget that after the encryption
table is programmed, verification cycle will produce only en-
crypted data.
To program the security bits, repeat the 10 pulses programming
sequence using the “Program Security Bit” levels. After one se-
curity bit is programmed, further programming of the code mem-
ory and encryption table is disabled. However, the other security
bit can still be programmed. Note that INT0/VPP pin must not be
allowed to go above the maximum specified VPP level for any
amount of time. Even a narrow glitch above that voltage can
cause permanent damage to the device.
The VPP source should be well regulated and free glitches and
overshoot.
Remarks
Device
Device ID
Manufacturer ID
Location
20H
30H
HMS97C7132
Contents
68H
ADH
相關PDF資料
PDF描述
HMS97C7134 [Monitor]
HMS97C8032 H8/SLP Series, 38799 Group, 4-ch 14-bit PWM, 2-ch 16-bit TPU, 16-bit AEC, RTC FP-100U; Vcc= 1.8 to 3.6 volts, Temp= -20 to 75 C; Package: PLQP0100KB-A
HMS99C51S 8-BIT SINGLE-CHIP MICROCONTROLLERS WITH EMBEDDED FLASH
HMS99C52S 8-BIT SINGLE-CHIP MICROCONTROLLERS WITH EMBEDDED FLASH
HMS99C54S 8-BIT SINGLE-CHIP MICROCONTROLLERS WITH EMBEDDED FLASH
相關代理商/技術參數
參數描述
HMS91C7432 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HMS91C7432 features and functions
HMS91C8032 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS
HMS97C7132 制造商:未知廠家 制造商全稱:未知廠家 功能描述:[Monitor]
HMS97C7134 制造商:未知廠家 制造商全稱:未知廠家 功能描述:[Monitor]
HMS97C8032 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:HYNIX SEMICONDUCTOR INC. 8-BIT SINGLE-CHIP MICROCONTROLLERS
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*