參數資料
型號： ORT8850H-1BM680C
廠商： Lattice Semiconductor Corporation
文件頁數： 20/105頁
文件大?。?/td> 0K
描述： IC FPSC TRANSCEIVER 8CH 680-BGA
產品變化通告： Product Discontinuation 01/Aug/2011
標準包裝： 24
系列： *
Lattice Semiconductor
ORCA ORT8850 Data Sheet
21
Figure 8. Data Paths for Near-End and Far-End Loopbacks (Single Channel)
Near end loopback is a loopback of data from the FPGA transmit into the core and back out of the core to the
FPGA. This loopback mode is good for simulation since two ORT8850 devices do not have to be included in the
simulation test bench. It is also ideal for system debugging when only working with a single card. There are two
depths to the near end loopback, CDR and LVDS. The CDR near end loopback performs the loopback inside the
CDR itself. LVDS near end loopback does the loopback just before data is sent out of the LVDS transmit pins. In all
near end loopbacks the transmit data is still sent out of the LVDS pins.
Far end loopback is a loopback of the high speed data on the backplane side. Serial data is transmitted into the
device from the backplane and then looped back to the backplane side. This loopback is good for backplane con-
nectivity tests and backplane integrity type tests. The actual loopback of data is performed inside the Pointer Mover
Block. In this mode the SYS_FP signal from the FPGA logic to the Embedded Core must provide an 8KHz frame
pulse. It should also be noted that during the bypass of the Pointer Mover Block, the Far End Loopback cannot be
performed inside the Embedded ASIC Block. In that case it can be coded to be performed inside the FPGA.
Protection Switching - Overview
The ORT8850 supports 1:1 redundancy within both the transmit and receive data paths. Work/protect selection is
controlled by a control register bit which can be set using the system bus or the external MicroProcessor Interface.
Protection switching allows a pair of SERDES channels to act as main and protect data links. On the transmit side,
a simple broadcast mode is used and the same data is transmitted across both work and protect interfaces.
All data channels have receive work and protect switching capability. There are two types of receive protection
switching supported. The switching can be performed at the parallel interface to the FPGA or at the interface to the
LVDS buffers. Parallel protection switching (Figure 9) takes place just before the FPGA interface ports and after the
alignment FIFO. The alignment FIFO must be used for this type of protection switching. In this mode SERDES
channels AA and AB are used as main and protect. When selected for main channel AA is used to provide data on
FPGA interface ports AA. When selected for protect channel AB is used to provide data on FPGA interface ports
Parallel
Loopback
Connection
Test Equipment or
Remote System
Card
(a) “ Near End ” Loopback
Embedded Core
2
FPGA Logic
m
n
Data
Checking
Data
Generation
Non-Functional
Active
(to Eye Diagram
Measurement or
Remote System
Card)
Receive
Transmit
ORT8850 Device Under Test (DUT)
LVDS
Buffer
LVDS
Buffer
High Speed
Serial Loopback
Connection
32
Test Equipment
or Logic on Local
System Card
TXDxx_[W:P]_[ P:N]
RXDxx_[W:P]_[P:N]
(b) “ Far End ” Loopback
SERDES
And
LVDS
Buffers
Embedded Core
FPGA Logic
m
n
Non-Functional
Receive
Transmit
ORT8850 Device Under Test (DUT)
2
Data
Checking
Data
Generation
RX SONET
TX SONET
TXDxx_[W:P]_[ P:N]
Note: xx = AA, ..., BD
RXDxx_[W:P]_[P:N]
Active
(to Logic on
Local System
Card)
相關PDF資料
PDF描述
ORT82G5-2F680I IC FPSC TRANSCEIVER 8CH 680-BGA
ORT82G5-2F680C IC FPSC TRANSCEIVER 8CH 680-BGA
D38999/26JC8PN CONN PLUG 8POS STRAIGHT W/PINS
MS27467T25F61SC CONN PLUG 61POS STRAIGHT W/SCKT
31-320-RFX BNC PLUG, CRIMP RG-58
相關代理商/技術參數
參數描述
ORT8850H-1BM680I 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT8850H-1BMN680C 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT8850H-1BMN680I 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT8850H-2BM680C 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
ORT8850H-2BMN680C 功能描述:FPGA - 現場可編程門陣列 16192 LUT 297 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*