- 您現在的位置：買賣IC網 > PDF目錄45022 > M306H3MC-XXXFP 16-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP116 PDF資料下載
參數資料
| 型號： | M306H3MC-XXXFP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, MROM, 10 MHz, MICROCONTROLLER, PQFP116 |
| 封裝： | 20 X 20 MM, 0.65 MM PITCH, PLASTIC, LQFP-116 |
| 文件頁數： | 120/135頁 |
| 文件大?。?/td> | 2583K |
| 代理商： | M306H3MC-XXXFP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁當前第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁
Rev.1.00
2004.03.23
page 85 of 320
M306H3MC-XXXFP/FCFP
2.9.3 DMA Enable
When a data transfer starts after setting the DMAE bit in DMiCON register (i = 0, 1) to “1” (enabled), the
DMAC operates as follows:
(1) Reload the forward address pointer with the SARi register value when the DSD bit in DMiCON register
is “1” (forward) or the DARi register value when the DAD bit of DMiCON register is “1” (forward).
(2) Reload the DMAi transfer counter with the DMAi transfer counter reload register value.
If the DMAE bit is set to “1” again while it remains set, the DMAC performs the above operation. However,
if a DMA request may occur simultaneously when the DMAE bit is being written, follow the steps below.
Step 1: Write “1” to the DMAE bit and DMAS bit in DMiCON register simultaneously.
Step 2: Make sure that the DMAi is in an initial state as described above (1) and (2) in a program.
If the DMAi is not in an initial state, the above steps should be repeated.
2.9.4 DMA Request
The DMAC can generate a DMA request as triggered by the cause of request that is selected with the
DMS and DSEL3 to DSEL0 bits of DMiSL register (i = 0, 1) on either channel. Table 2.9.4 shows the
timing at which the DMAS bit changes state.
Whenever a DMA request is generated, the DMAS bit is set to “1” (DMA requested) regardless of whether
or not the DMAE bit is set. If the DMAE bit was set to “1” (enabled) when this occurred, the DMAS bit is
set to “0” (DMA not requested) immediately before a data transfer starts. This bit cannot be set to “1” in
a program (it can only be set to “0”).
The DMAS bit may be set to “1” when the DMS or the DSEL3 to DSEL0 bits change state. Therefore,
always be sure to set the DMAS bit to “0” after changing the DMS or the DSEL3 to DSEL0 bits.
Because if the DMAE bit is “1”, a data transfer starts immediately after a DMA request is generated, the
DMAS bit in almost all cases is “0” when read in a program. Read the DMAE bit to determine whether the
DMAC is enabled.
Table 2.9.4. Timing at Which the DMAS Bit Changes State
DMA factor
Software trigger
Peripheral function
Timing at which the bit is set to “1”
Timing at which the bit is set to “0”
DMAS bit of the DMiCON register
When the DSR bit of DMiSL
register is set to “1”
When the interrupt control register
for the peripheral function that is
selected by the DSEL3 to DSEL0
and DMS bits of DMiSL register
has its IR bit set to “1”
Immediately before a data transfer starts
When set by writing “0” in a program
相關PDF資料 |
PDF描述 |
|---|---|
| M306H3FCFP | 16-BIT, FLASH, 10 MHz, MICROCONTROLLER, PQFP116 |
| M306H5MG-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP116 |
| M306H5MG-XXXFP | 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP116 |
| M306H5FGFP | 16-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP116 |
| M306N4FGVFP | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M306H5FGFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
| M306H5FGFP#U0 | 功能描述:IC M16C/6H MCU FLASH 116LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:M16C™ M16C/60 標準包裝:160 系列:S08 核心處理器:S08 芯體尺寸:8-位 速度:40MHz 連通性:I²C，LIN，SCI，SPI 外圍設備:LCD，LVD，POR，PWM，WDT 輸入/輸出數:53 程序存儲器容量:32KB（32K x 8） 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1.9K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 12x12b 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:64-LQFP 包裝:托盤 |
| M306H5MC-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
| M306H5MG-XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SNGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
| M306H7FGFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with DATA ACQUISITION CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。