- 您現在的位置：買賣IC網 > PDF目錄385814 > SAA7388GP (NXP SEMICONDUCTORS) Error correction and host interface IC for CD-ROM ELM PDF資料下載
參數資料
| 型號： | SAA7388GP |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Error correction and host interface IC for CD-ROM ELM |
| 中文描述： | 8-BIT, 50.4 MHz, MICROCONTROLLER, PQFP80 |
| 文件頁數： | 15/60頁 |
| 文件大小： | 226K |
| 代理商： | SAA7388GP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
1996 Apr 26
15
Philips Semiconductors
Preliminary specification
Error correction and host interface IC for
CD-ROM (ELM)
SAA7388
Bit 7 of the DACHH register specifies which memory is
accessed. If the bit is clear then the address refers to the
external memory, if the bit is set then the address refers to
the 4 kbyte internal memory. The internal memory should
not be accessed during error correction.
This register should be written to before each data transfer
because its value will be undefined at the end of the
previous transfer.
7.7.7
PTL, PTH
AND
PTHH
This register holds a 21-bit pointer to the external buffer
memory address of the head of the current data block after
correction.
The SAA7388 defines the minute byte in the header to be
at the head of the block, and the 12 sync bytes at the tail
of the block. Each block contained in the buffer is taken to
be 2352 bytes.
The controller can transfer the decoded block back to the
host by copying the address of this register to the DACL,
DACH and DACHH pointers after a decoder interrupt.
When the WRRQ bit in the CTRL0 register is set to logic 1,
this pointer is updated at the sync signal of every
2352 byte clocks.
7.7.8
WAL, WAH
AND
WAHH
These registers contain a 21-bit address of where raw data
from the drive is written to the external buffer memory. The
pointer is automatically incremented during data transfer.
The pointer should only be read while drive data writes to
the buffer are disabled. If WAHH is written to while drive
data write is enabled, then the new WA value will be used
for the first byte of the next sector. The new pointer value
is temporarily stored in the PT register. This cannot be
read after WA has been written to.
7.7.9
DTRG
Writing to this register starts a data transfer. The data
written is discarded.
7.7.10
DTACK
Writing to this register clears the DTEI interrupt. The data
written is discarded.
7.7.11
HEAD0, HEAD1, HEAD2
AND
HEAD3
These registers are used to hold the header and the
sub-header data of the current block.
To read the header data set, the SHDREN bit in the
CTRL1 register is set to logic 0; to read the sub-header
data, SHDREN is set to logic 1.
If sub-header is selected, the registers will normally hold
data from bytes 20 to 23. However, if the error flag for one
of these bytes is set, then the byte is taken from the first
sub-header field. (bytes 16 to 19.)
The error flags for header and sub-header can be read
from the STAT1 register. No error correction is performed
on header or sub-header.
Header and sub-header registers are valid directly after
decoder interrupt, and as long as the VALST bit in the
STAT3 register is LOW. In all write modes they contain
information on the block whose header is pointed to by
PTL, PTH and PTHH.
Table 5
HEAD registers
SHDREN
REGISTER
CONTENTS
0
0
0
0
1
1
1
1
HEAD0
HEAD1
HEAD2
HEAD3
HEAD0
HEAD1
HEAD2
HEAD3
MINUTES (byte 12)
SECONDS (byte 13)
FRAMES (byte 14)
MODE (byte 15)
FILE NUMBER (byte 16 or 20)
CHANNEL NUMBER (byte 17 or 21)
SUBMODE NUMBER (byte 18 or 22)
CODING INFORMATION (byte 19 or 23)
相關PDF資料 |
PDF描述 |
|---|---|
| SAA7388 | Error correction and host interface IC for CD-ROM ELM |
| SAA7392HL | Channel encoder/decoder CDR60 |
| SAA7392 | Channel encoder/decoder CDR60(通道編碼器/譯碼器) |
| SAA7705H | Car radio Digital Signal Processor（DSP）(車載電臺數字信號處理器) |
| SAA7712H | Sound effects DSP(聲音效應數字信號處理器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAA7390 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:High performance Compact Disc-Recordable CD-R controller |
| SAA7390GP | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:High performance Compact Disc-Recordable CD-R controller |
| SAA7391 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:ATAPI CD-R block encoder/decoder |
| SAA7391H | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:ATAPI CD-R block encoder/decoder |
| SAA7392 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Channel encoder/decoder CDR60 |
發布緊急采購，3分鐘左右您將得到回復。