- 您現在的位置：買賣IC網 > PDF目錄16848 > EVAL-ADAU1761Z (Analog Devices Inc)BOARD EVAL FOR ADAU1761 PDF資料下載
參數資料
| 型號： | EVAL-ADAU1761Z |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 25/92頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR ADAU1761 |
| 標準包裝： | 1 |
| 系列： | SigmaDSP® |
| 主要目的： | 音頻編解碼器 |
| 嵌入式： | 是，DSP |
| 已用 IC / 零件： | ADAU1761 |
| 主要屬性： | 立體聲，24 位，8 ~ 96 kHz 采樣率，GUI 工具 |
| 次要屬性： | I²C 和 GPIO 接口，2 差分和 1 個立體聲單端模擬輸入和輸出 |
| 已供物品： | 2 個板，線纜，CD |
| 產品目錄頁面： | 776 (CN2011-ZH PDF) |
| 相關產品： | ADAU1761BCPZ-RL-ND - IC SIGMADSP CODEC PLL 32LFCSP ADAU1761BCPZ-R7-ND - IC SIGMADSP CODEC PLL 32LFCSP ADAU1761BCPZ-ND - IC SIGMADSP CODEC PLL 32LFCSP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
ADAU1761
Rev. C | Page 31 of 92
Digital Microphone Input
Microphone Bias
When using a digital microphone connected to the JACKDET/
MICIN pin, the JDFUNC[1:0] bits in Register R2 (Address 0x4008)
must be set to 10 to enable the microphone input and disable the
jack detection function. The ADAU1761 must operate in master
mode and source BCLK to the input clock of the digital micro-
phone. The DSPRUN bit must also be asserted in Register R62
(DSP run register, Address 0x40F6) for digital microphone
operation.
The MICBIAS pin provides a voltage reference for electret analog
microphones. The MICBIAS voltage is set in Register R10
(record microphone bias control register, Address 0x4010). In
this register, the MICBIAS output can be enabled or disabled.
Additional options include high performance operation and a
gain boost. The gain boost provides two different voltage biases:
0.65 × AVDD or 0.90 × AVDD. When enabled, the high perfor-
mance bit increases supply current to the microphone bias
circuit to decrease rms input noise.
The digital microphone signal bypasses record path mixers and
ADCs and is routed directly into the decimation filters. The
digital microphone and ADCs share decimation filters and,
therefore, both cannot be used simultaneously. The digital
microphone input select bit, INSEL, can be set in Register R19
(ADC control register, Address 0x4019). Figure 36 depicts the
digital microphone interface and signal routing.
The MICBIAS pin can also be used to cleanly supply voltage
to digital microphones or analog microphones with separate
power supply pins.
ANALOG-TO-DIGITAL CONVERTERS
The ADAU1761 uses two 24-bit Σ-Δ analog-to-digital con-
verters (ADCs) with selectable oversampling ratios of 64× or
128× (selected by Bit 3 in Register R17, Address 0x4017).
JDFUNC[1:0]
DIGITAL MICROPHONE
INTERFACE
LEFT
CHANNEL
RIGHT
CHANNEL
TO JACK
DETECTION
CIRCUIT
JACKDET/MICIN
RIGHT
ADC
LEFT
ADC
DECIMATORS
R19: ADC CONTROL
INSEL
R2: DIGITAL MICROPHONE/
JACK DETECTION
CONTROL
0
768
0-
0
23
ADC Full-Scale Level
The full-scale input to the ADCs (0 dBFS) depends on AVDD.
At AVDD = 3.3 V, the full-scale input level is 1.0 V rms. This
full-scale analog input will output a digital signal at 1.38 dBFS.
This gain offset is built into the ADAU1761 to prevent clipping.
The full-scale input level scales linearly with the level of AVDD.
For single-ended and pseudo-differential signals, the full-scale
value corresponds to the signal level at the pins, 0 dBFS.
The full differential full-scale input level is measured after the
differential amplifier, which corresponds to 6 dBFS at each pin.
Signal levels above the full-scale value cause the ADCs to clip.
Digital ADC Volume Control
The digital ADC volume can be attenuated before DSP pro-
cessing using Register R20 (left input digital volume register,
Address 0x401A) and Register R21 (right input digital volume
register, Address 0x401B).
Figure 36. Digital Microphone Interface Block Diagram
High-Pass Filter
By default, a high-pass filter is used in the ADC path to remove
dc offsets; this filter can be enabled or disabled in Register R19
(ADC control register, Address 0x4019). At fS = 48 kHz, the
corner frequency of this high-pass filter is 2 Hz.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX6174BASA+ | IC VREF SERIES PREC 4.096V 8SOIC |
| GSC06DRXI-S734 | CONN EDGECARD 12POS DIP .100 SLD |
| 0982660987 | CBL 29PS 0.5MM JMPR TYPE A 1.18" |
| SRR5028-680Y | INDUCTOR POWER 68UH 0.62A SMD |
| ADN8831ACPZ-REEL7 | IC THERMO COOLER CTRLR 32LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-ADAU1781Z | 功能描述:BOARD EVAL FOR ADAU1781 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:SigmaDSP® 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| EVAL-ADAU1962AZ | 制造商:Analog Devices 功能描述:EVAL BOARD FOR ADAU1962A - Boxed Product (Development Kits) 制造商:Analog Devices 功能描述:Eval Board for ADAU1962A |
| EVAL-ADAU1966AZ | 制造商:Analog Devices 功能描述:EVAL BOARD FOR ADAU1962A - Boxed Product (Development Kits) |
| EVAL-ADAU1966Z | 功能描述:BOARD EVAL FOR ADAU1966 RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581 |
| EVAL-ADAU1966Z | 制造商:Analog Devices 功能描述:ADAU1966, DAC, SIGMA DELTA, SPI, I2C, EV |
發布緊急采購，3分鐘左右您將得到回復。