- 您現在的位置：買賣IC網 > PDF目錄383644 > MT9074AL (Mitel Networks Corporation) T1/E1/J1 Single Chip Transceiver PDF資料下載
參數資料
| 型號： | MT9074AL |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | T1/E1/J1 Single Chip Transceiver |
| 中文描述： | T1/E1/J1收發單芯片收發器 |
| 文件頁數： | 6/122頁 |
| 文件大?。?/td> | 372K |
| 代理商： | MT9074AL |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
MT9074
Advance Information
6
61
57
LOS
Loss of signal or synchronization (Output).
When high, and LOS/LOF (page
02H address 13H bit 2) is zero, this signal indicates that the receive portion of the
MT9074 is either not detecting an incoming signal (bit LLOS on page 03H address
18H is one) or is detecting a loss of basic frame alignment condition (bit SYNC on
page 03H address 10H is one). If LOS/LOF=1, a high on this pin indicates a loss of
signal condition.
62
58
IC
Internal Connection.
Tie to Vss (Ground) for normal operation.
59
NC
No Connection.
Leave open for normal operation.
63
60
IC
Internal Connection.
Tie to V
SS
(Ground) for normal operation.
Transmit Data Link Clock (Output).
A gapped clock signal derived from a gated
2.048 Mbit/s clock for transmit data link at 4, 8, 12, 16 or 20 kHz. The transmit data
link data (TxDL) is clocked in on the rising edge of TxDLCLK. TxDLCLK can also
be used to clock DL data out of an external serial controller.
64
61
TxDLCLK
65
62
TxDL
Transmit Data Link (Input).
An input serial stream of transmit data link data at 4,
8, 12, 16 or 20 kbit/s.
66
63
S/FR/C1.5i Sychronous/Freerun Extracted Clock (Input):
If low, and the internal LIU is
enabled, the MT9074 is in free run mode. Pins 45 C4b and 46 F0b are outputs
generating system clocks. Slips will occur in the receive slip buffer as a result of
any deviation between the MT9074's internal PLL (which is free - running) and the
frequency of the incoming line data. If high, and the internal LIU is enabled, the
MT9074 is in Bus or Line Synchronization mode depending on the BS/LS pin. If
the internal LIU is disabled, in digital framer mode, this pin (C1.5i) takes an input
clock 1.544Mhz (T1) / 2.048Mhz (E1) that clocks in the received digital data on
pins RTIP and RRING with its rising edge.
67
64
VDD
Positive Power Supply (Input).
Digital supply (+5V
±
5%).
68
65
VSS
Negative Power Supply (Input).
Digital ground.
Pin Description
Pin #
Name
Description
68 Pin
PLCC
100 Pin
MQFP
Device Overview
The MT9074 in T1 mode operates as an advanced
T1 framer with an on-chip Line Interface Unit (LIU)
that meets or supports the recommendations
including ITU I.431, AT&T PUB43801, TR-62411,
ANSI T1.102, T.403 and T.408.
The MT9074 in E1 mode operates as an advanced
PCM 30 framer with an on-chip Line Interface Unit
(LIU) that meets or supports the latest ITU-T
Recommendations for PCM 30 and ISDN primary
rate including G.703, G.704, G.706, G.775, G.796,
G.732, G.823 and I.431. It also meets or supports
the layer 1 requirements of ETSI ETS 300 011, ETS
300 166, ETS 300 233 and BS6450.
The Line Interface Unit (LIU) of the MT9074
interfaces the digital framer functions to either the
DS1 (T1 mode) or PCM 30 (E1 mode) transformer-
isolated four wire line. The transmit portion of the
MT9074 LIU consists of a digital buffer, a digital-to-
analog converter, and a differential line driver. The
receiver portion of the MT9074 LIU consists of an
input signal peak detector, an optional equalizer, a
smoothing filter, data and clock slicers and a clock
extractor.
System timing may be slaved to the line, operated in
free-run mode or controlled by an external timing
source. In T1 mode the MT9074 contains a PLL
which always generates the transmit timing for the
LIU. In E1 mode the LIU also contains a Jitter
Attenuator (JA), which can be included in either the
transmit or receive path. The MT9074 will attenuate
jitter from 2.5 Hz and roll-off at a rate of 20 dB/
decade. The intrinsic jitter is less than 0.02 UI. The
PLL output (@1.544 MHz for T1 mode and @2.048
MHz for E1 mode) clocks out the transmit line data.
相關PDF資料 |
PDF描述 |
|---|---|
| MT9074AP | T1/E1/J1 Single Chip Transceiver |
| MT9074 | T1/E1/J1 Single Chip Transceiver(T1/E1/J1單片收發器) |
| MT9075B | E1 Single Chip Transceiver |
| MT9075B | E1 Single Chip Transceiver(E1單片收發器) |
| MT9075 | E1 Single Chip Transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT9074AL1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 100MQFP - Trays |
| MT9074AP | 制造商:Microsemi Corporation 功能描述: |
| MT9074AP1 | 制造商:Microsemi Corporation 功能描述:T1/E1/J1 SGLE CHIP XSCR 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX SGL T1/E1 68PLCC 制造商:Microsemi Corporation 功能描述:IC TXRX SGL T1/E1 68PLCC |
| MT9074APR | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1/J1 Single Chip Transceiver |
| MT9074APR1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。