- 您現在的位置：買賣IC網 > PDF目錄358629 > 35007B (Microchip Technology Inc.) 18-pin Enhanced FLASH/EEPROM 8-bit Microcontroller PDF資料下載
參數資料
| 型號： | 35007B |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | 18-pin Enhanced FLASH/EEPROM 8-bit Microcontroller |
| 中文描述： | 18針/ EEPROM的8位微控制器的閃存 |
| 文件頁數： | 19/88頁 |
| 文件大?。?/td> | 1495K |
| 代理商： | 35007B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁
2001 Microchip Technology Inc.
DS35007B-page 17
PIC16F84A
4.2
PORTB and TRISB Registers
PORTB is an 8-bit wide, bi-directional port. The corre-
sponding data direction register is TRISB. Setting a
TRISB bit (= 1) will make the corresponding PORTB pin
an input (i.e., put the corresponding output driver in a
Hi-Impedance mode). Clearing a TRISB bit (= 0) will
make the corresponding PORTB pin an output (i.e., put
the contents of the output latch on the selected pin).
EXAMPLE 4-2:
INITIALIZING PORTB
Each of the PORTB pins has a weak internal pull-up. A
single control bit can turn on all the pull-ups. This is per-
formed by clearing bit RBPU (OPTION<7>). The weak
pull-up is automatically turned off when the port pin is
configured as an output. The pull-ups are disabled on a
Power-on Reset.
Four of PORTB’s pins, RB7:RB4, have an interrupt-on-
change feature. Only pins configured as inputs can
cause this interrupt to occur (i.e., any RB7:RB4 pin
configured as an output is excluded from the interrupt-
on-change comparison). The input pins (of RB7:RB4)
are compared with the old value latched on the last
read of PORTB. The “mismatch” outputs of RB7:RB4
are OR’ed together to generate the RB Port Change
Interrupt with flag bit RBIF (INTCON<0>).
This interrupt can wake the device from SLEEP. The
user, in the Interrupt Service Routine, can clear the
interrupt in the following manner:
a)
Any read or write of PORTB. This will end the
mismatch condition.
b)
Clear flag bit RBIF.
A mismatch condition will continue to set flag bit RBIF.
Reading PORTB will end the mismatch condition and
allow flag bit RBIF to be cleared.
The interrupt-on-change feature is recommended for
wake-up on key depression operation and operations
where PORTB is only used for the interrupt-on-change
feature. Polling of PORTB is not recommended while
using the interrupt-on-change feature.
FIGURE 4-3:
BLOCK DIAGRAM OF
PINS RB7:RB4
FIGURE 4-4:
BLOCK DIAGRAM OF
PINS RB3:RB0
BCF
CLRF
STATUS, RP0 ;
PORTB
; Initialize PORTB by
; clearing output
; data latches
BSF
MOVLW
STATUS, RP0 ; Select Bank 1
0xCF
; Value used to
; initialize data
; direction
TRISB
; Set RB<3:0> as inputs
; RB<5:4> as outputs
; RB<7:6> as inputs
MOVWF
RBPU
(1)
Data Latch
D
From other
RB7:RB4 pins
P
V
DD
Q
CK
Q
D
CK
Q
D
EN
Q
D
EN
Data Bus
WR Port
WR TRIS
Set RBIF
TRIS Latch
RD TRIS
RD Port
Weak
Pull-up
RD Port
Latch
TTL
Input
Buffer
Note 1:
TRISB = ’1’ enables weak pull-up
(if RBPU = ’0’ in the OPTION_REG register).
I/O pins have diode protection to V
DD
and V
SS
.
2:
I/O pin
(2)
RBPU
(1)
I/O pin
(2)
Data Latch
D
P
V
DD
Q
CK
Q
D
CK
Q
D
EN
Data Bus
WR Port
WR TRIS
RD TRIS
RD Port
Weak
Pull-up
RD Port
RB0/INT
TTL
Input
Buffer
Schmitt Trigger
Buffer
TRIS Latch
Note 1:
TRISB = ’1’ enables weak pull-up
(if RBPU = ’0’ in the OPTION_REG register).
I/O pins have diode protection to V
DD
and V
SS
.
2:
相關PDF資料 |
PDF描述 |
|---|---|
| 350PJT | 1200A ITGQ Gate Turn-Off Hockey Puk SCRs |
| 351-90-116-00-017 | PCB connectors 2.54 mm Single row / double row Solder tail |
| 351-90-116-00-016 | HOOD DB50 PLASTIC 10 PACK |
| 351-90-116-00-005 | DB-50 PLASTIC HOOD |
| 351-90-116-00-004 | CRIMP SHELLS DB50 FEMALE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 35-007-BU | 制造商:GC Electronics 功能描述:Switch Toggle ON OFF (ON) SPDT Bat Toggle Solder 5A 250VAC 28VDC Panel Mount with Threads Bulk |
| 35008 | 功能描述:WRENCH OPEN END METRIC 10X11MM RoHS:否 類別:工具 >> 鉗子、扳手 系列:350 標準包裝:1 系列:- 尖端 - 類型:針頭，直形 工具類型:鉗子 特點:人機工程型手柄，ESD 安全，鋸齒狀 長度:5.75"（146.05mm） 重量:0.23 磅（104.33g） |
| 35-008 | 制造商:GC Electronics 功能描述:SPDT(ON)-OFF-(ON)MIN BAT TO 制造商:Ideal Industries Inc 功能描述:TENITE HANDLES 8 IN 制造商:GC Electronics 功能描述:Switch Toggle (ON) OFF (ON) SPDT Bat Toggle Solder 5A 250VAC 28VDC Panel Mount with Threads 制造商:Ideal Industries Inc 功能描述:Switch Toggle (ON) OFF (ON) SPDT Bat Toggle |
| 35008 BK199 | 制造商:Alpha Wire Company 功能描述:35008 BLACK 1000 = 1000 FT |
| 350080-1 | 功能描述:端子 RING 18-14 10 .025TP RoHS:否 制造商:AVX 產品:Junction Box - Wire to Wire 系列:9826 線規:26-18 接線柱/接頭大小: 絕緣: 顏色:Red 型式:Female 觸點電鍍:Tin over Nickel 觸點材料:Beryllium Copper, Phosphor Bronze 端接類型:Crimp |
發布緊急采購，3分鐘左右您將得到回復。