- 您現在的位置：買賣IC網 > PDF目錄189003 > NAND08GR3B2AN1F (STMICROELECTRONICS) 1G X 8 FLASH 1.8V PROM, 35 ns, PDSO48 PDF資料下載
參數資料
| 型號： | NAND08GR3B2AN1F |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | PROM |
| 英文描述： | 1G X 8 FLASH 1.8V PROM, 35 ns, PDSO48 |
| 封裝： | 12 X 20 MM, ROHS COMPLIANT, PLASTIC, TSOP-48 |
| 文件頁數： | 11/57頁 |
| 文件大?。?/td> | 887K |
| 代理商： | NAND08GR3B2AN1F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
19/57
NAND01G-B, NAND02G-B, NAND04G-B, NAND08G-B
DEVICE OPERATIONS
The following section gives the details of the de-
vice operations.
Read Memory Array
At Power-Up the device defaults to Read mode.
To enter Read mode from another mode the Read
command
must
be
issued,
see
10., Commands. Once a Read command is is-
sued, subsequent consecutive Read commands
only require the confirm command code (30h).
Once a Read command is issued two types of op-
erations are available: Random Read and Page
Read.
Random Read. Each time the Read command is
issued the first read is Random Read.
Page Read. After the first Random Read access,
the page data (2112 Bytes or 1056 Words) is
transferred to the Page Buffer in a time of tWHBH
(refer to Table 25. for value). Once the transfer is
complete the Ready/Busy signal goes High. The
data can then be read out sequentially (from se-
lected column address to last column address) by
pulsing the Read Enable signal.
The device can output random data in a page, in-
stead of the consecutive sequential data, by issu-
ing a Random Data Output command.
The Random Data Output command can be used
to skip some data during a sequential data output.
The sequential operation can be resumed by
changing the column address of the next data to
be output, to the address which follows the Ran-
dom Data Output command.
The Random Data Output command can be is-
sued as many times as required within a page.
The Random Data Output command is not accept-
ed during Cache Read operations.
Figure 8. Read Operations
Note: 1. Highest address depends on device density.
CL
E
W
AL
R
I/O
RB
00h
ai08657b
Busy
Command
Code
Data Output (sequentially)
Address Input
tBLBH1
30h
Command
Code
相關PDF資料 |
PDF描述 |
|---|---|
| NAND04GW4B2AN1E | 256M X 16 FLASH 3V PROM, 35 ns, PDSO48 |
| NAND02GW4B2AN1T | 128M X 16 FLASH 3V PROM, 35 ns, PDSO48 |
| NAND04GR4B2CN1F | 256M X 16 FLASH 1.8V PROM, 35 ns, PDSO48 |
| NAND08GW3B2CZL1F | 1G X 8 FLASH 3V PROM, 25000 ns, PBGA52 |
| NAND128W3A2BV6E | 16M X 8 FLASH 3V PROM, 12000 ns, PDSO48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NAND08GR3B4CZL6E | 制造商:Micron Technology Inc 功能描述:NAND - Trays |
| NAND08GR3B4CZL6F | 制造商:Micron Technology Inc 功能描述:NAND - Tape and Reel |
| NAND08GW3B2AN6E | 功能描述:閃存 4 GBit 2112 Byte 1056 WP 1.8v/3v RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| NAND08GW3B2AN6F | 功能描述:閃存 4 GB 2112B 1056 Word Pg 1.8V/3V RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| NAND08GW3B2BN6E | 制造商:Micron Technology Inc 功能描述:NAND & S.MEDIA FLASH - Trays |
發布緊急采購，3分鐘左右您將得到回復。