- 您現在的位置：買賣IC網 > PDF目錄376440 > X40239 (Intersil Corporation) Triple Voltage Monitors, POR, 2 kbit EEPROM MEMORY, and Single/Dual DCP PDF資料下載
參數資料
| 型號： | X40239 |
| 廠商： | Intersil Corporation |
| 英文描述： | Triple Voltage Monitors, POR, 2 kbit EEPROM MEMORY, and Single/Dual DCP |
| 中文描述： | 三電壓監測器，葡萄牙，2千比特EEPROM存儲器，以及單/雙副處長 |
| 文件頁數： | 14/36頁 |
| 文件大?。?/td> | 541K |
| 代理商： | X40239 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
14
FN8115.0
April 11, 2005
DCP Read Operation
A read of DCPx (x = 0,1,2) can be performed using the
three byte random read command sequence shown in
Figure 10.
The master issues the START condition and the Slave
Address Byte 10101110 which specifies that a
“dummy” write” is to be conducted. This “dummy” write
operation sets which DCP is to be read (in the preced-
ing Read operation). An ACKNOWLEDGE is returned
by the X4023x after the Slave Address if received cor-
rectly. Next, an Instruction Byte is issued on SDA. Bits
P1-P0 of the Instruction Byte determine which DCP
“wiper position” is to be read. In this case, the state of
the WT bit is “don’t care”. If the Instruction Byte format
is valid, then another ACKNOWLEDGE is returned by
the X4023x.
Following this ACKNOWLEDGE, the master immedi-
ately issues another START condition and a valid
Slave address byte with the R/W bit set to 1. Then the
X4023x issues an ACKNOWLEDGE followed by Data
Byte, and finally, the master issues a STOP condition.
The Data Byte read in this operation, corresponds to
the “wiper position” (value of the WCR) of the DCP
pointed to by bits P1 and P0.
It should be noted that when reading out the data byte
for DCP0 (64 Tap), the upper two most significant bits
are “unknown” bits. For DCP1 (100 Tap), the upper
most significant bit is an “unknown”. For DCP2 (256
Tap) however, all bits of the data byte are relevant
(See Figure 10).
2 kbit EEPROM ARRAY
Operations on the 2 kbit EEPROM Array, consist of
either 1, 2 or 3 byte command sequences. All opera-
tions on the EEPROM must begin with the Device
Type Identifier of the Slave Address set to 1010000. A
Read or Write to the EEPROM is selected by setting
the LSB of the Slave Address to the appropriate value
R/W (Read = “1”, Write = ”0”).
In some cases when performing a Read or Write to
the EEPROM, an Address Byte may also need to be
specified. This Address Byte can contain the values
00h to FFh.
Slave
Address
Instruction
Byte
A
C
K
A
C
K
S
t
a
r
t
S
t
o
p
Slave
Address
Data Byte
A
C
K
S
t
a
r
t
SDA Bus
Signals from
the Slave
Signals from
the Master
Figure 10. DCP Read Sequence
“Dummy” write
READ Operation
1 0 1
1 1 1 0
0
0 0
0 0
0
W
T
P
1
P
0
1 0 1
1 1 1 1
0
WRITE Operation
-
- -
MSB
“-” = DON’T CARE
LSB
DCPx
x = 0
x = 1
x = 2
S
t
a
r
t
S
t
o
p
Slave
Address
Address
Byte
Data
Byte
A
C
K
A
C
K
A
C
K
SDA Bus
Signals from
the Slave
Signals from
the Master
Figure 11. EEPROM Byte Write Sequence
Internal
Device
Address
1 0 1 0 0 0 0 0
WRITE Operation
X40231, X40233, X40235, X40237, X40239
相關PDF資料 |
PDF描述 |
|---|---|
| X40420V14IZ-B | Dual Voltage Monitor with Intergrated CPU Supervisor |
| X40420S14IZ-A | Dual Voltage Monitor with Intergrated CPU Supervisor |
| X40420S14IZ-B | Dual Voltage Monitor with Intergrated CPU Supervisor |
| X40420S14Z-A | Dual Voltage Monitor with Intergrated CPU Supervisor |
| X40420S14Z-B | Dual Voltage Monitor with Intergrated CPU Supervisor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X40239S16I-A | 功能描述:IC VOLTAGE MON TRPL EE 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X40239S16I-AT1 | 功能描述:IC VOLTAGE MON TRPL EE 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X40239S16I-B | 功能描述:IC VOLTAGE MON TRPL EE 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X40239S16I-BT1 | 功能描述:IC VOLTAGE MON TRPL EE 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X-4028-P-C32-R | 功能描述:音頻指示器及警報器 2800Hz 105dBA 32Vdc RoHS:否 制造商:PUI Audio 產品:Indicators 聲壓級:85 dB 音調:Continuous 頻率:2300 Hz +/- 300 Hz 電壓額定值:5 VDC 電流額定值:30 mA 端接類型: 直徑:12 mm 安裝:Through Hole |
發布緊急采購，3分鐘左右您將得到回復。