參數資料
型號: FDC37C665IR
廠商: SMSC Corporation
英文描述: 3/5 Volt Advanced High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controller with Infranred Support
中文描述: 3 / 5伏先進的高性能多模并口超級I / O軟盤與Infranred支持磁盤控制器
文件頁數: 73/162頁
文件大?。?/td> 562K
代理商: FDC37C665IR
73
PARALLEL PORT FLOPPY DISK CONTROLLER
In this mode, the Floppy Disk Control signals
are available on the parallel port pins. When
this mode is selected, the parallel port is not
available. There are two modes of operation,
PPFD1 and PPFD2. These modes can be
selected in Configuration Register 4. PPFD1
has only drive 1 on the parallel port pins; PPFD2
has drive 0 and 1 on the parallel port pins.
PPFD1:
Drive 1 is on the Parallel port pins
Drive 2 is on the FDC pins*
Drive 3 is on the FDC pins*
Drive 0 is on the FDC pins
PPFD2:
Drive 0 is on the Parallel port
pins
Drive 1 is on the Parallel port pins
Drive 2 is on the FDC pins*
Drive 3 is on the FDC pins*
* If ECP is selected, then direct support for
drives 2 and 3 is not available. Drives 2 and 3
are available using external decoders.
When the PPFDC is selected the following pins
are set as follows:
1.
nDS2/PDIR (pin 98): not ECP = high-Z,
ECP = high
A10/nDS3 (pin 97): high-Z, A10 = to
internal logic.
nMTR2/nPDACK (pin 96): high-Z
2.
3.
4.
nMTR3/PDRQ (pin 99): not ECP = high-Z,
ECP & dmaEn = 0, ECP & not dmaEn =
high-Z
PINTR: not active, this is hi-Z or Low
depending on settings.
5.
The following parallel port pins are read as
follows by a read of the parallel port register:
1.
Data Register (read) = last Data Register
(write)
Control Register are read as "cable not
connected" STROBE, AUTOFD and SLC =
0 and nINIT = 1;
Status Register reads: nBUSY = 0, PE = 0,
SLCT = 0, nACK = 1, nERR = 1.
2.
3.
The following FDC pins are all in the high
impedence state when the PPFDC is actually
selected by the drive select register:
1.
nWDATA, DENSEL, nHDSEL, nWGATE,
nDIR, nSTEP, nDS1, nDS0, nMTRO,
nMTR1.
2.
If PPFDx is selected, then the parallel port
can not be used as a parallel port until
"Normal" mode is selected.
The FDC signals are muxed onto the Parallel
Port pins as shown in Table 32.
相關PDF資料
PDF描述
FDC37C665GT High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controllers
FDC37C666GT High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controllers
FDC37C67X ENHANCED SUPER I/O CONTROLLER WITH FAST IR
FDC37C957FR ULTRA I/O CONTROLLER FOR PORTABLE APPLICATIONS
FDC37M600 ENHANCED SUPER I/O CONTROLLER WITH INFRARED SUPPORT
相關代理商/技術參數
參數描述
FDC37C665IRQFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMSC 功能描述:
FDC37C666GT 制造商:SMSC 制造商全稱:SMSC 功能描述:High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controllers
FDC37C669 制造商:SMSC 制造商全稱:SMSC 功能描述:PC 98/99 Compliant Super I/O Floppy Disk Controller with Infrared Support
FDC37C669_07 制造商:SMSC 制造商全稱:SMSC 功能描述:PC 98/99 Compliant Super I/O Floppy Disk Controller with Infrared Support
FDC37C669FRQFP 制造商:Rochester Electronics LLC 功能描述:- Bulk