- 您現在的位置：買賣IC網 > PDF目錄383949 > TL16C554AI (Texas Instruments, Inc.) ASYNCHRONOUS-COMMUNICATIONS ELEMENT PDF資料下載
參數資料
| 型號： | TL16C554AI |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | ASYNCHRONOUS-COMMUNICATIONS ELEMENT |
| 中文描述： | 異步通信元 |
| 文件頁數： | 23/40頁 |
| 文件大?。?/td> | 605K |
| 代理商： | TL16C554AI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
TL16C554A, TL16C554AI
ASYNCHRONOUS-COMMUNICATIONS ELEMENT
SLLS509A
–
AUGUST 2001
–
REVISED JULY 2003
23
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION
interrupt-identification register (IIR) (continued)
Bit 0: IIR0 indicates whether an interrupt is pending. When IIR0 is cleared, an interrupt is pending.
Bits 1 and 2: IIR1 and IIR2 identify the highest priority interrupt pending as indicated in Table 5.
Bit 3: IIR3 is always cleared in the TL16C450 mode. This bit, along with bit 2, is set when in the FIFO mode
and a character time-out interrupt is pending.
Bits 4 and 5: IIR4 and IIR5 are always cleared.
Bits 6 and 7: IIR6 and IIR7 are set when FCR0 = 1.
line-control register (LCR)
The format of the data character is controlled by LCR. LCR may be read. Its contents are described in the
following bulleted list and shown in Figure 18.
Bits 0 and 1: LCR0 and LCR1 are word-length select bits. These bits program the number of bits in each
serial character and are shown in Figure 18.
Bit 2: LCR2 is the stop-bit select bit. This bit specifies the number of stop bits in each transmitted character.
The receiver always checks for one stop bit.
Bit 3: LCR3 is the parity-enable bit. When LCR3 is set, a parity bit between the last data word bit and the
stop bit is generated and checked.
Bit 4: LCR4 is the even-parity select bit. When this bit is set and parity is enabled (LCR3 is set), even parity
is selected. When this bit is cleared and parity is enabled, odd parity is selected.
Bit 5: LCR5 is the stick-parity bit. When parity is enabled (LCR3 is set) and this bit is set, the transmission
and reception of a parity bit is placed in the opposite state from the value of LCR4. This forces parity to a
known state and allows the receiver to check the parity bit in a known state.
Bit 6: LCR6 is a break-control bit. When this bit is set, the serial outputs TXx are forced to the spacing state
(low). The break-control bit acts only on the serial output and does not affect the transmitter logic. If the
following sequence is used, no invalid characters are transmitted because of the break.
Step 1.
Load a zero byte in response to the transmitter holding register empty (THRE) status indicator.
Step 2.
Set the break in response to the next THRE status indicator.
Step 3.
Wait for the transmitter to be idle when transmitter empty status signal is set (TEMT = 1); then
clear the break when the normal transmission has to be restored.
Bit 7: LCR7 is the divisor-latch access bit (DLAB) bit. This bit must be set to access the divisor latches DLL
and DLM of the baud-rate generator during a read or write operation. LCR7 must be cleared to access the
receiver-buffer register, the transmitter-holding register, or the interrupt-enable register.
相關PDF資料 |
PDF描述 |
|---|---|
| TL16C554I | ASYNCHRONOUS COMMUNICATIONS ELEMENT |
| TL2575-15I | 1-A SIMPLE STEP-DOWN SWITCHING VOLTAGE REGULATORS |
| TL2575-33I | 1-A SIMPLE STEP-DOWN SWITCHING VOLTAGE REGULATORS |
| TL2575_0701 | 1-A SIMPLE STEP-DOWN SWITCHING VOLTAGE REGULATORS |
| TL3414AIPE4 | DUAL HIGH OUTPUT CURRENT OPERATIONAL AMPLIFIER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TL16C554AIFN | 功能描述:UART 接口集成電路 Quad UART w/ 16-Byte FIFOs RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| TL16C554AIFNR | 功能描述:UART 接口集成電路 Quad UART w/ 16-Byte FIFOs RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| TL16C554AIPN | 功能描述:UART 接口集成電路 Quad UART with 16-Byte FIFOs RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| TL16C554AIPNG4 | 功能描述:UART 接口集成電路 Quad UART with 16-Byte FIFOs RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| TL16C554AIPNR | 功能描述:UART 接口集成電路 Quad UART with 16-Byte FIFOs RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。