參數資料
型號： JTSX8388B-1V1B
英文描述： A/D CONVERTER
中文描述： 的A / D轉換器
文件頁數： 30/45頁
文件大?。?/td> 1597K
代理商： JTSX8388B-1V1B
30
JTS8388B
Product Specification
This is true so long as the out of phase analog input pin VINB is 50 ohms terminated very closely to one of the neighboring shield ground pins (33
35 37) which constitute the local ground reference for the inphase analog input pin (VIN).
Thus the differential analog input preamplifier will fully reject the local ground noise ( and any capacitively and inductively coupled noise) as common
mode effects.
In typical single–ended configuration, enter on the (VIN) input pin, with the inverted phase input pin (VINB) grounded through the 50 ohms
termination resistor.
In single–ended input configuration, the in-phase input amplitude is 0.5 Volt peak to peak,centered on 0V. (or -2 dBm into 50 ohms.)
The inverted phase input is at ground potential through the 50 ohms termination resistor.
However, dynamic performances can be somewhat improved by entering either analog or clock inputs in differential mode.
Typical Single ended analog input configuration
VIN or VINB
VIN or VINB double pad 34, 36
50
(external)
50
reverse termination
1M
3 pF
-250
250
[mV]
500 mV
500 mV
Full Scale
analog input
t
VINB
VIN
VINB = 0V
V
IN
= +/- 250 mV
500 mV diff
7.4.
CLOCK INPUTS (CLK) (CLKB)
The JTS8388B can be clocked at full speed without noticeable performance degradation in either differential or single ended configuration.
This is explained by the fact the ADC uses a differential preamplifier stage for the clock buffer, which has been designed in order to be entered either
in differential or single–ended mode.
7.4.1.
SINGLE ENDED CLOCK INPUT (G
ROUND
C
OMMON
M
ODE
)
Although the clock inputs were intended to be driven differentially with nominal -0.8V / -1.8V ECL levels, the JTS8388B clock buffer can manage a
single–ended sinewave clock signal centered around 0 Volt. This is the most convenient clock input configuration as it does not require the use of a
power splitter.
No performance degradation ( e.g. : due to timing jitter) is observed in this particular single–ended configuration up to 1.2GSPS Nyquist conditions (
Fin = 600 MHz ).
This is true so long as the inverted phase clock input pin is 50 ohms terminated very closely to one of the neighbouring shield ground pin, which
constitutes the local Ground reference for the inphase clock input.
Thus the JTS8388B differential clock input buffer will fully reject the local ground noise ( and any capacitively and inductively coupled noise) as
common mode effects.
Moreover, a very low phase noise sinewave generator must be used for enhanced jitter performance.
The typical inphase clock input amplitude is 1 Volt peak to peak, centered on 0 Volt (ground) common mode.
This corresponds to a typical clock input power level of 4 dBm into the 50 ohms termination resistor.
Do not exceed 10 dBm to avoid saturation of the preamplifier input transistors.
The inverted phase clock input is grounded through the 50 ohms termination resistor.
相關PDF資料
PDF描述
JUCA4532 Optoelectronic
JV1-100V
JV1-12V
JV1-18V
JV1-24V
相關代理商/技術參數
參數描述
JTV1AF-PA-12V 功能描述:通用繼電器 1 Form A 12V Relay 6kv Type RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
JTV1AF-PA-15V 功能描述:通用繼電器 1 FORM A 15V Relay 6kv Type RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
JTV1AF-PA-18V 功能描述:通用繼電器 1 FORM A 18V Relay 6kv Type RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
JTV1AF-PA-24V 功能描述:通用繼電器 1 FORM A 24V Relay 6kv Type RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
JTV1AF-PA-48V 功能描述:通用繼電器 1 FORM A 48V Relay 6kv Type RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*