- 您現在的位置：買賣IC網 > PDF目錄202135 > W29GL064CT9A (WINBOND ELECTRONICS CORP) 64M X 1 FLASH 3V PROM, 100 ns, PBGA48 PDF資料下載
參數資料
| 型號： | W29GL064CT9A |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | PROM |
| 英文描述： | 64M X 1 FLASH 3V PROM, 100 ns, PBGA48 |
| 封裝： | GREEN, VFBGA-48 |
| 文件頁數： | 10/64頁 |
| 文件大?。?/td> | 563K |
| 代理商： | W29GL064CT9A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
W29GL064C
12
7.2.15 Buffer Write Abort
Write Buffer Programming Sequence will ABORT, if the following condition takes place:
The word count minus one loaded is bigger than the page buffer size (32) during, “Number of
Locations to Program.”
Sector Address written is not the same as the one specified during the Write-Buffer-Load
instruction.
If the Address/Data set is not inside the Write Buffer Page range which was set during cycle
5’s first initial write-buffer-page select address/data set.
No “Program Confirm Instruction” after the assigned number of “data load” cycles.
After Write Buffer Abort, the status register will be DQ1=1, DQ7 = DATA# (last address loaded),
DQ6=toggle, DQ5=0. This status represents a Write Buffer Programming Operation was ABORTED. A
Write-to-Buffer-Abort Reset instruction sequence has to be written to reset the device back to the read
array mode.
DQ1 is the bit for Buffer Write Abort. When DQ1=1, the device will abort from buffer write operation
and go back to read status register shown in the following table:
Status
DQ7
DQ6
DQ5
DQ3
DQ2
DQ1
RY/#BY
Buffer Write Busy
DQ7#
Toggle
0
N/A
0
Buffer Write Abort
DQ7#
Toggle
0
N/A
1
0
Buffer Write Exceeded Time Limit
DQ7#
Toggle
1
N/A
0
Table 7-8
Polling Buffer Write Abort Flag
7.2.16 Accelerated Programming Operation
The device will enter the Accelerated Programming mode by applying high voltage (VHH) to the
#WP/ACC pin. Accelerated Programming mode allows the system to skip the normal unlock
sequences instruction and program byte/word locations directly. The current drawn from the #WP/ACC
pin during accelerated programming is no more that IACC1. Important Note: Do not exceed 10
accelerated programs per sector.
7.2.17 Automatic Select Bus Operation
There are basically two methods to access Automatic Selection Operations; Automatic Select
Instructions through software commands and High Voltage applied to A9. See Automatic Select
Instruction Sequence later on in this section for details of equivalent instruction operations that do not
require the use of VHH. The following five bus operations require A9 to be raised to VHH.
7.2.17.1
Sector Lock Status Verification
To verify the protected state of any sector using bus operations, execute a Read Operation with VHH
applied to A9, the sector address present on address pins A[22:12], address pins A6, A3, A2, and A0
held Low, and address pins A1 held High. If DQ0 is Low, the sector is considered not protected, and if
DQ0 is High, the sector is considered to be protected.
7.2.17.2
Read Silicon Manufacturer ID Code
Winbond’s 29GL family of Parallel Flash memories feature an Industry Standard compatible
Manufacturer ID code of 01h. To verify the Silicon Manufacturer ID code, execute a Read Operation
with VHH applied to the A9 pin and address pins A6, A3, A2, A1 and A0 are held Low. The ID code
can then be read on data bits DQ[7:0].
相關PDF資料 |
PDF描述 |
|---|---|
| W948D6FBHX6G | 8M X 16 DDR DRAM, 5 ns, PBGA60 |
| WF128K32-120HC5 | 512K X 8 FLASH 5V PROM MODULE, 120 ns, CHIP66 |
| WF128K32-90HM5 | 512K X 8 FLASH 5V PROM MODULE, 90 ns, CHIP66 |
| WS128K32-35CJM | 512K X 8 MULTI DEVICE SRAM MODULE, 35 ns, CQCC68 |
| WS512K32F-100G2Q | 2M X 8 MULTI DEVICE SRAM MODULE, 100 ns, QMA68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W29GL128C | 制造商:WINBOND 制造商全稱:Winbond 功能描述:128M-BIT 3.0-VOLT PARALLEL FLASH MEMORY WITH PAGE MODE |
| W29GL128CH9B | 功能描述:IC FLASH 128MBIT 90NS 64LFBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1 系列:- 格式 - 存儲器:閃存 存儲器類型:閃存 - NAND 存儲容量:4G（256M x 16） 速度:- 接口:并聯 電源電壓:2.7 V ~ 3.6 V 工作溫度:0°C ~ 70°C 封裝/外殼:48-TFSOP（0.724"，18.40mm 寬） 供應商設備封裝:48-TSOP I 包裝:Digi-Reel® 其它名稱:557-1461-6 |
| W29GL128CH9B TR | 制造商:Winbond Electronics Corp 功能描述:IC FLASH 128MBIT 90NS 64LFBGA |
| W29GL128CH9T | 功能描述:IC FLASH 128MBIT 90NS 56TSOP RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:2,500 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:1K (128 x 8) 速度:100kHz 接口:UNI/O?（單線） 電源電壓:1.8 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MSOP 包裝:帶卷 (TR) |
| W29GL128CH9T TR | 制造商:Winbond Electronics Corp 功能描述:IC FLASH 128MBIT 90NS 56TSOP |
發布緊急采購，3分鐘左右您將得到回復。