- 您現在的位置：買賣IC網 > PDF目錄379645 > ADM7008 (Electronic Theatre Controls, Inc.) Octal Ethernet 10/100M PHY PDF資料下載
參數資料
| 型號： | ADM7008 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Octal Ethernet 10/100M PHY |
| 中文描述： | 八路個10/100M以太網物理層 |
| 文件頁數： | 51/92頁 |
| 文件大?。?/td> | 981K |
| 代理商： | ADM7008 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
ADM7008
Function Description
Figure 3-20 10M SS_SMII Transmit Timing Diagram
3.3 LED Display
Register 19 is used for different mode led display. There are two kind of led display
mechanisms provided by ADM7008: single and dual color led mode, either mode provide
power on LED self test to minimize and ease the system test cost.
3.3.1 Single Color LED
When Single Color LED is programmed (DUALLED is set to low during power on reset),
all ports LED will be Off during power on reset (Output value same as recommend value
on LED pins). After power on reset, all internal parallel LEDs will be On for 2 seconds,
internal parallel LED status will be streamed out through LED_DATA and this signal is
output by ADM7008 at the falling edge of LED_CLK. Before describing the serial LED
output data format, we tend to describe the meaning of internal parallel LEDs.
There are three types of LED supported by ADM7008 internally. The first is LNKACT,
which represents the status of Link and Transmit/Receive Activity; the second is LDSPD,
which indicates the speed status and the last is DUPCOL, which shows pure duplex status
in full duplex and duplex/collision combined status in half duplex. All these three LED
can be controlled by Register 19 to change display contents.
After LED self test, Table 3-4, 3-5 and 3-6 show the On/Off polarity according to
different recommended value setting for LDSPD, DUPCOL and LNKACT. When the
recommend value is high, ADM7008 will drive LED LOW; ADM7008 will drive the
LED HIGH when the recommend value is low, instead.
SPEED
10M
100M
LINK FAIL
LDSPD
0
1
1
Table 3-4 Speed LED Display
DUPLEX
DUPCOL
ADMtek Inc.
3-21
TXCLK_SSMII
TXD_P
SYNC_TX
TXD7_
0
TXER_
1
TXEN_1
TXD0_
1
TXD1_
1
TXD2_
1
TXD3_
1
TXD4_
1
TXD6_
1
TXD7_
1
TXD5_
1
TXER_
1
TXEN_1
TXD0_
1
TXD1_
1
TXD2_
1
TXD3_
1
TXD4_
1
TXD5_
1
TXD6_
1
TXD7_
1
TXER_
2
TXEN_2
TXD0_
2
Data Repeated 10 Times (Use 10 SYNC_RX for 1 Byte Data)
相關PDF資料 |
PDF描述 |
|---|---|
| ADM9511 | LAN/Modem Controller with Embedded Fast Ethernet PHY |
| ADS-238Q | 12-Bit, 20MHz, Low Power Sampling A/D Converters |
| ADS-917GC | 14-Bit, 1MHz, Low-Power Sampling A/D Converters |
| ADS-927GC | 14-Bit, 1MHz, Low-Power Sampling A/D Converters |
| ADS-927GM | 14-Bit, 1MHz, Low-Power Sampling A/D Converters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADM7008A3T1 | 功能描述:IC SWITCH CTRLR 10/100 128PQFP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| ADM7008A3T1NP | 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY |
| ADM7008XA3T1 | 功能描述:IC SWITCH CTRLR 10/100 128PQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| adm7008x-a3-t-1 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Infineon Technologies AG 功能描述: |
| ADM7008XA3T1XP | 制造商:Infineon Technologies AG 功能描述:GREEN, SWITCH / PHY |
發布緊急采購，3分鐘左右您將得到回復。