參數資料
型號： MC56F8014VFAE
廠商： 飛思卡爾半導體(中國)有限公司
英文描述： 16-bit Digital Signal Controllers
中文描述： 16位數字信號控制器
文件頁數： 78/124頁
文件大?。?/td> 1878K
代理商： MC56F8014VFAE
56F8014 Technical Data, Rev. 3
78
Freescale Semiconductor
Preliminary
utilization. It is possible to invoke Stop or Wait mode while in Standby mode for even greater levels of
power reduction. A 400kHz clock external clock can optionally be used in Standby mode to produce the
required Standby 200kHz system bus rate. Power-down mode, which selects the ROSC clock source but
shuts it off, fully disables the part and minimizes its power utilization but is only recoverable via reset.
When the PLL is not selected and the system bus is operating at 200kHz or less, the large regulator can be
put into its Standby mode (LRSTDBY) to reduce the power utilization of that regulator.
All peripherals, except the COP/watchdog timer, run at the IPBus clock (peripheral bus) frequency
1
, which
is the same as the main processor frequency in this architecture. The COP timer runs at
MSTR_OSC / 1024. The maximum frequency of operation is SYS_CLK = 32MHz. The only exception is
the TMR and PWM, which can be configured to operate at three times the system bus rate using TCR and
PCR controls, provided the PLL is active and selected.
6.6 Resets
The SIM supports four sources of reset, as shown in
Figure 6-15
. The two asynchronous sources are the
external reset pin and the Power-On Reset (POR). The two synchronous sources are the software reset,
which is generated within the SIM itself by writing the SIM_CTRL register in
Section 6.3.1
, and the COP
reset. The SIM uses these to generate resets for the internal logic. These are outlined in
Table 6-4
. The
first column lists the four primary resets which are calculated. The JTAG circuitry is reset by the Power-On
Reset. Columns two through five indicate which reset sources trigger these reset signals. The last column
provides additional detail.
1. The TMR ans PWM modules can be operated at three times the IPBus clock frequency.
Table 6-4 Primary System Resets
Reset Sources
Reset Signal
POR
External
Software
COP
Comments
EXTENDED_POR
X
Stretched version of POR. Relevant 64
Relaxation Oscillator Clock cycles after
POR deasserts.
CLKGEN_RST
X
X
X
X
Released 32 Relaxation Oscillator Clock
cycles after all reset sources have
released.
PERIP_RST
X
X
X
X
Releases 32 Relaxation Oscillator Clock
cycles after the CLKGEN_RST is
released.
CORE_RST
X
X
X
X
Releases 32 SYS_CLK periods after
PERIP_RST is released.
相關PDF資料
PDF描述
MC56F8155VFG 16-bit Hybrid Controllers
MC56F8323 16-bit Hybrid Controller(16位混合控制器)
MC56F8345 16-bit Hybrid Controller(16位混合控制器)
MC56F8346 16-bit Hybrid Controller(16位混合控制器)
MC56F8366MFV60 16-bit Digital Signal Controllers
相關代理商/技術參數
參數描述
MC56F8023 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
MC56F8023VLC 功能描述:數字信號處理器和控制器 - DSP, DSC 16 BIT DSPHC RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
MC56F8025 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:16-bit Digital Signal Controllers
MC56F8025E 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Digital Signal Controller Product Brief
MC56F8025MLD 功能描述:數字信號處理器和控制器 - DSP, DSC 16 BIT DSPHC RoHS:否 制造商:Microchip Technology 核心:dsPIC 數據總線寬度:16 bit 程序存儲器大小:16 KB 數據 RAM 大小:2 KB 最大時鐘頻率:40 MHz 可編程輸入/輸出端數量:35 定時器數量:3 設備每秒兆指令數:50 MIPs 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TQFP-44 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*