- 您現在的位置：買賣IC網 > PDF目錄367625 > MFRC53001T (NXP Semiconductors N.V.) ISO-IEC 14443 A Reader IC PDF資料下載
參數資料
| 型號： | MFRC53001T |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 通信及網絡 |
| 英文描述： | ISO-IEC 14443 A Reader IC |
| 封裝： | MFRC53001T/0FE<SOT287-1 (SO32)|<<http://www.nxp.com/packages/SOT287-1.html<1<week 5, 2005,;MFRC53001T/0FE<SOT287-1 (SO32)|<<http://www.nxp.com/packages/SOT287-1.html<1 |
| 文件頁數： | 27/115頁 |
| 文件大小： | 2590K |
| 代理商： | MFRC53001T |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
MFRC530_33
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
PUBLIC
Rev. 3.3 — 6 July 2010
057433
27 of 115
NXP Semiconductors
MFRC530
ISO/IEC 14443 A Reader IC
9.7.3
Initialization phase
The initialization phase automatically follows the reset phase and takes 128 clock cycles.
During the initializing phase the content of the EEPROM blocks 1 and 2 is copied into the
register subaddresses 10h to 2Fh (see
Section 9.2.2 on page 13
).
Remark:
During the production test, the MFRC530 is initialized with default configuration
values. This reduces the microprocessor’s configuration time to a minimum.
9.7.4
Initializing the parallel interface type
A different initialization sequence is used for each microprocessor. This enables detection
of the correct microprocessor interface type and synchronization of the microprocessor’s
and the MFRC530’s start-up. See
Section 9.1.3 on page 8
for detailed information on the
different connections for each microprocessor interface type.
During StartUp phase, the command value is set to 3Fh once the oscillator attains clock
frequency stability at an amplitude of > 90 % of the nominal 13.56 MHz clock frequency. At
the end of the initialization phase, the MFRC530 automatically switches to idle and the
command value changes to 00h.
To ensure correct detection of the microprocessor interface, the following sequence is
executed:
the Command register is read until the 6-bit register value is 00h. On reading the 00h
value, the internal initialization phase is complete and the MFRC530 is ready to be
controlled
write 80h to the Page register to initialize the microprocessor interface
read the Command register. If it returns a value of 00h, the microprocessor interface
was successfully initialized
write 00h to the Page registers to activate linear addressing mode.
9.8 Oscillator circuit
The clock applied to the MFRC530 acts as a time basis for the synchronous system
encoder and decoder. The stability of the clock frequency is an important factor for correct
operation. To obtain highest performance, clock jitter must be as small as possible. This is
best achieved by using the internal oscillator buffer with the recommended circuitry.
Fig 10. Quartz clock connection
001aak614
13.56 MHz
15 pF
15 pF
OSCOUT
OSCIN
DEVICE
相關PDF資料 |
PDF描述 |
|---|---|
| MFRC53101T | ISO-IEC 14443 reader IC |
| MFRX85201HD | Secure contactless reader solution |
| MMBD4148 | High-speed switching diode |
| MMBD6050-V-GS08 | SWITING 70V 0.2A 3PIN SOT-23 - Tape and Reel |
| MMBD6050-V-GS18 | SWITING 70V 0.2A 3PIN SOT-23 - Tape and Reel |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MFRC53001T/0FE | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:ISO/IEC 14443 A Reader IC |
| MFRC53001T/0FE,112 | 功能描述:RFID應答器 MIFARE HS READER RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| MFRC53001T/0FE,518 | 功能描述:RFID應答器 IC READER 13.56MHZ RoHS:否 制造商:Murata 存儲容量:512 bit 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| MFRC53001T/0FE112 | 制造商:NXP Semiconductors 功能描述:CNTCLESS RC 3.3V ISO14443-A/B |
| MFRC531 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Short Form Specification |
發布緊急采購，3分鐘左右您將得到回復。