- 您現在的位置：買賣IC網 > PDF目錄16527 > XR20V2172L64-0A-EB (Exar Corporation)EVAL BOARD FOR XR20V2170 64QFN PDF資料下載
參數資料
| 型號： | XR20V2172L64-0A-EB |
| 廠商： | Exar Corporation |
| 文件頁數： | 24/51頁 |
| 文件大?。?/td> | 0K |
| 描述： | EVAL BOARD FOR XR20V2170 64QFN |
| 標準包裝： | 1 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁
XR20V2172
30
TWO CHANNEL I2C/SPI UART WITH 64-BYTE FIFO AND RS232 TRANSCEIVER
REV. 1.0.2
MCR[2]: OP1# / TCR and TLR Enable
OP1# is not available as an output pin on the V2172. But it is available for use during Internal Loopback Mode
(MCR[4] = 1). In the Internal Loopback Mode, this bit is used to write the state of the modem RI# interface
signal.
This bit is also used to select between the MSR and TCR registers at address offset 0x6 and the SPR and TLR
registers at address offset 0x7. Table 12 and Table 13 below shows how these registers are accessed.
TABLE 12: REGISTER AT ADDRESS OFFSET 0X6
EFR[4] MCR[2] Register at Address Offset 0x6
0
X
Modem Status Register (MSR)
1
0
Modem Status Register (MSR)
1
Trigger Control Register (TCR)
TABLE 13: REGISTER AT ADDRESS OFFSET 0X7
EFR[4] MCR[2] Register at Address Offset 0x7
0
X
Scratchpad Register (SPR)
1
0
Scratchpad Register (SPR)
1
Trigger Level Register (TLR)
MCR[3]: OP2# Output
OP2# is not available as an output on the V2172 but can be controlled in internal loopback mode.
Logic 0 = OP2# output set HIGH(default).
Logic 1 = OP2# output set LOW.
MCR[4]: Internal Loopback Enable
Logic 0 = Disable loopback mode (default).
Logic 1 = Enable local loopback mode, see loopback section and Figure 14.
MCR[5]: Xon-Any Enable (requires EFR bit-4=1 to write to this bit)
Logic 0 = Disable Xon-Any function (default).
Logic 1 = Enable Xon-Any function. In this mode, any RX character received will resume transmit operation.
The RX character will be loaded into the RX FIFO, unless the RX character is an Xon or Xoff character and
the V2172 is programmed to use the Xon/Xoff flow control.
MCR[6]: Infrared Encoder/Decoder Enable
Logic 0 = Enable the standard modem receive and transmit input/output interface (default).
Logic 1 = Enable infrared IrDA receive and transmit inputs/outputs. The TX/RX output/input are routed to the
infrared encoder/decoder. The data input and output levels conform to the IrDA infrared interface requirement.
While in this mode, the infrared TX output will be idling LOW. SEE”INFRARED MODE (UART CHANNEL B
相關PDF資料 |
PDF描述 |
|---|---|
| UPJ1C331MPD6TD | CAP ALUM 330UF 16V 20% RADIAL |
| UUR0J471MNL1GS | CAP ALUM 470UF 6.3V 20% SMD |
| XR20V2170L40-0B-EB | EVAL BOARD FOR XR20V2170 40QFN |
| UPJ1K390MPD6TD | CAP ALUM 39UF 80V 20% RADIAL |
| EEU-EB2E330 | CAP ALUM 33UF 250V 20% RADIAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR20V2172L64-0B-EB | 功能描述:UART 接口集成電路 Supports V2172 64pin QFN, SPI Interface RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR-210 | 制造商:EXAR 制造商全稱:EXAR 功能描述:FSK MODULATOR / DEMODULATOR |
| XR-2100CJ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MODEM |
| XR-2100CP | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:MODEM |
| XR-2103 | 制造商:EXAR 制造商全稱:EXAR 功能描述:FSK Modem Filter |
發布緊急采購，3分鐘左右您將得到回復。