參數資料
型號： MC68HC05BD7P
廠商： MOTOROLA INC
元件分類： 微控制器/微處理器
英文描述： 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP40
封裝： DIP-40
文件頁數： 49/85頁
文件大?。?/td> 302K
代理商： MC68HC05BD7P
SECTION 9: DDC12AB INTERFACE
MOTOROLA
Page 43
MC68HC05BD7 Rev. 2.0
GENERAL RELEASE SPECIFICATION
PRELIMINARY
9.3.4
DDC Status Register (DSR)
This status register is readable only. All bits are cleared upon reset except bit 3 (RXAK) and
bit 1 (TXBE).
RXIF
Bit 7
The data Receive Interrupt Flag (RXIF) is set after the DDRR
is loaded with a newly received data. Once the DDRR is
loaded with received data, no more received data can be
loaded to the DDRR register. The only way to release the
DDRR register for loading next received data is that software
reads the data from the DDRR register to clear RXBF flag.
This bit is cleared by writing ’0’ to it or when the DEN is
disabled.
TXIF
Bit 6
The data Transmit Interrupt Flag is set before the data of the
DDTR register is downloaded to the shift register. It is
software’s responsibility to fill the DDTR register with new
data when this bit is set. This bit is cleared by writing ’0’ to it
or when the DEN is disabled.
MATCH
Bit 5
The MATCH flag is set when the received data in the DDRR
register is an calling address which matches with the address
or its extended addresses (EXTAD=1) specified in the DADR
register.
SRW
Bit 4
The Slave RW bit will indicate the data direction of DDC
protocol. It is updated after the calling address is received in
the DDC2 protocol. When it is one, the master will read the
data from DDC module, so the module is in transmit mode.
When it is zero, the master will send data to the DDC module,
the module is in receive mode. When DDC1EN is set, the
SRW bit will be one. The reset state of it is zero.
RXAK
Bit 3
If the received acknowledge bit (RXAK) is low, it indicates an
acknowledge signal has been received after the completion of
8 data bits transmission on the bus. If RXAK is high, it
indicates no acknowledge signal has been detected at the 9th
clock. Then the module will release the SDA line for the
master to generate ’stop’ or ’repeated start’ condition. It is set
upon reset.
SCLIF
Bit 2
This SCLIF flag is set by the falling edge of SCL line only
when DDC1EN is enabled. This bit is cleared by writing zero
to it, clearing DDC1EN bit or when the DEN is disable.
0
7
TXBE
0001010
6543210
RXBF
W
R
DSR
$0019
reset
SCLIF
MATCH
RXAK
SRW
TXIF
RXIF
相關PDF資料
PDF描述
MC68HC705BD7B 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP42
MC68HC05C0B 8-BIT, 4 MHz, MICROCONTROLLER, PDIP42
MC68HC05C0P 8-BIT, 4 MHz, MICROCONTROLLER, PDIP40
MC68HC05C0FN 8-BIT, 4 MHz, MICROCONTROLLER, PQCC44
MC68HC05C12AFN 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44
相關代理商/技術參數
參數描述
MC68HC05C0CP 制造商:Motorola Inc 功能描述:
MC68HC05C12 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
MC68HC05C12B 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
MC68HC05C12CP 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
MC68HC05C12P 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*