- 您現在的位置：買賣IC網 > PDF目錄192316 > SCANPSC100FSCX (FAIRCHILD SEMICONDUCTOR CORP) PDF資料下載
參數資料
| 型號： | SCANPSC100FSCX |
| 廠商： | FAIRCHILD SEMICONDUCTOR CORP |
| 元件分類： | 微控制器/微處理器 |
| 中文描述： | SPECIALTY MICROPROCESSOR CIRCUIT, PDSO28 |
| 封裝： | 0.300 INCH, MS-013, SOIC-28 |
| 文件頁數： | 19/21頁 |
| 文件大?。?/td> | 208K |
| 代理商： | SCANPSC100FSCX |
7
www.fairchildsemi.com
SCANPSC100F
Parallel Processor Interface (PPI) (Continued)
TIMING WAVEFORMS (Continued)
FIGURE 4. Consecutive Read/Writes (best case timing)
FIGURE 5. Consecutive Read/Writes (worst case timing)
Note 3: Figures 4, 5: Figure 4 shows the best case bus cycle timing for SCK and STB during consecutive read or write cycles. The rising edge of strobe
occurs a setup time, tS4 or before the falling edge of SCK. This allows the cycle to be completed within 1.5 clock SCK clock cycles. Figure 5 shows the worst
case bus cycle timing for SCK and STB during consecutive read or write cycles. The rising edge of strobe does not meet the tS4 requirement between STB
and SCK. Therefore, the propagation of the internal PSC100 control and reset signals is delayed until the next falling edge of SCK. The bus cycle is then
completed 1.5 SCK cycles later creating a total bus cycle time of 2.5 SCK cycles. If worst case timing is considered for bus cycle timing, tS4 is not a manda-
tory timing specification.
FIGURE 6. Read/Write or Write/Read (best case timing)
FIGURE 7. Read/Write or Write/Read (worst case timing)
Note 4: Figures 6, 7: This diagram shows the timing for a read followed by a write (or write followed by a read). Separate Read and Write data/address
latches and control logic allow consecutive read/write or write/read operations to be overlapped (i.e., do not need to wait 2 or 3 SCK cycles between bus
cycles). For the best case timing scenario (Figure 6: rising edge of STB to falling edge of SCK greater than tS4), a new bus cycle can be performed each SCK
cycle. For the worst timing scenario (Figure 7: rising edge of STB to falling edge of SCK is less than tS4), a one SCK cycle delay must be included after each
back to back read/write or write/read sequence.
Note 5: Figures 4, 5, 6, 7 assume that the PSC100 register participating in the bus cycle is ready to accept/provide data. For bus cycles involving a PSC100
shifter/buffer(s), the ready status of a shifter/buffer can be checked using the status bits in Mode Register 2 prior to the start of the bus cycle. Polling is
required when the RDY pin is not used to provide a processor “handshake”.
相關PDF資料 |
PDF描述 |
|---|---|
| SCANPSC110FSCX | |
| SCBA15FF | 5 A, SILICON, BRIDGE RECTIFIER DIODE |
| SCBC21WA4S0000G | 21 CONTACT(S), FEMALE, D SUBMINIATURE CONNECTOR, CRIMP |
| SCBM5W1M/F | 5-5 CONTACT(S), PANEL MOUNT, MALE-FEMALE, RECTANGULAR ADAPTER |
| SCBM5W5M/F | 5-5 CONTACT(S), PANEL MOUNT, MALE-FEMALE, RECTANGULAR ADAPTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SCANPSC110 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) |
| SCANPSC110_ZFC3026B WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| SCANPSC110F | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) |
| SCANPSC110FDMQB | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support) |
| SCANPSC110FDMQB WAF | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。