- 您現在的位置：買賣IC網 > PDF目錄376463 > XRT83VSH314IB (EXAR CORP) 14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT PDF資料下載
參數資料
| 型號： | XRT83VSH314IB |
| 廠商： | EXAR CORP |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | 14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| 中文描述： | DATACOM, PCM TRANSCEIVER, PBGA304 |
| 封裝： | 31 X 31 MM, 1.27 MM PITCH, PLASTIC, BGA-304 |
| 文件頁數： | 25/80頁 |
| 文件大?。?/td> | 497K |
| 代理商： | XRT83VSH314IB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
XRT83VSH314
22
REV. 1.0.1
14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT
3.2.3.1
The XRT83VSH314supports both G.775 or ETSI-300-233 RLOS detection scheme.
In G.775 mode, RLOS is declared when the received signal is less than 375mV for 32 consecutive pulse
periods (typical). The device clears RLOS when the receive signal achieves 12.5% ones density with no more
than 15 consecutive zeros in a 32 bit sliding window and the signal level exceeds 425mV (typical).
In ETSI-300-233 mode the device declares RLOS when the input level drops below 375mV (typical) for more
than 2048 pulse periods (1msec).
The device exits RLOS when the input signal exceeds 425mV (typical) and has transitions for more than 32
pulse periods with 12.5% ones density with no more than 15 consecutive zero’s in a 32 bit sliding window.
ETSI-300-233 RLOS detection method is only available in Host mode.
In T1 mode RLOS is declared when the received signal is less than 320mV for 175 consecutive pulse period
(typical). The device clears RLOS when the receive signal achieves 12.5% ones density with no more than 100
consecutive zeros in a 128 bit sliding window and the signal level exceeds 425mV (typical).
3.2.3.2
EXLOS (Extended Loss of Signal)
By enabling the extended loss of signal by programming the appropriate channel register, the digital RLOS is
extended to count 4,096 consecutive zeros before declaring RLOS in T1 and E1 mode. By default, EXLOS is
disabled and RLOS operates in normal mode.
3.2.3.3
AIS (Alarm Indication Signal)
The XRT83VSH314 adheres to the ITU-T G.775 specification for an all ones pattern. The alarm indication
signal is set to "1" if an all ones pattern (at least 99.9% ones density) is present for T, where T is 3ms to 75ms
in T1 mode. AIS will clear when the ones density is not met within the same time period T. In E1 mode, the
AIS is set to "1" if the incoming signal has 2 or less zeros in a 512-bit window. AIS will clear when the incoming
signal has 3 or more zeros in the 512-bit window.
3.2.4
FLSD (FIFO Limit Status Detection)
The purpose of the FIFO limit status is to indicate when the Read and Write FIFO pointers are within a pre-
determined range (over-flow or under-flow indication). The FLSD is set to "1" if the FIFO Read and Write
Pointers are within ±3-Bits.
3.2.4.1
LCVD (Line Code Violation Detection)
The LIU contains 14 independent, 16-bit LCV counters. When the counters reach full-scale, they remain
saturated at FFFFh until they are reset globally or on a per channel basis. For performance monitoring, the
counters can be updated globally or on a per channel basis to place the contents of the counters into holding
registers. The LIU uses an indirect address bus to access a counter for a given channel. Once the contents of
the counters have been placed in holding registers, they can be individually read out from register 0xE8h 8-bits
at a time according to the BYTEsel bit in the appropriate global register. By default, the LSB byte is in register
0xE8h until the BYTEsel is pulled "High" where upon the MSB byte will be placed in the register for read back.
Once both bytes have been read, the next channel may be selected for read back.
By default, the LCV_OFD will be set to a "1" if the receiver is currently detecting line code violations or
excessive zeros for HDB3 (E1 mode) or B8ZS (T1 mode). In AMI mode, the LCVD will be set to a "1" if the
receiver is currently detecting bipolar violations or excessive zeros. However, if the LIU is configured to
monitor the 16-bit LCV counter by programming the appropriate global register, the LCV_OFD will be set to a
"1" if the counter saturates.
RLOS (Receiver Loss of Signal)
相關PDF資料 |
PDF描述 |
|---|---|
| XRT83VSH316 | 16-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH316IB | 16-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH38 | 8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH38IB | 8-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT84L14 | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT83VSH314IB-F | 功能描述:外圍驅動器與原件 - PCI 14 Channel Short-Haul RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT83VSH314IB-SAM | 制造商:Exar Corporation 功能描述:FOR FUJITSU ONLY |
| XRT83VSH316 | 制造商:EXAR 制造商全稱:EXAR 功能描述:16-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH316_07 | 制造商:EXAR 制造商全稱:EXAR 功能描述:16-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH316ES | 功能描述:外圍驅動器與原件 - PCI 16 CH T1/E1LIUSH LOW COST VERSION RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。