參數資料
型號： ADS1191IPBSR
廠商： Texas Instruments
文件頁數： 44/67頁
文件大?。?/td> 0K
描述： IC AFE 16BIT 8KSPS 1CH 32TQFP
標準包裝： 1,000
位數： 16
通道數： 1
電壓 - 電源，模擬： 2.7 V ~ 5.25 V
電壓 - 電源，數字： 1.7 V ~ 3.6 V
封裝/外殼： 32-TQFP
供應商設備封裝： 32-TQFP（5x5）
包裝： 帶卷 (TR)
a)ExternalPull-Up/Pull-DownResistors
b)InputCurrentSource
PGA
10MW
AVDD
INP
INN
Device
PGA
AVDD
INP
INN
Device
SBAS566A – DECEMBER 2011 – REVISED SEPTEMBER 2012
DC Lead-Off
In this method, the lead-off excitation is with a dc signal. The dc excitation signal can be chosen from either an
external pull-up/pull-down resistor or a current source/sink, as shown in Figure 45. One side of the channel is
pulled to supply and the other side is pulled to ground. The internal current source and current sink can be
swapped by setting thebits in the LOFF_FLIP register. In case of current source/sink, the magnitude of the
current can be set by using the ILEAD_OFF[1:0] bits in the LOFF register. The current source/sink gives larger
input impedance compared to the 10-M
pull-up/pull-down resistor.
Figure 45. DC Lead-Off Excitation Options
Sensing of the response can be done either by looking at the digital output code from the device or by monitoring
the input voltages with an on-chip comparator. If either of the electrodes is off, the pull-up resistors and/or the
pull-down resistors saturate the channel. By looking at the output code it can be determined that either the P-side
or the N-side is off. To pinpoint which one is off, the comparators must be used. The input voltage is also
monitored using a comparator and a 4-bit digital-to-analog converter (DAC) whose levels are set by the
COMP_TH[2:0] bits in the LOFF register. The output of the comparators are stored in the LOFF_STAT register.
These two registers are available as a part of the output data stream. (See the Data Output Protocol (DOUT)
subsection of the SPI Interface section.) If dc lead-off is not used, the lead-off comparators can be powered
down by setting the PD_LOFF_COMP bit in the CONFIG2 register.
An example procedure to turn on dc lead-off is given in the Lead-Off subsection of the Quick-Start Guide section.
AC Lead-Off
In this method, an out-of-band ac signal is used for excitation. The ac signal is generated by alternatively
providing an internal current source and current sink at the input with a fixed frequency. The excitation frequency
is a function of the output data rate and is fDR/4. This out-of-band excitation signal is passed through the channel
and measured at the output.
Sensing of the ac signal is done by passing the signal through the channel to digitize it and measure at the
output. The ac excitation signals are introduced at a frequency that is above the band of interest, generating an
out-of-band differential signal that can be filtered out separately and processed. By measuring the magnitude of
the excitation signal at the output spectrum, the lead-off status can be calculated. Therefore, the ac lead-off
detection can be accomplished simultaneously with the ECG signal acquisition.
Copyright 2011–2012, Texas Instruments Incorporated
49
Product Folder Links: ADS1191 ADS1192
相關PDF資料
PDF描述
V375C2M50BF CONVERTER MOD DC/DC 2V 50W
MAX9015AEKA+T IC COMPARATOR SGL SOT23-8
V375C2M50BL2 CONVERTER MOD DC/DC 2V 50W
V375C2M50BL CONVERTER MOD DC/DC 2V 50W
MCP3901A0T-E/ML IC AFE 24BIT 64KSPS 2CH 20QFN
相關代理商/技術參數
參數描述
ADS1191IRSMR 制造商:Texas Instruments 功能描述:AFE General Purpose 1ADC 24-Bit 1.8V/3V 32-Pin VQFN EP T/R 制造商:Texas Instruments 功能描述:IC AFE 16BIT 8KSPS 1CH 32VQFN 制造商:Texas Instruments 功能描述:Low Pwr Int AFE for ECG App
ADS1191IRSMT 功能描述:模數轉換器 - ADC Cmplt Lw Pwr Intgrtd AFE for ECG apps RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
ADS1192 制造商:TI 制造商全稱:Texas Instruments 功能描述:Low-Power, 2-Channel, 16-Bit Analog Front-End for Biopotential Measurements
ADS1192ECG-FE 功能描述:數據轉換 IC 開發工具 ADS1192 Demo Kit RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V
ADS1192IPBS 功能描述:模數轉換器 - ADC Low Pwr Integ AFE RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*