- 您現在的位置：買賣IC網 > PDF目錄376329 > RTL8309SB (Electronic Theatre Controls, Inc.) SINGLE-CHIP 9-PORT 10/100MBPS SWITCH CONTROLLER PDF資料下載
參數資料
| 型號： | RTL8309SB |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | SINGLE-CHIP 9-PORT 10/100MBPS SWITCH CONTROLLER |
| 中文描述： | 單芯片9口10/100Mbps開關控制器 |
| 文件頁數： | 83/115頁 |
| 文件大?。?/td> | 866K |
| 代理商： | RTL8309SB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁當前第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
RTL8309SB
Datasheet
Single-chip 9-port 10/100Mbps Switch Controller
68
Track ID: JATR-1076-21 Rev. 1.4
8.1.9.
Auto Crossover Detection
During the link setup phase, the RTL8309SB checks whether it receives active signals on every port in order to determine if a
connection can be established. In cases where the receiver data pin pair is connected to the transmitter data pin pair of the peer
device and vice versa, the RTL8309SB will automatically change its configuration to swap receiver data pins with transmitter
data pins. In other words, the RTL8309SB adapts automatically to a peer device’s configuration. If a port is connected with a
crossover cable to a NIC with an MDI-X interface, the RTL8309SB will reconfigure the port to ensure proper connection. This
effectively replaces the DIP switch commonly used for reconfiguring a port on a hub or switch.
By pulling-up EN_AUTOXOVER, the RTL8309SB identifies the type of connected cable and sets the port to MDI or MDIX.
When switching to MDI mode, the RTL8309SB uses TXOP/N as transmit pairs; when switching to MDIX mode, the
RTL8309SB uses RXIP/N as transmit pairs. This function is port-based. Pulling-down EN_AUTOXOVER disables this
function and the RTL8309SB operates in MDI mode, in which TXOP/N represents transmit pairs and RXIP/N represents
receive pairs.
IEEE 802.3 compliant forced mode 100M ports with auto crossover have link issues with NWay (Auto-Negotiation) ports. It is
recommended to
not
use auto crossover for forced 100M.
8.2.
Switch Core Functional Overview
8.2.1.
Address Search, Learning, and Aging
When a packet is received, the RTL8309SB uses the least 10 bits of the destination MAC address to index the 1024-entry look-
up table, and at the same time compares the destination MAC address with the contents of the 16-entry CAM. If the indexed
entry is valid or the CAM comparison is matched, the received packet will be forwarded to the corresponding destination port.
Otherwise, the RTL8309SB will broadcast the packet. This is the ‘Address Search’.
The RTL8309SB then extracts the least 10 bits of the source MAC address to index the 1024-entry look-up table. If the entry is
not already in the table it will record the source MAC address and add switching information. If this is an occupied entry, it
will update the entry with new information. This is called ‘Learning’. If the indexed location has been occupied by a different
MAC address (hash collision), the new source MAC address will be recorded into the 16-entry CAM. The 16-entry CAM
reduces address hash collisions and improves switching performance.
Address aging is used to keep the contents of the address table correct in a dynamic network topology. The look-up engine will
update the time stamp information of an entry whenever the corresponding source MAC address appears. An entry will be
invalid (aged out) if it’s time stamp information is not refreshed by the address learning process during the aging time period.
The aging time of the RTL8309SB is around 300 seconds.
相關PDF資料 |
PDF描述 |
|---|---|
| RTS0072 | VOICE CHANGER |
| RTS0072B | VOICE CHANGER |
| RU4D | SDR Cable Assembly; Connector Type A:micro D Ribbon Plug; Connector Type B:micro D Ribbon Plug; Cable Length:2m; No. of Contacts:26; Pitch Spacing:0.8mm RoHS Compliant: Yes |
| RU4D | Damper Diodes (For Display) |
| RU4DS | SDR Cable Assembly; Connector Type A:micro D Ribbon Plug; Connector Type B:micro D Ribbon Plug; Cable Length:5m; No. of Contacts:26; Pitch Spacing:0.8mm RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RTL8309SB-LF | 制造商:Realtek Semiconductor 功能描述:RTL8309 Series 9 Port 10/100 Mbps Ethernet Switch Controller - PQFP-128 制造商:Realtek 功能描述:RTL8309 Series 9 Port 10/100 Mbps Ethernet Switch Controller - PQFP-128 |
| RTL8316 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Specifications |
| RTL8363S-GR | 制造商:Realtek Semiconductor 功能描述: |
| RTL8801 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Specifications |
| RTL8812AE | 制造商:Realtek 功能描述:2.4G/5G 2T2R a.b.g.n.ac wireless mini PCIE card |
發布緊急采購，3分鐘左右您將得到回復。