- 您現在的位置：買賣IC網 > PDF目錄192316 > SCANPSC110FSCX (FAIRCHILD SEMICONDUCTOR CORP) PDF資料下載
參數資料
| 型號： | SCANPSC110FSCX |
| 廠商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分類： | 微控制器/微處理器 |
| 中文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, PDSO28 |
| 封裝： | 0.300 INCH, MS-013, SOIC-28 |
| 文件頁數： | 8/25頁 |
| 文件大?。?/td> | 269K |
| 代理商： | SCANPSC110FSCX |
www.fairchildsemi.com
16
SCAN
PSC1
10
F
Special Features (Continued)
This moves the local chain TAP Controllers to the synchro-
nization state (Run-Test/Idle), where they stay until syn-
chronization occurs. If the next state of the SCANPSC110F
TAP Controller is Run-Test/Idle, TMSL is connected to
TMSB and the local TAP Controllers are synchronized to
the SCANPSC110F TAP Controller as shown in Figure 12.
If the next state after Update-IR were Select-DR, TMSL
would remain LOW and synchronization would not occur
until the SCANPSC110F TAP Controller entered the Run-
Test/Idle state, as shown in Figure 11.
Each local port has its own Local Scan Port Controller. This
is necessary because the LSPN can be configured in any
one of eight (8) possible combinations. Either one, some,
or all of the local ports can be accessed simultaneously.
Configuring the LSPN is accomplished with the mode reg-
ister, in conjunction with the UNPARK instruction.
The LSPN can be unparked in one of seven different con-
figurations, as specified by bits 0-2 of the mode register.
Using multiple ports presents not only the task of synchro-
nizing the SCANPSC110F TAP Controller with the TAP
Controllers of an individual local port, but also of synchro-
nizing the individual local ports to one another.
When multiple local ports are selected for access, it is pos-
sible that two ports are parked in different states. This
could occur when previous operations accessed the two
ports separately and parked them in the two different
states. The LSP Controllers handle this situation gracefully.
Figure 12 shows the UNPARK instruction being used to
access LSP1, LSP2, and LSP3 in series (mode register =
“XXX0X111” binary). LSP1 and LSP2 become active as the
SCANPSC110F controller is sequenced through the Run-
Test/Idle state. LSP3 remains parked in the Pause-DR
state until the SCANPSC110F TAP Controller is sequenced
through the Pause-DR state. At that point, all three local
ports are synchronized for access via the active scan
chain.
FIGURE 12. Synchronization of the Three Local Scan Ports (LSP1, LSP2, and LSP3)
相關PDF資料 |
PDF描述 |
|---|---|
| SCBA15FF | 5 A, SILICON, BRIDGE RECTIFIER DIODE |
| SCBC21WA4S0000G | 21 CONTACT(S), FEMALE, D SUBMINIATURE CONNECTOR, CRIMP |
| SCBM5W1M/F | 5-5 CONTACT(S), PANEL MOUNT, MALE-FEMALE, RECTANGULAR ADAPTER |
| SCBM5W5M/F | 5-5 CONTACT(S), PANEL MOUNT, MALE-FEMALE, RECTANGULAR ADAPTER |
| SCBM7W2M/F | 7-7 CONTACT(S), PANEL MOUNT, MALE-FEMALE, RECTANGULAR ADAPTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SCANSTA101 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage IEEE 1149.1 STA Master |
| SCANSTA101_06 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low Voltage IEEE 1149.1 STA Master |
| SCANSTA101SM | 功能描述:接口 - 專用 RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| SCANSTA101SM/NOPB | 功能描述:接口 - 專用 Low Vltg IEEE 1149.1 Sys Test Access RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| SCANSTA101SM/NOPB | 制造商:Texas Instruments 功能描述:Test Master IC |
發布緊急采購，3分鐘左右您將得到回復。