參數資料
型號: CDB5534U
廠商: Cirrus Logic Inc
文件頁數: 33/43頁
文件大小: 0K
描述: EVAL BOARD FOR CS5534
標準包裝: 1
ADC 的數量: 1
位數: 24
采樣率(每秒): 3.84k
數據接口: 串行
輸入范圍: 0 ~ 2.5 V
在以下條件下的電源(標準): 35mW @ 5V
工作溫度: -40°C ~ 85°C
已用 IC / 零件: CS5534
已供物品: 板,纜線,CD
相關產品: CS5534-BSZR-ND - IC ADC 24BIT 4CH W/LNA 24SSOP
CS5534-ASZR-ND - IC ADC 24BIT 4CH W/LNA 24-SSOP
598-1116-5-ND - IC ADC 24BIT 4CH W/LNA 24SSOP
598-1115-5-ND - IC ADC 24BIT 4CH W/LNA 20SSOP
其它名稱: 598-1016
CS5531/32/33/34-AS
DS289F5
39
2.10. Clock Generator
The CS5531/32/33/34 include an on-chip inverting
amplifier which can be connected with an external
crystal to provide the master clock for the chip. Fig-
ure 20 illustrates the on-chip oscillator. It includes
loading capacitors and a feedback resistor to form
a Pierce oscillator configuration. The chips are de-
signed to operate using a 4.9152 MHz crystal;
however, other crystals with frequencies between
1 MHz to 5 MHz can be used. One lead of the crys-
tal should be connected to OSC1 and the other to
OSC2. Lead lengths should be minimized to reduce
stray capacitance. Note that while using the on-chip
oscillator, neither OSC1 or OSC2 is capable of di-
rectly driving any off-chip logic. When the on-chip
oscillator is used, the voltage on OSC2 is typically
0.5 V peak-to-peak. This signal is not compatible
with external logic unless additional external cir-
cuitry is added. The OSC2 output should be used if
the on-chip oscillator output is used to drive other
circuitry.
The designer can use an external CMOS-compati-
ble oscillator to drive OSC2 with a 1 MHz to
5 MHz clock for the ADC. The external clock into
OSC2 must overdrive the 60
A output of the on-
chip amplifier. This will not harm the on-chip cir-
cuitry. In this scheme, OSC1 should be left uncon-
nected.
2.11. Power Supply Arrangements
The CS5531/32/33/34 are designed to operate from
single or dual analog supplies and a single digital
supply. The following power supply connections
are possible:
VA+ = +5V; VA- = 0V; VD+ = +3V to +5V
VA+ = +2.5V; VA- = -2.5V; VD+ = +3V to +5V
VA+ = +3V; VA- = -3V; VD+ = +3V
A VA+ supply of +2.5 V, +3.0 V, or +5.0 V should
be maintained at ±5% tolerance. A VA- supply of
-2.5 V or -3.0 V should be maintained at ±5% tol-
erance. VD+ can extend from +2.7 V to +5.5 V
with the additional restriction that:
[(VD+) - (VA-)] < 7.5 V.
Figure 21 illustrates the CS5532 connected with a
single +5.0 V supply to measure differential inputs
relative to a common mode of 2.5 V. Figure 22 il-
lustrates the CS5532 connected with ±2.5 V bipo-
lar analog supplies and a +3 V to +5 V digital
supply to measure ground referenced bipolar sig-
nals. Figures 23 and 24 illustrate the CS5532 con-
nected with ±3 V analog supplies and a +3 V
digital supply to measure ground-referenced bipo-
lar signals.
Figure 25 illustrates alternate bridge configurations
which can be measured with the converter. Voltage
V1 can be measured with the PGIA gain set to 1x
as the input amplifier on this gain setting can go
rail-to-rail. Voltage V2 should be measured with
the PGIA gain set at 2x or higher as the instrumen-
1 M
OSC1
OSC2
20 pF
+
-
V
TH
MCLK
~
~ 60 A
NOTE: 20 pF capacitors are on
chip and should not be added
externally.
Figure 20. On-chip Oscillator Model
相關PDF資料
PDF描述
AD9648-125EBZ EVAL BOARD AD9648-125
CDB5463U-Z EVAL BOARD USB FOR CS5463
AD9633-125EBZ BOARD EVAL FOR AD9633
PM0805-68NK-RC INDUCTOR CHIP 68NH 10% SMD
MAX1379EVKIT+ EVAL KIT FOR MAX1379
相關代理商/技術參數
參數描述
CDB5534U-Z 功能描述:EVAL BD 24-BIT ADCS W/ULTRALN PG 制造商:cirrus logic inc. 系列:- 零件狀態:在售 A/D 轉換器數:1 位數:24 采樣率(每秒):3.84k 數據接口:串行 輸入范圍:±2.5 V 不同條件下的功率(典型值):35mW @ 3.84kSPS 使用的 IC/零件:CS5534 所含物品:板,電纜 標準包裝:1
CDB5540 制造商:Cirrus Logic 功能描述:EVAL BOARD FOR CS5540 - Bulk
CDB5541 制造商:Cirrus Logic 功能描述:EVAL BOARD FOR 5540 & 5541 N/A - Bulk 制造商:Cirrus Logic 功能描述:Tools Development kit For Use
CDB5550 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Evaluation Board and Software
CDB5560 功能描述:數據轉換 IC 開發工具 Eval Bd 50kSps 24Bit Mux ADC RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V