- 您現在的位置：買賣IC網 > PDF目錄368023 > PIC12C67X (Microchip Technology Inc.) 8-Pin, 8-Bit CMOS Microcontroller with A/D Converter and EEPROM Data Memory PDF資料下載
參數資料
| 型號： | PIC12C67X |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | 8-Pin, 8-Bit CMOS Microcontroller with A/D Converter and EEPROM Data Memory |
| 中文描述： | 8引腳，8位CMOS微控制器與A / D轉換器和EEPROM數據存儲器 |
| 文件頁數： | 58/129頁 |
| 文件大?。?/td> | 931K |
| 代理商： | PIC12C67X |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁當前第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁
PIC12C67X
DS30561B-page 58
1999 Microchip Technology Inc.
9.4
Power-on Reset (POR), Power-up
Timer (PWRT) and Oscillator Start-up
Timer (OST)
9.4.1
POWER-ON RESET (POR)
The on-chip POR circuit holds the chip in reset until
V
DD
has reached a high enough level for proper opera-
tion. To take advantage of the POR, just tie the MCLR
pin through a resistor to V
DD
. This will eliminate exter-
nal RC components usually needed to create a Power-
on Reset. A maximum rise time for V
DD
is specified.
See Electrical Specifications for details.
When the device starts normal operation (exits the
reset condition), device operating parameters (voltage,
frequency, temperature, ...) must be met to ensure
operation. If these conditions are not met, the device
must be held in reset until the operating conditions are
met.
For additional information, refer to Application Note
AN607, "Power-up Trouble Shooting"
9.4.2
POWER-UP TIMER (PWRT)
The Power-up Timer provides a fixed 72 ms nominal
time-out on power-up only, from the POR. The Power-
up Timer operates on an internal RC oscillator. The
chip is kept in reset as long as the PWRT is active. The
PWRT’s time delay allows V
DD
to rise to an acceptable
level. A configuration bit is provided to enable/disable
the PWRT.
The power-up time delay will vary from chip to chip due
to V
DD
, temperature and process variation. See
Table 11-4.
9.4.3
OSCILLATOR START-UP TIMER (OST)
The Oscillator Start-up Timer (OST) provides 1024
oscillator cycle (from OSC1 input) delay after the
PWRT delay is over. This ensures that the crystal oscil-
lator or resonator has started and stabilized.
The OST time-out is invoked only for XT, LP and HS
modes and only on Power-on Reset or wake-up from
SLEEP.
9.4.4
TIME-OUT SEQUENCE
On power-up, the Time-out Sequence is as follows:
first, PWRT time-out is invoked after the POR time
delay has expired; then, OST is activated. The total
time-out will vary, based on oscillator configuration and
the status of the PWRT. For example, in RC mode with
the PWRT disabled, there will be no time-out at all.
Figure 9-7, Figure 9-8, and Figure 9-9 depict time-out
sequences on power-up.
Since the time-outs occur from the POR pulse, if MCLR
is kept low long enough, the time-outs will expire. Then
bringing MCLR high will begin execution immediately
(Figure 9-9). This is useful for testing purposes or to
synchronize more than one PIC12C67X device operat-
ing in parallel.
9.4.5
POWER CONTROL (PCON)/STATUS
REGISTER
The Power Control/Status Register, PCON (address
8Eh), has one bit. See Register 4-6 for register.
Bit1 is POR (Power-on Reset). It is cleared on a Power-
on Reset and is unaffected otherwise. The user sets
this bit following a Power-on Reset. On subsequent
resets, if POR is ‘0’, it will indicate that a Power-on
Reset must have occurred.
TABLE 9-4:
Oscillator Configuration
TIME-OUT IN VARIOUS SITUATIONS
TABLE 9-5:
POR
STATUS/PCON BITS AND THEIR SIGNIFICANCE
PD
Power-on Reset
x
Illegal, TO is set on POR
0
Illegal, PD is set on POR
u
WDT Reset
0
WDT Wake-up
u
MCLR Reset during normal operation
0
MCLR Reset during SLEEP or interrupt wake-up from SLEEP
Legend:
u
= unchanged,
x
= unknown.
Power-up
Wake-up from SLEEP
PWRTE = 0
72 ms + 1024T
OSC
72 ms
PWRTE = 1
1024T
OSC
—
XT, HS, LP
INTRC, EXTRC
1024T
OSC
—
TO
0
0
0
1
1
1
1
1
0
x
0
0
u
1
1
相關PDF資料 |
PDF描述 |
|---|---|
| pic12ce674 | 8-Pin, 8-Bit CMOS Microcontroller with A/D Converter(具A/D轉換器和EEPROM數據存儲器的8位微控制器) |
| PIC12CR509A | 8-Pin, 8-Bit CMOS Microcontrollers |
| PIC12F505 | 8/14-Pin, 8-Bit Flash Microcontrollers |
| PIC12F506 | 8/14-Pin, 8-Bit Flash Microcontroller |
| PIC12F510_07 | 8/14-Pin, 8-Bit Flash Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PIC12C67X_13 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontroller with A/D Converter and EEPROM Data Memory |
| PIC12CE-04/EJW | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers |
| PIC12CE-04/EP | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers |
| PIC12CE-04/ESM | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers |
| PIC12CE-04/ESN | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:8-Pin, 8-Bit CMOS Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。